UNT Libraries Government Documents Department - 579 Matching Results

Search Results

prev Results: 25 - 48 next
open access

Application of Balancing Tabs to Ailerons

Description: Analysis was made to determine characteristics required of a balancing-tab system for ailerons in order to reduce aileron stick forces to any desired magnitude. Series of calculations based on section data were made to determine balancing-tab systems of various chord tabs and ailerons that will give, for a particular airplane, zero rate of aileron hinge moment with aileron deflection and yet will produce same maximum rate of roll as a plain unbalanced 15-percent chord aileron of same span. Effe… more
Date: June 1942
Creator: Sears, Richard I.
Item Type: Refine your search to only Report
open access

Beam and torsion tests of aluminum-alloy 615-T tubing

Description: From Summary: "Tests were made to determine the effect of length and the effect of ratios of diameter to wall thickness upon the flexural and torsional moduli of failure of 61S-T aluminum-alloy tubing. The moduli of failure in bending, as determined by tests in which the tubing was loaded on the neutral axis at the one-third points of the span, were found to bear an approximately linear relationship with diameter-thickness ratio and were practically independent of span within the limits investi… more
Date: October 1942
Creator: Moore, R. L. & Holt, Marshall
Item Type: Refine your search to only Report

Become a nurse : your country needs you.

Description: Color poster of a young woman receiving her nursing cap. A male (only the hands and sleeves are shown) is placing it on her head. He wears blue sleeves with a stars-and-stripes motif on the cuffs. The young woman wears a blue cotton uniform with a white collar, cuffs, and pocket handkerchief. The model for this poster is Weslee Wootten D'Audney.
Date: 1942
Creator: American Nurses Association. Nursing Information Bureau.
Item Type: Refine your search to only Poster
open access

Bending of Rectangular Plates with Large Deflections

Description: "The solution of von Karman's fundamental equations for large deflections of plates is presented for the case of a simply supported rectangular plate under combined edge compression and lateral loading. Numerical solutions are given for square plates and for rectangular plates with a width-span ratio of 3:1. The effective widths under edge compression are compared with effective widths according to von Karman, Bengston, Marguerre, and Cox and with experimental results by Ramberg, McPherson, and… more
Date: May 1942
Creator: Levy, Samuel
Item Type: Refine your search to only Report
open access

Bending tests of a monocoque box

Description: A monocoque box beam consisting of a 24S-T aluminum-alloy sheet reinforced by four bulkheads and by longitudinal stringers and corner posts was subjected to bending loads as follows: pure bending about the lift axis, cantilever bending about the lift axis, and pure bending about both lift and drag axis. Longitudinal strains were measured for loads up to a load at which permanent set became measurable. The loads were sufficient to produce buckling of the sheet between stringers on the compressio… more
Date: November 1942
Creator: McPherson, Albert E.; Ramberg, Walter & Levy, Samuel
Item Type: Refine your search to only Report
open access

Bending With Large Deflection of a Clamped Rectangular Plate With Length-Width Ratio of 1.5 Under Normal Pressure

Description: "The Von Karman equations for a thin flat plate with large deflections are solved for the special case of a plate with clamped edges having a ratio of length to width of 1.5 and loaded by uniform normal pressure. Center deflections, membrane stresses, and extreme-fiber bending stresses are given as a function of pressure for center deflections up to twice the thickness of the plate. For small deflections the results coincide with those obtained by Hencky from the linear theory" (p. 1).
Date: July 1942
Creator: Levy, Samuel & Greenman, Samuel
Item Type: Refine your search to only Report
open access

A Brief Study of the Speed Reduction of Overtaking Airplanes by Means of Air Brakes

Description: "As an aid to airplane designers interested in providing pursuit airplanes with decelerating devices intended to increase the firing time when overtaking another airplane, formulas are given relating the pertinent distances and speeds in horizontal flight to the drag increase required. Charts are given for a representative parasite-drag coefficient from which the drag increase, the time gained, and the closing distance may be found. The charts are made up for three values of the ratio of the fi… more
Date: May 1942
Creator: Pearson, H. A. & Anderson, R. F.
Item Type: Refine your search to only Report
open access

