Search Results

open access

Intermediate Heat Exchanger Preliminary Design. Vol. 1, IHX Preliminary Design

Description: Preface: The intermediate heat exchanger is designed for operation in a nuclear power plant using liquid sodium as the primary and secondary coolant. Since the primary fluid coming from the reactor is radioactive, the purpose of the IHX is to transfer heat to a nonradioactive fluid which then goes to a steam generator. Because of this activity the until will be enclosed in a concrete pit and will not be accessible during periods of operation. Immediately after shut down it will be necessary … more
Date: February 28, 1959
Creator: Alco Products (Firm)
Partner: UNT Libraries Government Documents Department
open access

K [infinity] in Uranium - Water Lattices

Description: This report follows experiments on K[infinity], measuring the element for several red sizes, enrichments, and water-to-uranium volume ratios-(1, 2), by making use of the relation k[infinity] = 0M-[2]B-[2] (M-2 = migration area, B = buckling). The purpose of this report is to compare the experimental data for k[infinity] with values calculated from the four-factor formula k[infinity] = [eta][epsilon]pf.
Date: July 28, 1955
Creator: Auerback, T.
Partner: UNT Libraries Government Documents Department
open access

Tentative Procedures for Analysis of HCP Process Materials

Description: Abstract: The procedures recommended for analysis in Department 190 Laboratories, in the Limits Control Laboratory, and in the Analytical Development Laboratories, of all process materials from the HCP cycle are presented in a stepwise manner. A description of the characteristics of each sample type along with a brief description of factors involved in the Analytical Quality Control program is included.
Date: May 28, 1947
Creator: Belknap, Herbert J.; Nessle, G. J. & Grimes, W. R.
Partner: UNT Libraries Government Documents Department
open access

Hazards Report for SM-1 Core Temperature and Flow Instrumentation (Task XIV) Covering Special Test Procedures.

Description: Abstract: Test procedures for special tests involving in-core SM-1 temperature and flow instrumentation are described (Task XIV Package Tests). These tests involve in-core steady state flow and temperature measurements, loss of flow transients, load transients, reduced primary system pressure operations and reduced element flow. The thermal and hydraulic conditions prevailing in these tests, including steady state and transient burnout rations, are developed. The effects of reduced system pres… more
Date: February 28, 1962
Creator: Bradley, P. L. & Coombe, J. R.
Partner: UNT Libraries Government Documents Department
open access

Water Hammer Tests Loop Able Pwp Land Reactor, 1957

Description: "This report essentially substantiates the preliminary data reported ln WAPD-PWR-PMF-898. The Primary Coolant System of the Pressurized Water Reactor (PWR) at Shippingport, Pennsylvania, comprises four loops. Each of the loops has one pump to control the mass rate of water flow-. A series of tests were conducted on the cooling system of the PWR land reactor to determine the magnitude and duration of the water hammer pressure wave resulting from check valve closure. The water hammer pressure wav… more
Date: February 28, 1958
Creator: Brewer, G. A. & Wing, J. C.
Partner: UNT Libraries Government Documents Department
open access

Critical Ionization of Potentials of Uranium Hexafluoride

Description: Introduction: "The extensive use of uranium hexafluoride in the Nier-type mass spectrometers, where the ionization is produced by slow electrons, made a knowledge of the ionization potentials of the various ions desirable. This information was not available and work was accordingly begun to secure such data. The first measurement was made with a VGIA ion gauge and has been described in TEO report CD-310. With this apparatus it was not possible to identify the ionization products and it was pres… more
Date: November 28, 1955
Creator: Cameron, Angus Ewan, 1906- & White, J. R.
Partner: UNT Libraries Government Documents Department
open access

