UNT Libraries Government Documents Department - 48 Matching Results

Search Results

Results: 1 - 24 next
open access

Airfoil-Contour Modifications Based on (Epsilon)-Curve Method of Calculating Pressure Distribution

Description: From Introduction: "Certain alternations of a qualitative nature may be performed in spite of the fact that a pressure change cannot be prescribed. It is the purpose of this paper to indicate a method by which qualitative alternation may be performed. It will be noted that the present method of contour modification will serve the intended purpose of the inverse method."
Date: July 1944
Creator: Theodorsen, Theodore
Item Type: Refine your search to only Report
open access

Analysis of Square Shear Web Above Buckling Load

Description: "A solution of Von Karman's fundamental equations for plates with large deflections is presented for the case of a shear web divided into square panels by reinforcing struts. Numerical solutions are given for struts of infinite rigidity and for struts the weight of which is one-fourth the weight of the sheet. The results are compared with Wagner's diagonal tension theory as extended by Kuhn and by Langhaar. It is found that the diagonal tension theory as developed by Kuhn agrees best with the p… more
Date: July 1944
Creator: Levy, Samuel; Fienup, Kenneth L. & Woolley, Ruth M.
Item Type: Refine your search to only Report
open access

Applicability of Similarity Principles to Structural Models

Description: "A systematic account is given in part I of the use of dimensional analysis in constructing similarity conditions for models and structures. The analysis covers large deflections, buckling, plastic behavior, and materials with nonlinear stress-strain characteristics, as well as the simpler structural problems" (p. 1).
Date: July 1944
Creator: Goodier, J. N. & Thomson, W. T.
Item Type: Refine your search to only Report
open access

The Behavior of Some Solid Materials Under Pile Operating Conditions

Description: Technical report abstract. The present state of knowledge concerning the effect of pile radiation on a variety of solid materials is reviewed. Radiation corrosion will not be a serious hazard for aluminum or stainless steel but it can be for iron or lead if either are exposed to water. Apart from corrosion the principal uncertainty is in regard to the Wigner effect on the behavior of metals. There is at present no ground for optimism regarding the behavior of tuballoy. The effect on alumin… more
Date: July 20, 1944
Creator: Burton, Milton, 1902- & Seitz, Frederick, 1911-2008
Item Type: Refine your search to only Report
open access

Building 313 operations

Description: On June 3 the writer was detailed to the 300 Area to study operations in Bldg, 313. Seven days were spent with C shift in the caning and dipping area. In this period, a system of coordinating press cycles was developed to utilize machine time most effectively. Subsequently, a brief amount of time was spent working in a design of the can cleaning area so as to incorporate the aluminum can etching operation and facilitate the handling and flow of materials. The next stage of perhaps a week was de… more
Date: July 7, 1944
Creator: Venable, I. B.
Item Type: Refine your search to only Report
open access

Compressibility and Heating Effects on Pressure Loss and Cooling of a Baffled Cylinder Barrel

Description: Report presenting testing to obtain experimental confirmation of the effect of air compressibility on cooling and pressure loss of a baffled cylinder barrel and to evaluate various methods of analysis. Testing occurred over a wide range of air flows and density altitudes.
Date: July 1944
Creator: Goldstein, Arthur W. & Ellerbrock, Herman H., Jr.
Item Type: Refine your search to only Report
open access

Compressibility and Heating Effects on Pressure Loss and Cooling of a Baffled Cylinder Barrel

Description: "Theoretical investigations have shown that, because air is compressible, the pressure-drop requirements for cooling an air-cooled engine will be much greater at high altitudes and high speeds than at sea level and low speeds. Tests were conducted by the NACA to obtain some experimental confirmation of the effect of air compressibility on cooling and pressure loss of a baffled cylinder barrel and to evaluate various methods of analysis. The results reported in the present paper are regarded as … more
Date: July 1, 1944
Creator: Goldstein, Arthur W. & Ellerbrock, Herman H., Jr.
Item Type: Refine your search to only Report
open access

Compressibility and Heating Effects on Pressure Loss and Cooling of a Baffled Cylinder Barrel