Calculated effects of full-span slotted and Fowler flaps on longitudinal stability and control characteristics for a typical fighter-type airplane with various tail modifications

Description: Report presenting an analytical study of the influence of full-span slotted and Fowler flaps on the requirements for horizontal tail surfaces. The elevator deflection required to land at three-point attitude, elevator deflection required to stall the airplane at altitude, and permissible center-of-gravity range have been calculated for a fighter-type airplane.
Date: July 1942
Creator: Goranson, R. Fabian
Item Type: Refine your search to only Report
open access

Calculation of tab characteristics for flight conditions from wind-tunnel data

Description: Report presenting tail-surface characteristics calculated from wind-tunnel data, which have been reported to not correspond with flight-test measurements. The primary problem under consideration is the calculation of the effect of tab deflection on the free-floating angle of the elevator, as in a servocontrol.
Date: April 1942
Creator: Sears, Richard I.
Item Type: Refine your search to only Report
open access

Calibrations of pitot-static tubes at high speeds

Description: Report presenting the calibrations of three types of service pitot-static tubes over an approximate range of speeds of 150 to 600 miles per hour. The calibrations indicated a need for a pitot-static tube with greater accuracy, especially at higher speeds. Results regarding the service tubes, Prandtl tube, Eigh-speed tube, and a comparison of the tubes are provided.
Date: July 1942
Creator: Hensley, Reece V.
Item Type: Refine your search to only Report

Can you qualify for the Army Air Corps?

Description: Chart of requirements for joining the Army Air Corps. Upper and lower borders are red-white-and-blue stripes with text. A "watermark"-type logo can be seen in the background of the chart, with text: "LET'S GO! U.S.A. KEEP 'EM FLYING." This 1942 edition of the poster is distinguished by one split column numbered "2" under "Aviation Cadets" and one split column numbered "3" under "Enlisted Men."
Date: 1942
Creator: United States. Army. Recruiting Service.
Item Type: Refine your search to only Poster
open access

Care of damaged shade trees.

Description: Discusses the important role shade trees play in camouflaging property. Explains the ways in which shade trees can become damaged and provides advice for repairing them in the event of damage.
Date: May 1942
Creator: United States. Department of Agriculture.
Item Type: Refine your search to only Book
open access

Characteristics of beveled-trailing-edge elevators on a typical pursuit fuselage at altitudes simulating-normal flight and spin conditions

Description: Report presenting lift and elevator hinge-moment characteristics were measured on horizontal tail provided with elevators having three different beveled trailing edges. Results regarding fuselage alone and fuselage interference, lift characteristics of fuselage-tail combination, elevator hinge-moment characteristics, drag, and comparison with data from two-dimensional-flow tests are provided.
Date: December 1942
Creator: Gillis, Clarence L.
Item Type: Refine your search to only Report
open access

Characteristics of plain and balanced elevators on a typical pursuit fuselage at attitudes simulating normal-flight and spin conditions

Description: Report presenting lift and elevator hinge-moment characteristics of a horizontal tail with various plain and balanced elevators and mounted on a typical pursuit fuselage as measured in the 7- by 10-foot wind tunnel at attitudes simulating normal-flight and spin conditions. The lift effectiveness of the elevator was practically independent of the size of the aerodynamic balance. Results regarding the fuselage alone and fuselage interference, lift characteristics of fuselage-tail combinations, li… more
Date: March 1942
Creator: Sears, Richard I. & Hoggard, H. Page, Jr.
Item Type: Refine your search to only Report
open access

The Characteristics of Two Model Six-Blade Counterrotating Pusher Propellers of Conventional and Improved Aerodynamic Design

Description: Two airfoil plans were used for propeller blades. One is modified Clark Y section designed for structural reliability and the second an NACA 16 airfoil section designed to produce minimum aerodynamic losses. At low air speeds, the propeller designed for aerodynamic effects showed a gain of from 1.5 to 4.0 percent in propulsive efficiency over the conventional type depending on the pitch. Because of the numerous variables involved, the effect of each one on the aerodynamic characteristics of the… more
Date: June 1942
Creator: McHugh, James G. & Pepper, Edward
Item Type: Refine your search to only Report
Back to Top of Screen