National Advisory Committee for Aeronautics (NACA) - 150 Matching Results

Search Results

Results: 1 - 24 next
open access

Aerodynamic Characteristics of a 45 Degree Swept Wing Fighter Airplane Model and Aerodynamic Loads on Adjacent Stores and Missiles at Mach Numbers of 1.57, 1.87, 2.16, and 2.53

Description: Report discussing tests to determine the aerodynamic characteristics of a model of a 45 degree swept-wing fighter airplane and to determine the loads on attached stores and detached missiles. An investigation into aileron-spoiler effectiveness, aileron hinge moments, and the effects of wing modifications of aerodynamic characteristics was also carried out at various Mach numbers. Results are presented, but caution is provided in regards to extrapolating results from the model onto a full-scale … more
Date: June 24, 1958
Creator: Oehman, Waldo I. & Turner, Kenneth L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Some Effects of Sweep and Aspect Ratio on the Transonic Flutter Characteristics of a Series of Thin Cantilever Wings Having a Taper Ratio of 0.6

Description: Report presenting an investigation of the flutter characteristics of a series of thin cantilever wings with taper ratios of 0.6 for a range of Mach numbers. Results regarding flutter frequencies, time histories, effects of sweep on the flutter-speed ratio, effects of aspect ratio on the flutter-speed ratio, effects of additional models on the reference flutter speed, application of the flutter-speed ratio, and modified experimental flutter-speed coefficient are provided.
Date: January 24, 1956
Creator: Unangst, John R. & Jones, George W., Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Investigation of local heat-transfer and pressure drag characteristics of a yawed circular cylinder at supersonic speeds

Description: Local heat-transfer coefficients, temperature recovery factors, and pressure distributions were measured on the front side of a circular cylinder at a nominal Mach number of 3.9 over a range of free-stream Reynolds numbers from 2.1 x 10 to the 3rd power to 6.7 x 10 to the 3rd power and yaw angles from zero degrees to 44 degrees. Yawing the cylinder reduced the heat-transfer coefficients and the pressure drag coefficients. The amount of reduction may be predicted by a theory presented herein.
Date: January 24, 1956
Creator: Goodwin, Glen; Creager, Marcus O. & Winkler, Ernest L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Low-Amplitude Damping-in-Pitch Characteristics of Four Tailless Swept Wing-Body Combinations at Mach Numbers From 0.85 to 1.30 as Obtained With Rocket-Powered Models

Description: Report presenting an investigation to determine the damping-in-pitch characteristics of four rocket-powered wing-body combinations for a range of Mach numbers from 0.85 to 1.30. The models were tested at the same center-of-gravity location and had identical bodies. Information about the trim, lift, static longitudinal stability, dynamic longitudinal stability, and drag is provided.
Date: November 24, 1954
Creator: D'Aiutolo, Charles T.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Investigation of Supersonic-Compressor Rotors Designed with External Compression

Description: Report presenting an investigation of the possibility of utilizing the relatively good characteristics of the spike-type diffuser in the supersonic compressor. Results regarding the overall performance, inlet conditions, outlet conditions, entrance flow conditions, and estimated performance of subsonic portion of rotor passage are provided.
Date: September 24, 1954
Creator: Jahnsen, Lawrence J. & Hartmann, Melvin J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Results of initial wind-tunnel flutter experiments at low speed with a towed airplane model having a 40 degree sweptback wing of aspect ratio 3.62 equipped with pylon-mounted stores

Description: Report presenting wind-tunnel flutter testing at a range of Mach numbers conducted on a swept-wing towed airplane model equipped with an autopilot system. Results regarding the towed model tests, fixed-root tests, and a comparison between the calculated and experimental flutter characteristics are provided.
Date: March 24, 1955
Creator: Martina, Albert P. & Young, George E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Low-Amplitude Damping-in-Pitch Characteristics of Tailless Delta-Wing-Body Combinations at Mach Numbers From 0.80 to 1.35 as Obtained With Rocket-Powered Models

Description: Report of an investigation using three rocket-propelled delta-wing-body combinations for a range of Mach numbers to determine the damping-in-pitch characteristics. All models were statically stable but dynamically unstable at transonic speeds. Information about trim, lift, and drag is also provided.
Date: June 24, 1954
Creator: D'Aiutolo, Charles T.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Intensity, scale, and spectra of turbulence in mixing region of free subsonic jet