Response of Protective Vaults to Blast Loading

Description: A reinforced-concrete steel-plate-lined vault and steel vault door were exposed to a nuclear detonation (shot Priscilla, about 37 kt, balloon suspended, at 700 ft) at the predicted 75-psi peak incident pressure level (1150 ft from Ground Zero). The vault was designed by the ultimate-strength theory to utilize the additional strain energy available in the elastoplastic and plastic ranges. Flexural and thrust capacities were determined, and shear capacity was computed. It was established that abo… more
Date: May 28, 1962
Creator: Cohen, Edward; Laing, E. & Bottenhofer, A.
Partner: UNT Libraries Government Documents Department
open access

An Ion Exchange Study of Possible Hybridized 5f Bonding in the Actinides

Description: A study was conducted on the elution behavior of curium (III), americium (III), plutonium (III), actinium (III), plutonium (IV), neptunium (IV), uranium (IV), thorium (IV), neptunium (V), plutonium (VI), uranium (VI), lanthanum (III), cerium (III), europium (III), ytterbium (III), ytterium (III), strontium (II), barium (II), radium (II), cesium (I) with 3.2 M, 6.2 M, and 12.2 M HCI solutions from Dower-50 cation exchange resin columns. These elutions show that in high concentrations of hydroch… more
Date: August 28, 1951
Creator: Diamond, R. M.; Street, K., Jr. & Seaborg, Glenn T. (Glenn Theodore), 1912-1999
Partner: UNT Libraries Government Documents Department
open access

Digestion and Filtration of Leached Zone in Pilot Plant

Description: Introduction: The present report summarizes pilot plant operations on the sulfuric acid digestion of -200 mesh leached zone and filtration of the digested slurry for the period May 5, 1952 through August 7, 1953.
Date: February 28, 1955
Creator: Dugger, Gordon L.; Adams, J. B. & Bart, Roger
Partner: UNT Libraries Government Documents Department
open access

Wall and Bulk Temperatures for Fluids Flowing in Concentric Annuli

Description: From introduction: "This brief paper deals with the subject of radial temperature differences for heat transfer to fluids flowing through concentric annuli under the following conditions and assumptions: a. constant heat flux; b. fully-established turbulent flow; c. heat transfer through inner wall only; d. physical properties independent of temperature."
Date: May 28, 1962
Creator: Dwyer, Orrington Embry, 1912-
Partner: UNT Libraries Government Documents Department
open access

Multiplication of Enriched Loading in Exponential Pile

Description: This report refutes earlier calculations made in the flux level of exponential piles. The results of the earlier calculations made on subcritical assemblies using critical assembly equations are in error. The calculations used in this report were more successful.
Date: September 28, 1953
Creator: Farrand, W. B. & Lloyd, R. C.
Partner: UNT Libraries Government Documents Department
open access

High Energy Proton Spallation--Fission of Uranium

Description: The fission and spallation reactions caused in uranium by bombardment with high energy protons (340 to 350 Mev) were investigated. The reaction products were separated from the target by chemical processes and identified by their radioactive properties. The relative yields of the observed fission products were measured, and the results plotted as a function of mass number. Several of the spallation products were identified and their yields estimated.
Date: May 28, 1951
Creator: Folger, R. L.; Stevenson, P. C. & Seaborg, Glenn T. (Glenn Theodore), 1912-1999
Partner: UNT Libraries Government Documents Department
open access

Metallurgy Division Quarterly Progress Report for Period Ending January 31, 1952

Description: This quarterly progress report describes the ongoing research at the Metallurgy Division at the Oak Ridge National Laboratory. In particular, this report discusses the thorium research program, the slug problem, the preferred orientation and anisotropy in metals, fundamental studies of alloying, and the ANP program.
Date: August 28, 1952
Creator: Frye, John H., Jr., 1908-2001 & Bridges, W. H.
Partner: UNT Libraries Government Documents Department
open access

Patent of Invention--Gr 5--Cl.3--Bearing

Description: The object of this invention is a bearing: a thrust bearing. This bearing is one in which the bearing faces is a continuous annular surface and the other an annular surface divided into shoes having the form of sectors.
Date: October 28, 1925
Creator: Fulpius, Edward
Partner: UNT Libraries Government Documents Department
Back to Top of Screen