UNT Libraries Government Documents Department - 138 Matching Results

Search Results

Results: 1 - 24 next
open access

The 6-Foot-4-Inch Wind Tunnel at the Washington Navy Yard

Description: Report discussing the 6-foot-4-inch wind tunnel and its auxiliary equipment has proven itself capable of continuous and reliable output of data. The real value of the tunnel will increase as experience is gained in checking the observed tunnel performance against full-scale performance. Such has been the case of the 8- by 8-foot tunnel, and for that reason the comparison in the calibration tests have been presented.
Date: August 1935
Creator: Desmond, G. L. & McCrary, J. A.
Item Type: Refine your search to only Report
open access

The Aerodynamic Aspect of Wing-Fuselage Fillets

Description: Report discussing model tests prove the feasibility of enhancing the aerodynamic qualities of wing-fuselage fillets by appropriate design of fuselage and wing roots. Abrupt changes from maximum fuselage height to wing chord must be avoided and every longitudinal section of fuselage and wing roots must be so faired and arranged as to preserve the original lift distribution of the continuous wing. Adapting the fuselage to the curvilinear circulation of the wing affords further improvement. The po… more
Date: February 1935
Creator: Muttray, H.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics of a wing with Fowler flaps including flap loads, downwash, and calculated effect on take-off

Description: From Summary: "This report presents the results of wind tunnel tests of a wing in combination with each of three sizes of Fowler flap. The purpose of the investigation was to determine the aerodynamic characteristics as affected by flap chord and position, the air loads on the flaps, and the effect of flaps on the downwash."
Date: 1935
Creator: Platt, Robert C.
Item Type: Refine your search to only Report
open access

Aerodynamic Characteristics of Several Airfoils of Low Aspect Ratio

Description: "This paper presents the results of wind-tunnel tests of several airfoils of low aspect ratio. The airfoils included three circular Clark Y airfoils with different amounts of dihedral, two Clark Y airfoils with slots in their portions, and three flat-plate airfoils. Lift, drag, and pitching-moment characteristics of the slotted airfoils with slots open and closed; pitching moment characteristics of one of the slotted airfoils with slots open and closed; and lift characteristics of the flat-plat… more
Date: August 1935
Creator: Zimmerman, C. H.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics of wings with cambered external airfoil flaps, including lateral control, with a full-span flap

Description: From Summary: "The results of a wind-tunnel investigation of the NACA 23012, the NACA 23021, and the Clark Y airfoils, each equipped with a cambered external-airfoil flap, are presented in this report. The purpose of the research was to determine the relative merit of the various airfoils in combination with the cambered flap and to investigate the use of the flap as a combined lateral-control and high-lift device."
Date: 1935
Creator: Platt, Robert C.
Item Type: Refine your search to only Report
open access

The Aerodynamic Drag of Flying-Boat Hull Model as Measured in the NACA 20-Foot Wind Tunnel - 1

Description: "The main purpose of this investigation is to make available to the designer useful information with regard to the aerodynamic drag of various types of flying-boat hull models. The present report is the first in a series covering investigation in this field. Through close cooperation between hydrodynamics and aerodynamics divisions it is hoped that results leading to improvements in hull design obtained" (p. 1).
Date: April 1935
Creator: Hartman, Edwin P.
Item Type: Refine your search to only Report
open access

Air flow around finned cylinders

Description: Report presents the results of a study made to determine the air-flow characteristics around finned cylinders. Air-flow distribution is given for a smooth cylinder, for a finned cylinder having several fin spacings and fin widths, and for a cylinder with several types of baffle with various entrance and exit shapes. The results of these tests show: that flow characteristics around a cylinder are not so critical to changes in fin width as they are to fin spacing; that the entrance of the baffle … more
Date: November 7, 1935
Creator: Brevoort, M. J. & Rollin, Vern G.
Item Type: Refine your search to only Report
open access

Aircraft compass characteristics

Description: From Summary: "A description of the test methods used at the National Bureau of Standards for determining the characteristics of aircraft compasses is given. The methods described are particularly applicable to compasses in which mineral oil is used as the damping liquid. Data on the viscosity and density of certain mineral oils used in United States Navy aircraft compasses are presented. Results of flight tests are presented."
Date: December 14, 1935
Creator: Peterson, John B. & Smith, Clyde W.
Item Type: Refine your search to only Report
open access