Description: "Theoretical investigations have shown that, because air is compressible, the pressure-drop requirements for cooling an air-cooled engine will be much greater at high altitudes and high speeds than at sea level and low speeds. Tests were conducted by the NACA to obtain some experimental confirmation of the effect of air compressibility on cooling and pressure loss of a baffled cylinder barrel and to evaluate various methods of analysis. The results reported in the present paper are regarded as … more
Date: July 1, 1944
Creator: Goldstein, Arthur W. & Ellerbrock, Herman H., Jr.
Item Type: Refine your search to only Report
open access

Contributions to the Water Problem

Description: Technical report describing the investigation of the short-lived activities produced in oxygen compounds by irradiation with pile neutrons. The most prominent of these activities in cooling water is a beta and gamma emitting activity of about 8 second half-life. Because of its production by epicadmium neutrons it was believed to be the 8 second N16 produced in the pile by n,p on O16. The identification has been accomplished and it is established that the 8 second activity is N16. Part 2 of the… more
Date: July 3, 1944
Creator: Novey, Theodore B.
Item Type: Refine your search to only Report
open access

Effect of Compressibility on Pressure Distribution Over an Airfoil With a Slotted Frise Aileron

Description: Pressure distribution measurements were made over an airfoil with slotted Frise aileron up to 0.76 Mach at various angles of attack and aileron defections. Section characteristics were determined from these pressure data. Results indicated loss of aileron rolling power for deflections ranging from -12 Degrees to -19 Degrees.
Date: July 1944
Creator: Luoma, Arvo A.
Item Type: Refine your search to only Report
open access

The effect of cooling-air blowers on thrust power

Description: Report presenting an analysis of the effect of cooling-air blowers on thrust power using an assumed airplane. Results indicated that when aviation-engine heat exchangers are used above their design altitude, blowers may be used to give additional available pressure and to increase jet thrust. Results regarding airplane speed, altitude, fin width, physical significance of the heat cycle, and thermodynamic efficiency are provided.
Date: July 1944
Creator: Palmer, Carl B. & Brevoort, Maurice J.
Item Type: Refine your search to only Report
open access

The Effect of Increased Cooling Surface on Performance of Aircraft-Engine Cylinders as Shown by Tests of the NACA Cylinder

Description: Report presenting a method of constructing fins of nearly optimum proportions to the point where a cylinder has been manufactured and tested. Data were obtained on cylinder temperature for a wide range of inlet-manifold pressures, engine speeds, and cooling-pressure differences. Results regarding cooling equations, cylinder-temperature relationships, and a comparison of three cylinder cooling performances are provided.
Date: July 1944
Creator: Schey, Oscar W.; Rollin, Vern G. & Ellerbrock, Herman H., Jr.
Item Type: Refine your search to only Report
open access

The Effect of Increased Cooling Surface on Performance of Aircraft-Engine Cylinders as Shown by Tests of the NACA Cylinder

Description: A method of constructing fins of nearly optimum proportions has been developed by the NACA to the point where a cylinder has been manufactured and tested. Data were obtained on cylinder temperature for a wide range of inlet-manifold pressures, engine speeds, and cooling-pressure differences. The results indicate that an improvement of 40 percent in the outside-wall heat-transfer coefficient could be realized on the present NACA cylinder by providing a thermal bond equivalent to that of an integ… more
Date: July 1, 1944
Creator: Schey, Oscar W.; Rollin, Vern G. & Ellerbrock, Herman H., Jr.
Item Type: Refine your search to only Report
open access

The Effect of Piston-Head Temperature on Knock-Limited Power

Description: To determine the effect of piston-head temperature on knock-limited power, tests were made in a supercharged CFR engine over a range of fuel-air ratios from 0.055 to 0.120, using S-3 reference fuel, AN-F-28, Amendment-2, aviation gasoline, and AN-F-28 plus 2 percent xylidines by weight. Tests were run at a compression ratio of 7.0 with inlet-air temperatures of 150 F and 250 F and at a compression ratio of 8.0 with an inlet-air temperature of 250 F. All other engine conditions were held constan… more
Date: July 1944
Creator: Imming, Harry S.
Item Type: Refine your search to only Report
open access

