UNT Libraries Government Documents Department - 821 Matching Results

Search Results

Results: 1 - 24 next
open access

The 1350 F stress-rupture properties of two wrought alloys and three cast alloys

Description: From Summary: "These properties compare favorably with those of the strongest similar alloys previously investigated. However, compared with a 60Cr-25Fe-15Mo alloy, the three cobalt-chronium-nickel cast alloys are inferior. A correlation of NACA and OSRD (Project NRC-8) data is presented, showing the variation of rupture strengths with temperature in the range of 1350^o to 2000^o for alloys."
Date: November 1947
Creator: Reynolds, E. E.; Freeman, J. W. & White, A. E.
Item Type: Refine your search to only Report
open access

Abrasive Blasting for Cleaning Parts

Description: Abstract: A demonstration on August 22, 1945, showed that Alpha or Beta M or K parts, including insulators, can be well cleaned with a pressure-feed abrasive blaster. The abrasive is a slurry of alumina and water mixed with high velocity air in a special feed nozzle. The slurry is continuously recycled.
Date: September 1945
Creator: McWherter, Jack R. & Yerazunis, Stephen
Item Type: Refine your search to only Report
open access

The Acute Radiotoxicity of Injected Na²⁴ for Mice and Rats

Description: The following report describes the results from studies based on the toxicity and metabolism of radioactive substances derived from uranium fission. Rats and mice were administered radioactive sodium and reactions and changes were studied.
Date: April 15, 1948
Creator: Finkle, R. D.; Snyder, R. H.; Kisieleski, Walter E.; Teresi, J.; Broido, A. & Tompkins, P. C.
Item Type: Refine your search to only Report
open access

Adsorbent Clays: Their Distribution, Properties, Production, and Uses

Description: From Abstract: "This bulletin is a summary of present knowledge of the adsorbent or bleaching clays-their distribution, field and laboratory identification, physical and chemical properties, uses, quality, and value. Problems in the drying, treating with acids, and washing are discussed, and methods of testing and rating decolorizing efficiency are described."
Date: 1943
Creator: Nutting, P. G.
Item Type: Refine your search to only Report
open access

Air-consumption parameters for automatic mixture control of aircraft engines

Description: From Introduction: "The purpose of this analysis was to investigate the use of function of intake-manifold temperature and pressure, exhaust back pressure, and engine speed in place of a ventri as a means of measuring engine air consumption and to determine if this function is suitable for automatic mixture control."
Date: September 1944
Creator: Shames, Sidney J.
Item Type: Refine your search to only Report
open access

Air-Consumption Parameters for Automatic Mixture Control of Aircraft Engines

Description: From Introduction: "The purpose of this analysis was to investigate the use of a function of intake-manifold pressure, exhaust back pressure, intake manifold temperature, and engine speed in place of a venturi as a means of measuring engine air consumption and to determine if this function is suitable for automatic mixture control."
Date: September 1, 1944
Creator: Shames, Sidney J.
Item Type: Refine your search to only Report
open access

Alpha Particle Detection and the A. C. Operated Detector "A" (Howler)

Description: Abstract: This discussion concerns the operation, construction, and servicing of an alpha rate meter of medium sensitivity (30,000 alpha particles full scale per minute) and good stability. The instrument is equipped with an oscillator which increases both in frequency and loudness as the alpha activity is increased. The oscillator circuit includes an anticipator which causes a change in frequency depending directly upon the rate of change of alpha activity. Maximum sensitivity is approximately… more
Date: January 29, 1946
Creator: Neil, Hugh G.
Item Type: Refine your search to only Report
open access

Altitude-wind-tunnel investigation of thrust augmentation of a turbojet engine IV: performance with tail-pipe burning and water injection

Description: From Introduction: "Thrust augmentation of an axial-flow-type turbojet engine by burning fuel in the tail pipe is discussed in references 1 to 3. Thrust augmentation of the same turbojet engine by water injection at the compressor inlet is reported in reference 4."
Date: June 15, 1948
Creator: Dietz, Robert O., Jr.; Wishnek, George & Kuenzig, John K.
Item Type: Refine your search to only Report
open access

Altitude-wind-tunnel tests of power-plant installation in jet-propelled fighter

Description: From Introduction: "The research program included clean-up tests (unpublished data) and stability and control tests (reference 1) made in the NACA Langley full-scale tunnel. An investigation of the aerodynamic characteristics of the power-plant installation in the Cleveland altitude wind tunnel is discussed in this report."
Date: February 1946
Creator: Preston, G. Merritt; Black, Fred O., Jr. & Jagger, James M.
Item Type: Refine your search to only Report
open access

Ames Project, Chemical Research - Analytical Chemistry, Report for Period of February 1 to March 10, 1944

Description: Technical report covering (1) analysis of uranium bromide and chloride samples, (2) the ferric-nitrate method of analyzing uranium fluorides for fluorine, (3) spectrographic determination of boron, cadmium and manganese in magnesium metal, (4) service analyses. contributions to other problems, (5) attempted preparation of uranous oxyfluoride, and (6) corrections in previous reports.
Date: April 13, 1944
Creator: Spedding, F. H. (Frank Harold), 1902- & Wilholm, H. A.
Item Type: Refine your search to only Report
Back to Top of Screen