Analysis of a Strut With a Single Elastic Support in the Span, With Applications to the Design of Airplane Jury-Strut Systems

Description: Report presenting an analysis of a wing brace with a small auxiliary strut, which is attached to the wing spar at the upper end. The design is quite effective but has some difficult analysis problems. The report is broken into two parts; one is a theoretical investigation and one is an experimental investigation.
Date: May 1935
Creator: Schwartz, A. Murray & Bogert, Reid
Item Type: Refine your search to only Report
open access

An Application of the Von Kármán-Millikan Laminar Boundary-Layer Theory and Comparison With Experiment

Description: Note presenting the von Kármán-Millikan theory of laminar boundary layers as applied to the laminar boundary layer about an elliptical cylinder on which boundary-layer and pressure-distribution measurements. Good agreement is obtained between calculated and experimental results, meaning that the method may be generally applied to the laminar boundary layer about any body provided that an experimentally determined pressure distribution is available.
Date: October 1935
Creator: von Doenhoff, Albert E.
Item Type: Refine your search to only Report
open access

Bending Stresses Due to Torsion in Cantilever Box Beams

Description: "The paper beings with a brief discussion on the origin of the bending stresses in cantilever box beams under torsion. A critical survey of existing theory is followed by a summary of design formulas; this summary is based on the most complete solution published but omits all refinements considered unnecessary at the present state of development. Strain-gage tests made by NACA to obtained some experimental verification of the formulas are described next. Finally, the formulas are applied to a s… more
Date: June 1935
Creator: Kuhn, Paul
Item Type: Refine your search to only Report
open access

Calculations of the Effect of Wing Twist on the Air Forces Acting on a Monoplane Wing

Description: "A method is presented for calculating the aerodynamic forces on a moncylane wing, taking into account the elastic twisting of the wing due to these forces. The lift distribution along the span is calculated by the formulas of Amstutz as a function of the geometrical characteristics of the wing and of the twist at stations 60 and 90 percent of the semispan. The twist for a given lift distribution is calculated by means of influence lines" (p. 1).
Date: March 1935
Creator: Dätwyler, G.
Item Type: Refine your search to only Report
open access

Cattle Scab and Methods of Control and Eradication

Description: Revised edition. "Cattle scab can be eradicated by dipping or spraying, but dipping is the better method of treatment. Lime-sulphur dips, nicotine dips, and crude-petroleum dips are efficacious. Methods of preparing and using these dips are described and the intervals between dippings and the conditions under which the various dips may safely be used for the different kinds of scab are discussed. Also, plans of cattle-dipping plants and directions for building vats and dipping cattle are given.… more
Date: 1935
Creator: Imes, Marion
Item Type: Refine your search to only Pamphlet
open access

Characteristics of the NACA 23012 airfoil from tests in the full-scale and variable-density tunnels

Description: "This report gives the results of tests in the NACA full-scale and variable-density tunnels of a new wing section, the NACA 23012, which is one of the more promising of an extended series of related airfoils recently developed. The tests were made at several values of the Reynolds number between 1,000,000 and 8,000,000. The new airfoil develops a reasonably high maximum lift and a low profile drag, which results in an unusually high value of the speed-range index. In addition, the pitching-mome… more
Date: March 1, 1935
Creator: Jacobs, Eastman N. & Clay, William C.
Item Type: Refine your search to only Report
open access

Coal-Mine Accidents in the United States, 1933

Description: Report compiled by the U.S. Bureau of Mines including statistics on fatal and non-fatal accidents in coal mines located in the United States as well as data regarding the various operations (e.g., number of miners employed and average production). The information is organized into tables for comparison and the text draws some overall conclusions in the summary.
Date: 1935
Creator: Adams, W. W. & Geyer, L. E.
Item Type: Refine your search to only Report
open access

Combustion in a Bomb With a Fuel-Injection System

Description: "Fuel injected into a spherical bomb filled with air at a desired density and temperature could be ignited with a spark a few thousandths of a second after injection, an interval comparable with the ignition lag in fuel-injection engines. The effect of several variables on the extent and rate of combustion was investigated: time intervals between injection and ignition of fuel of 0.003 to 0.06 second and one of 5 minutes; initial air temperatures of 100 degrees C. to 250 degrees C.; initial air… more
Date: August 9, 1935
Creator: Cohn, Mildred & Spencer, Robert C.
Item Type: Refine your search to only Report
Back to Top of Screen