The Effect of Radiation on the Corrosion of Metals by Water

Description: Technical report. Long-time tests have been made on the effect of various types of radiation on the corrosion of 2S aluminum in simulated W water. In no case was any acceleration of corrosion by the radiation observed; the effect of radiation, if any, appeared to be a protective one. Deuteron irradiation did accelerate the corrosion of mild steel at low flow rates in hot water of pH 6 to 7, but no appreciable effect was observed with copper, stainless steel, or tuballoy. The general theory … more
Date: July 6, 1944
Creator: Allen, A. O. (Augustine O.); Bowman, M. C.; Goldowski, Nathalie; Larson, R. G. & Treiman, L.
Item Type: Refine your search to only Report
open access

The Effect of Radiation on the Corrosion of Metals by Water. (Problem No. 322 MLC 2213)

Description: Long-time tests have been made on the effect of various types of radiation on the corrosion of 2S aluminum in simulated W water. In no case was any acceleration of corrosion by the radiation observed; the effect of radiation, if any, appeared to be a protective one. Deuteron irradiation did accelerate the corrosion of mild steel at low flow rates in hot water of pH 6 to 7, but no appreciable effect was observed with copper, stainless steel, or tuballoy. The general theory of the effect of radia… more
Date: July 6, 1944
Creator: Allen, A. O.; Bowman, M. C.; Goldowski, N.; Larson, R. G. & Treiman, L.
Item Type: Refine your search to only Report
open access

Estimation of Pressure Distributions at Subcritical Speeds for Turrets Located on a Wing

Description: Report presenting the use of current methods that include interference and compressibility effects to estimate pressures over and near turrets located on a wing in regions of high interference velocities. The agreement between measured and estimated pressures indicated that present methods are adequate for predicting approximate critical speeds and for estimating loads at subcritical speeds with sufficient accuracy for design purposes.
Date: July 1944
Creator: Ritchie, Virgil S. & Daniels, Everett J.
Item Type: Refine your search to only Report
open access

Explosives TNX Technical Division, Hanford weekly report for period ending July 25, 1944

Description: Progress on finding suitable water conditions for start-up had been approached as closely as possible with our present equipment and information as to the requirements. The water composition should be attainable that is not corrosive or build up a film rapidly, and we have means available for removal of such films. Slug classification methods were analyzed from a dimensional standpoint. Analysis of current CMX data was undertaken with the objective of establishing allowable variations in pressu… more
Date: July 26, 1944
Creator: Worthington, H.
Item Type: Refine your search to only Report
open access

Extrusion of Compound Tubes of Aluminum and B4C

Description: Various experimenters have shown (H.H. Gersman U.S. Patent 2,335,590, Nov. 30, 1943; Aluminum Co. of America, various technical papers; also CT-482) that when a billet is extruded by proper technique into a rod (or tube by a floating mandril) that flow of material is streamline and and the extruded article is essentially a space replica of the billet, with linearly distorted coordinates. Advantage is taken of this fact in the manufacture of alclad tubing in which a billet containing an inner co… more
Date: July 1, 1944
Creator: Creutz, E. C.
Item Type: Refine your search to only Report
open access

Flight tests of various tail modifications on the Brewster XSBA-1 airplane 3: measurements of flying qualities with tail configuration 3

Description: Report presenting a series of tests on the Brewster XSBA-1 airplane to determine the effects of various tail modifications. Some of the modifications include variations of the chord of the elevator and rudder while the span and total area of the surfaces are kept constant and variations of the total area of the vertical tail surface. Results regarding the longitudinal stability and control and lateral stability and control are provided.
Date: July 1944
Creator: Crane, H. L. & Reeder, J. P.
Item Type: Refine your search to only Report
open access

The Flow of a Compressible Fluid Past a Circular Arc Profile

Description: "The Ackeret iteration process is utilized to obtain higher approximations than that of Prandtl and Glauert for the flow of a compressible fluid past a circular arc profile. The procedure is to expand the velocity potential in a power series of the camber coefficient. The first two terms of the development correspond to the Prandtl-Glauert approximation and yield the well-known correction to the circulation about the profile" (p. 385).
Date: July 15, 1944
Creator: Kaplan, Carl
Item Type: Refine your search to only Report
Back to Top of Screen