Description: Report presents the results of the measurements of intensity of turbulence, the longitudinal and lateral correlation coefficients, and the spectra of turbulence in a 3.5-inch-diameter free jet measured with hot-wire anemometers at exit Mach numbers from 0.2 to 0.7 and Reynolds numbers from 192,000 to 725,000.
Date: April 24, 1956
Creator: Laurence, James C.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The effect of ground on the low-speed aerodynamics control, and control hinge-moment characteristics of a delta-wing-fuselage model with trailing-edge controls

Description: Report presenting an investigation to determine the effect of ground on the low-speed aerodynamic, control, and control hinge-moment characteristics of a 3-percent-thick, delta-wing-fuselage configuration. Aerodynamic forces and moments and hinge-moment data were obtained for a range of angles of attack, ground heights, and a designated Mach and Reynolds number.
Date: September 24, 1954
Creator: Scallion, William I.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Experimental Performance of a 5000-Pound-Thrust Rocket Chamber Using a 20-Percent-Fluorine - 80-Percent-Oxygen Mixture With RP-1

Description: Memorandum presenting an evaluation of the performance increase resulting from the addition of 20 percent fluorine to the oxygen-RP-1 propellant combination in a 5000-pound-thrust rocket engine at a chamber pressure of 650 pounds per square inch absolute. Runs were made with the engine water cooled and regeneratively cooled.
Date: April 24, 1957
Creator: Tomazic, William A.; Kutina, Franklin J., Jr. & Rothenberg, Edward A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Transonic Flutter Investigation of Models of the All-Movable Horizontal Tail of a Fighter Airplane

Description: Memorandum presenting a transonic flutter investigation of models of the all-movable horizontal tail of a fighter airplane in the transonic blowdown tunnel. The models were dynamically and elastically scaled by criteria which provide a flutter safety margin. Results regarding some general comments, simulated airplane tests, effects of pitch stiffness with rearward pitch axis, and effect of pitch-axis location are provided.
Date: January 24, 1958
Creator: Sellers, Thomas B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Low-Speed Static Stability Characteristics of a Complete Model with an M-Wing in Mid and High Positions and with Three Horizontal-Tail Heights

Description: Report presenting an investigation of the low-speed static longitudinal and lateral stability characteristics of a model with an M-wing in mid and high positions and with three horizontal-tail heights. The wing had its sweep discontinuity at 40-percent wing semispan, an aspect ratio of 6, a taper ratio of 0.60, NACA 65A009 airfoil sections parallel to the plane of symmetry, and 45 degrees sweep of the quarter-chord lines. Results regarding longitudinal stability characteristics and lateral stab… more
Date: January 24, 1956
Creator: Fournier, Paul G.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Investigation of a Cermet Gas-Turbine-Blade Material of Titanium Carbide Infiltrated With Hastalloy C

Description: A cermet composition was investigated as a potential material for gas-turbine blades. Blades of HS-21 alloy were also operated in the engine simultaneously to provide a basis of comparison. The cermet blades survived as long as approximately 312-1/2 hours at about 1500 degrees F with an average midspan centrifugal stress of approximately 11,500 psi.
Date: January 24, 1955
Creator: Hoffman, Charles A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

An improved approximate method for calculating lift distributions due to twist

Description: Report presenting a method for calculating the lift distribution due to twist which gives a closer approximation than the current Schrenk empirical method and requires about the same amount of computing. The method uses the lifting-line theory and makes use of the lift distribution due to angle of attack and considers the aspect ratio of the wing. Examples are presented for four main types of twist: symmetrical, antisymmetrical, continuous, and discontinuous.
Date: May 24, 1950
Creator: Sivells, James C.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Investigation of Aerodynamic and Icing Characteristics of a Flush Alternate Inlet Induction System Air Scoop

Description: "An investigation has been made in the NACA Lewis icing research tunnel to determine the aerodynamic and icing characteristics of a full-scale induction-system air-scoop assembly incorporating a flush alternate inlet. The flush inlet was located immediately downstream of the offset ram inlet and included a 180 deg reversal and a 90 deg elbow in the ducting between inlet and carburetor top deck. The model also had a preheat-air inlet" (p. 1).
Date: July 24, 1953
Creator: Lewis, James P.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Use of Truncated Flapped Airfoils for Impingement and Icing Tests of Full-Scale Leading-Edge Sections

