UNT Libraries - 4 Matching Results
Search Results
Note: All results matching your query require you to be a member of the UNT Community (you must be on campus or login with university credentials for access).
- Development, Validation, and Evaluation of a Continuous, Real-time, Bivalve Biomonitoring System
- A biological monitoring tool to assess water quality using bivalve gape behavior was developed and demonstrated. The purpose of this work was to develop methodologies for screening water quality appropriate to the goals of the watershed paradigm. A model of bivalve gape behavior based on prediction of behavior using autoregressive techniques was the foundation of the bivalve biomonitoring system. Current technology was used in developing the system to provide bivalve gape state data in a continuous real-time manner. A laboratory version of the system, including data collection and analysis hardware and software, was developed for use as a toxicological assay for determination of effective concentrations of toxicant(s) or other types of stress on bivalve gape behavior. Corbicula fluminea was monitored and challenged with copper, zinc, and chlorpyrifos using the system. Effective concentrations of 176±23µg/L copper, 768±412µg/L zinc, and 68µg/L chlorpyrifos were observed using a natural water with high dissolved organic carbon concentrations. A rugged field version of the bivalve biomonitoring system was developed and deployed in two locations. The field systems were fitted with a photovoltaic array, a single board computer, and a CDPD telemetry modem for robust remote operation. Data were telemetered at a time relevant rate of once every ten minutes. One unit was deployed in Lake Lewisville, Denton County, TX in February 2000. Data were telemetered and archived at a 92% success rate. Bivalve gape data demonstrated significant behavioral deviations on average 5 times per month. A second unit was deployed in Pecan Creek, Denton, TX in June 2001. Data from this site were telemetered and archived at a 96% success rate. Over the months of June-August 2001, 16 significant behavioral deviations were observed, 63% of which were correlated with changes in physical/chemical parameters. This work demonstrated the relative sensitivity of bivalve gape as a toxicological endpoint …
- Integrating life cycle analysis and the ecological footprint calculator to foster sustainable behaviors
- Many tools have been developed to assess global, national or regional sustainable development policies. However, as governments develop sustainable policies, individuals must also feel empowered to affect their personal impact on the planet. This thesis integrates three sustainability concepts that lend themselves to individual sustainability: The natural step, life cycle assessment, and the ecological footprint. TNS serves to provide the meaning and substance toward sustainable development. LCA helps provide the framework for assessing sustainability. The EF calculator determines the driving components and measures the qualitative decisions made through TNS and LCA. From the analysis of the household footprint calculator a simplified footprint calculator was developed to assist individuals and communities in setting benchmarks and goals as they move away from over-consumption and towards a sustainable lifestyle.
- Phosphorus Retention and Fractionation in Masonry Sand and Light Weight Expanded Shale Used as Substrate in a Subsurface Flow Wetland
- Constructed wetlands are considered an inefficient technology for long-term phosphorus (P) removal. The P retention effectiveness of subsurface wetlands can be improved by using appropriate substrates. The objectives of this study were to: (i) use sorption isotherms to estimate the P sorption capacity of the two materials, masonry sand and light weight expanded shale; (ii) describe dissolved P removal in small (2.7 m3) subsurface flow wetlands; (iii) quantify the forms of P retained by the substrates in the pilot cells; and (iv) use resulting data to assess the technical and economic feasibility of the most promising system to remove P. The P sorption capacity of masonry sand and expanded shale, as determined with Langmuir isotherms, was 60 mg/kg and 971 mg/kg respectively. In the pilot cells receiving secondarily treated wastewater, cells containing expanded shale retained a greater proportion of the incoming P (50.8 percent) than cells containing masonry sand (14.5 percent). After a year of operation, samples were analyzed for total P (TP) and total inorganic P (TIP). Subsamples were fractionated into labile-P, Fe+Al-bound P, humic-P, Ca+Mg-bound P, and residual-P. Means and standard deviations of TP retained by the expanded shale and masonry sand were 349 + 169 and 11.9 + 18.6 mg/kg respectively. The largest forms of P retained by the expanded shale pilot cells were Fe+Al- bound P (108 mg/kg), followed by labile-P (46.7 mg/kg) and humic-P (39.8). Increases in the P forms of masonry sand were greatest in labile-P (7.5 mg/kg). The cost of an expanded shale wetland is within the range of costs conventional technologies for P removal. Accurate cost comparisons are dependent upon expansion capacity of the system under consideration. Materials with a high P sorption capacity also have potential for enhancing P removal in other constructed wetland applications such as stormwater wetlands and wetlands …
- Removal of selected water disinfection byproducts, and MTBE in batch and continuous flow systems using alternative sorbents.
- A study was conducted to evaluate the sorption characteristics of six disinfection byproducts (DBPs) on four sorbents. To investigate sorption of volatile organic compounds (VOCs), specially designed experimental batch and continuous flow modules were developed. The investigated compounds included: chloroform, 1,2-dichloroethane (DCE), trichloroethylene (TCE), bromodichloromethane (BDCM), methyl tertiary butyl ether (MTBE), bromate and bromide ions. Sorbents used included light weight aggregate (LWA), an inorganic porous material with unique surface characteristics, Amberlite® XAD-16, a weakly basic anion exchange resin, Amberjet®, a strongly basic anion exchange resin, and granular activated carbon (GAC). Batch experiments were conducted on spiked Milli-Q® and lake water matrices. Results indicate considerable sorption of TCE (68.9%), slight sorption of bromate ions (19%) and no appreciable sorption for the other test compounds on LWA. The sorption of TCE increased to 75.3% in experiments utilizing smaller LWA particle size. LWA could be a viable medium for removal of TCE from contaminated surface or groundwater sites. Amberlite® was found unsuitable for use due to its physical characteristics, and its inability to efficiently remove any of the test compounds. Amberjet® showed an excellent ability to remove the inorganic anions (>99%), and BDCM (96.9%) from aqueous solutions but with considerable elevation of pH. Continuous flow experiments evaluated GAC and Amberjet® with spiked Milli-Q® and tap water matrices. The tested organic compounds were sorbed in the order of their hydrophobicity. Slight elevation of pH was observed during continuous flow experiments, making Amberjet® a viable option for removal of BDCM, bromate and bromide ions from water. The continuous flow experiments showed that GAC is an excellent medium for removal of the tested VOCs and bromate ion. Each of the test compounds showed different breakthrough and saturation points. The unique design of the continuous flow apparatus used in the study proved to be highly beneficial to …