Search Results

The Ammonium Carbonate Pressure Leaching of Uranium Ores Proposed as Feed to the Pilot Plant at Grand Junction, Colorado : Progress Report
From introduction: This is Progress report BMI-282, the first of a series covering the operation of the pressure-leaching towers for the extraction of uranium by an ammonium carbonate leach...This report discusses the data obtained from tests run to show the effects of such variables as the amount of air and carbon dioxide passed through the pulp, temperature, pressure, and concentration of ammonium carbonate and ammonium bicarbonate in the leach solution on the extraction of uranium.
An Application of the Concepts of Particle Packing to the Consolication of Silicon Carbide Powders
From introduction: Silicon carbide is being considered as a basis material for nonmetallic fuel elements because of its high thermal conductivity, low nuclear cross section, high resistance to thermal rupture, and high degree of stability at high temperature in air. A requirement of the fuel elements is that they be thin and have as low porosity as possible. One shape of element under consideration is 0.050 to 0.070 inch thick by a few inches in width and breadth.
Corrosion-Resistant Materials for Hydrofluoric Acid : Progress Report
Introduction: Among the many corrosion problems encountered in the production of uranium tetrafluoride and uranium metal from ores and concentrates, some of the most serious occur where hydrofluoric acid must be handled.
Critical-Assembly Studies on an Intermediate Reactor for Aircraft Propulsion
The following report studies an intermediate solid-fuel reactor system for aircraft propulsion.
The Determination of Rare Earths in Thorium
Abstract: "A quantitative method for the determination of individual rare earths in thorium down to a level of 0.05 ppm, is described. The procedure consists of a chromatographic cellulose-columns separation followed by a solution-type spectrographic determination. Values are given for the recovery of a number of rare earths using this combined procedure."
Estimated Manufacturing Costs for the Recovery of Thorium and Uranium from Monazite Sand
Abstract: "Costs have been estimated for the production of uranium and pure thorium from monasite concentrates by a process involving (1) reaction of monasite with caustic soda, (2) dissolution of the hydrous oxides in hydrochloric acid, (3) separation from the bulk of the rare earths by hydroxide precipitation of thorium and uranium, and (4) purification by solvent extraction."
Evaluation and Consolidation of Electrolytic Thorium
Abstract: "Sound, fabricable ingots of thorium were produced by triple are melting of electrolytic thorium. Consumable electrodes were fabricated by tack welding of cold-pressed and vacuum-sintered bars of the granular thorium electrodeposited from a molten-salt bath. The hydrogen content of the electrodeposited material was reduced from 80 to 4 ppm by vacuum sintering at 1250 C at pressures below 1 x 10-(-3) mm of mercury. Both sodium and chlorine content were reduced during melting; sodium from 250 to 25 ppm and chlorine from 1000 to 30 ppm. Oxygen and HCl acid-insoluble contents increased during sintering and melting. Oxygen content increased from 0.35 to 0.50 w/o and HCl acid-insoluble content from 0.8 to 4.0 w/o. A starlike includion revealed by metallographic examination of the as-cast thorium was identified as ThO2."
An Experimental Survey of the Heat-Treatment Response of some Zirconium-Uranium Alloys
Abstract: "The heat-treatment behavior of zirconium alloys containing 7 to 70 w/o uranium is described. The effect of oxygen contamination on the structure and hardness of these alloys is outlined. It is shown that in the initial stages pf transformation of beta zirconium-uranium solid solution into the low-temperature phases a potent hardening reaction occurs in alloys containing 20 to 70 w/o uranium. In this reaction the hardness may rise from 200 DPH characteristic of retained beta to values in excess of 400 DPH. Practical heat treatments have been developed which produce relatively soft alloys. The microstructures and hardnesses produces by these treatments are shown."
Identification of Reaction Products Formed During Magnesium Reduction of Uranium Tetrafluoride: Report
Abstract: "This report describes the results of X-ray diffraction examination of reaction products from a series of experiments performed by Mallinckrodt Chemical Works as an acid in understanding the process of bomb reduction of UF4. UF4 is initially reduced to UF3 by magnesium at 560 C., and subsequently to metal at 600 C. MgF2 from the initial reaction forms a coating on the magnesium which retards the final spontaneous reaction."
Investigation of the Behavior of NaOH-UO₃ Slurries in Small Flow Loops
From introduction: "This report presents the results of an experimental program to evaluate engineering problems which might be encountered when circulating NaOH-UO3 slurry through a thermal cycle."
The Kinetics of the Zirconium-Uranium Dioxide Reaction
This report discusses three experimental methods used to study the kinetics of the reaction between zirconium and UO2.
Progress Report on Nonaqueous Extractive Methods for Western Uranium Ores
Abstract: "Dissolution of carnotite in several readily liquefiable gases, including ammonia, sulfur dioxide, chlorine, and nitrogen dioxide, was found to be negligible, even in the presence of uranium complexing agents. No low-boiling liquids have been found which will dissolve carnotite directly. Treatment with various sulfur chloride will convert carnotite to a form soluble in water or in certain organic solvents. Also, carnotite can be readily dissolved in HCl-acidified ethanol, methanol, or acetone. Amenability tests on nine western ores with HCl-methanol solvent indicated that uranium extractions greater than 90 per cent could be obtained if sufficient acid was used to insure some free acidity in the pregnant liquor. Temple Mountain and Sinbad-Muddy River ores were exceptions to this, uranium extractions being only about 50-60 per cent. Vanadium extractions were invariably lower than uranium extractions. Chemical analyses are presented for nine western ores."
Progress Report on Nonaqueous Extractive Methods for Western Uranium Ores
The following progress report is part of a series of reports on the study of nonaqueous extractive methods for western uranium ores. This report continues studies on HCl-methanol leaching of Western ores, primarily on Temple Mountain ores.
Tungsten-Arc Welding of Ames Thorium and Thorium Alloys
This report follows an investigation made on the welding of Ames thorium by the inert-gas-shielded tungsten-arc process as the first part of a program on the joining of thorium. This program is part of a broader research program to develop the technology of thorium.
Zirconium Research and Development : Progress Report
From introduction: "This is the ninth monthly report, BMI-514, under Contract No. AT(30-1)-771 on "Zirconium Research and Development". The report covers the work period from September 15, 1950, to October 15, 1950. Work is continuing on the preparation of large-diameter zirconium crystal bars in the 16-inch-diameter de Boer unit. Crystal bars up to 1-5/16 inches in diameter and 8 feet long have been prepared in this unit."
Back to Top of Screen