Description: From Summary: "In an effort to increase the operational range of existing small icing tunnels, the use of truncated airfoil sections has been suggested. With truncated airfoils, large-scale or even full-scale wing-icing-protection systems could be evaluated. Therefore, experimental studies were conducted in the NACA Lewis laboratory icing tunnel with an NACA 651-212 airfoil section to determine the effect of truncating the airfoil chord on velocity distribution and impingement characteristics. … more
Date: July 24, 1956
Creator: von Glahn, Uwe H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Preliminary Results of Cyclical De-Icing of a Gas-Heated Airfoil

Description: "An NACA 65(sub 1)-212 airfoil of 8-foot chord was provided with a gas-heated leading edge for investigations of cyclical de-icing. De-icing was accomplished with intermittent heating of airfoil segments that supplied hot gas to chordwise passages in a double-skin construction. Ice removal was facilitated by a spanwise leading-edge parting strip which was continuously heated from the gas-supply duct. Preliminary results demonstrate that satisfactory cyclical ice removal occurs with ratios of cy… more
Date: January 24, 1952
Creator: Gray, V. H.; Bowden, D. T. & von Glahn, U.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Interpretation of boundary-layer pressure-rake data in flow with a detached shock

Description: From Summary: "A procedure is presented for determining boundary-layer quantities from pressure-rake data, which include the combined effects of viscous and shock losses. The problem is analyzed using schileren photographs of the shock configuration, the continuity of mass relationship, and the characteristics of the turbulent boundary layer that its outer edge is defined by a rapid change in slope in the Mach-number profiles in the vicinity of the edge."
Date: August 24, 1950
Creator: Luidens, Roger W. & Madden, Robert T.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Investigation of Noise Field and Velocity Profiles of an Afterburning Engine

Description: From Summary: "Sound pressure levels, frequency spectrum, and jet velocity profiles are presented for an engine-afterburner combination at various values of afterburner fuel - air ratio. At the high fuel-air ratios, severe low-frequency resonance was encountered which represented more than half the total energy in the sound spectrum. At similar thrust conditions, lower sound pressure levels were obtained from a current fighter air craft with a different afterburner configuration. The lower soun… more
Date: September 24, 1954
Creator: North, Warren J.; Callaghan, Edmund E. & Lanzo, Chester D.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Interference Effects of Fuselage-Stored Missiles on Inlet Duct Model of an Interceptor-Type Aircraft at Mach Numbers 1.5 to 1.9

Description: Memorandum presenting the effect of missile armament on the performance of an interceptor-type aircraft model at Mach numbers 1.5, 1.7, and 1.9 and at angles of attack up to 19 degrees. The aircraft model was characterized by triangular-shaped normal-shock inlets located at wing roots. Results regarding force measurements, effect of armament on inlet-duct performance, fuselage boundary-layer survey, and total-pressure contours at inlet throat and diffuser exit are provided.
Date: April 24, 1957
Creator: Piercy, Thomas G. & Davis, Owen H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Effects of Body Vortices and the Wing Shock-Expansion Field on the Pitch-Up Characteristics of Supersonic Airplanes

Description: Memorandum presenting a technique for predicting the influence of body vortices and the wing shock-expansion field on the pitch-up characteristics of supersonic airplanes to supplement the calculative methods for wing vortices which are well known. The method is applied to the prediction of the pitch-up characteristics of four airplanes with high tails, of which one serves as a calculative example.
Date: March 24, 1958
Creator: Nielsen, Jack N.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

An Experimental Investigation of the Static Longitudinal Stability and Control Characteristics of a Wingless Missile Configuration at Mach Numbers From 3.0 to 6.3

Description: Memorandum presenting static longitudinal stability and control characteristics of a flare-stabilized body of revolution employing a movable portion of the flare surface as a pitch control determined for a range of Mach numbers, angles of attack, and control deflections. The variation of lift coefficient with pitching-moment coefficient for the basic configuration with control undeflected was found to be essentially linear, and the stability to increase slightly with increasing Mach number.
Date: June 24, 1958
Creator: Gloria, Hermilo R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen