3 Matching Results

Search Results

Advanced search parameters have been applied.

Basic Engineering Research for D and D of R Reactor Storage Pond Sludge: Electrokinetics, Carbon Dioxide Extraction, and Supercritical Water Oxidation

Description: Large quantities of mixed low level waste (MLLW) that fall under the Toxic Substances Control Act (TSCA) exist and will continue to be generated during D and D operations at DOE sites across the country. The standard process for destruction of MLLW is incineration, which has an uncertain future. The extraction and destruction of PCBs from MLLW was the subject of this research Supercritical Fluid Extraction (SFE) with carbon dioxide with 5% ethanol as cosolvent and Supercritical Waster Oxidation (SCWO) were the processes studied in depth. The solid matrix for experimental extraction studies was Toxi-dry, a commonly used absorbent made from plant material. PCB surrogates were 1.2,4-trichlorobenzene (TCB) and 2-chlorobiphenyl (2CBP). Extraction pressures of 2,000 and 4,000 psi and temperatures of 40 and 80 C were studied. Higher extraction efficiencies were observed with cosolvent and at high temperature, but pressure little effect. SCWO treatment of the treatment of the PCB surrogates resulted in their destruction below detection limits.
Date: April 1, 2002
Creator: Matthews, Michael A.; David A. Bruce,; Davis, Thomas A.; Thies, Mark C.; Weidner, John W. & White, Ralph E.
Partner: UNT Libraries Government Documents Department

Passive damping in EDS maglev systems.

Description: There continues to be strong interest in the subjects of damping and drag forces associated with electrodynamic suspension (EDS) systems. While electromagnetic drag forces resist the forward motion of a vehicle and therefore consume energy, damping forces control, at least in part, the response of the vehicle to disturbances. Ideally, one would like to reduce the drag forces as much as possible while retaining adequate damping forces to insure dynamic stability and satisfactory ride quality. These two goals turn out to be difficult to achieve in practice. It is well known that maglev systems tend to be intrinsically under damped. Consequently it is often necessary in a practical system design to enhance the damping passively or actively. For reasons of cost and simplicity, it is desirable to rely as much as possible on passive damping mechanisms. In this paper, rough estimates are made of the passive damping and drag forces caused by various mechanisms in EDS systems. No attention will be given to active control systems or secondary suspension systems which are obvious ways to augment passive damping mechanisms if the latter prove to be inadequate.
Date: May 3, 2002
Creator: Rote, D. M.
Partner: UNT Libraries Government Documents Department

Electrodynamics at the highest energies

Description: At very high energies, the bremsstrahlung and pair production cross sections exhibit complex behavior due to the material in which the interactions occur. The cross sections in dense media can be dramatically different than for isolated atoms. This writeup discusses these in-medium effects, emphasizing how the cross section has different energy and target density dependencies in different regimes. Data from SLAC experiment E-146 will be presented to confirm the energy and density scaling. Finally, QCD analogs of the electrodynamics effects will be discussed.
Date: June 17, 2002
Creator: Klein, Spencer R.
Partner: UNT Libraries Government Documents Department