192 Matching Results

Search Results

Advanced search parameters have been applied.
in creator/contributor: "Langley Aeronautical Laboratory"  
Results: 1 - 24 next
open access

Pressure-Distribution Measurements of a Model of a Davis Wing Section with Fowler Flap Submitted by Consolidated Aircraft Corporation

Description: Wing pressure distribution diagrams for several angles of attack and flap deflections of 0 degrees, 20 degrees, and 40 degrees are presented. The normal force coefficients agree with lift coefficients obtained in previous test of the same model, except for the maximum lifts with flap deflection. Pressure distribution measurements were made at Reynolds Number of about 6,000,000.
Date: January 1942
Creator: Abbott, Ira H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Pressure-distribution measurements of two airfoil models with Fowler flaps submitted by Consolidated Aircraft Corporation as alternative wing sections of the XB-32 airplane

Description: Report presenting pressure distribution measurements on two 24-inch chord models equipped with Fowler flaps in the two-dimensional low-turbulence pressure tunnel. Results regarding pressure-distribution diagrams and normal-force and moment coefficients are provided.
Date: January 1942
Creator: Abbott, Ira H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Pressure-Distribution Measurements of a Low-Drag Airfoil With Slotted Flap Submitted by Curtiss-Wright Corporation

Description: "Pressure-distribution measurements were made at the request of the Materiel Division, U.S. Army Air Corps, on a 24-inch-chord wooden model equipped with a slotted flap and submitted by the Curtiss-Wright Corporation. The tests were made in the Langley two-dimensional tunnel at a Reynolds number of about 5,600,000" (p. 1).
Date: December 1941
Creator: Abbott, Ira H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Some Flight Measurements on Pressure Distribution During Tail Buffeting

Description: Report presenting pressure-distribution measurements obtained from the horizontal tail surfaces of the Curtiss P-40K airplane during low-speed pull-ups to abrupt stall in which tail buffeting was experienced. The chordwise load distributions during buffeting are similar to those experienced during angle-of-attack changes. The location of the stall and frequency of stall disturbances are also described.
Date: October 1945
Creator: Boshar, John
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Flutter tests of B-34 fin-rudder-tab system

Description: From Summary: "Tests on the B-34 fin-rudder-tab assembly were performed in the NACA 8-foot high-speed tunnel. Two cases of tab flutter were studied. It was shown conclusively that the frequency of the original or heavy tab was too low and caused coupling with one of the lower bending frequencies. A general conclusion was made that the tab frequency should be considerably higher than the lower modes of the fin-rudder assembly because there is generally a weaker coupling between the tab and the h… more
Date: September 1944
Creator: Theodorsen, Theodore
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Flight tests of various tail modifications on the Brewster XSBA-1 airplane 3: measurements of flying qualities with tail configuration 3

Description: Report presenting a series of tests on the Brewster XSBA-1 airplane to determine the effects of various tail modifications. Some of the modifications include variations of the chord of the elevator and rudder while the span and total area of the surfaces are kept constant and variations of the total area of the vertical tail surface. Results regarding the longitudinal stability and control and lateral stability and control are provided.
Date: July 1944
Creator: Crane, H. L. & Reeder, J. P.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Wind-tunnel investigation of an NACA 23012 airfoil with a 30 percent chord Maxwell slate and with trailing-edge flaps

Description: Report presenting an investigation in the 7- by 10-foot wind tunnel of an NACA 23012 airfoil with a 30 percent-chord Maxwell leading-edge slat and a slotted and a split flap. The main purpose was to determine the optimum slot cap of the Maxwell slat for, and the aerodynamic section characteristics of, the airfoil with several deflections for both types of flaps. Curves of lift, drag, and pitching-moment characteristics for optimum arrangements are provided.
Date: June 1941
Creator: Lowry, John G. & McKee, John W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Wind-tunnel investigation of an NACA 23012 airfoil with an 18.05 percent chord Maxwell slat and with trailing-edge flaps

Description: Report presenting an investigation in the 7- by 10-foot wind tunnel of an NACA 23012 airfoil with an 18.05-percent-chord Maxwell leading-edge slat and with a slotted and a split flap. The main purpose of the investigation was to determine the optimum slot gap of the Maxwell slat for, and the aerodynamic section characteristics of, the airfoil with several deflections of both types of flap.
Date: October 1941
Creator: McKee, John W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Airfoil Section Data From Tests of 10 Practical-Construction Sections of Helicopter Rotor Blades Submitted by the Sikorsky Aircraft Division, United Aircraft Corporation

Description: Report presenting 10 practical-construction models of sections of helicopter rotor blades tested in the NACA two-dimensional low-turbulence pressure tunnel at atmospheric pressure. Lift, drag, and pitching-moment characteristics of blades representing the present method of construction of the YR-4A helicopter were determined.
Date: September 1944
Creator: Tetervin, Neal
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Drag measurements at high Reynolds numbers of a 100-inch-chord NACA 23016 practical construction wing section submitted by Chance Vought Aircraft Company

Description: Report presenting drag measurements in the two-dimensional low-turbulence tunnel of an available 100-inch-chord model of the NACA 23016 wing section. Results regarding the curves of section drag coefficient plotted against Reynolds number for various surface conditions and lift coefficients, variation of drag coefficient with lift coefficient, and effects of skin friction are provided.
Date: June 1944
Creator: von Doenhoff, Albert E. & Nuber, Robert J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Estimates of the Vertical-Tail Loads of a Bell P-63A-1 Airplane (AAF No. 42-68889) in Accelerated Rolling Maneuvers Based on Flight Tests With Two Vertical-Tail Arrangements

Description: Report discussing the results of using an enlarged vertical tail on a P-63A-1 on directional stability. The tests included measurements of the amount of sideslip at various speeds and normal accelerations. Potential required modifications for increased performance using the larger tail are also described.
Date: November 30, 1944
Creator: Johnson, Harold I.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Vibration Surveys of the P-40 Rudder and Fin-Rudder Assembly

Description: "The following surveys on the vibration response of the P-40 rudder and fin-rudder assembly were conducted during the fall of 1942 for the purpose of obtaining information on the flutter characteristics of high-speed airplanes of known performance. The tests on the rudder alone were made with the rudder suspended in a floating condition; the tests on the fin-rudder unit were made with the fin rigidly fastened to a concrete base" (p. 1). A variety of figures and diagrams for the assembly are pro… more
Date: April 1943
Creator: Theodorsen, Theodore & Regier, Arthur A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Flight Tests of a Rudder With a Spring Tab on an F6F-3 Airplane (BuAer No.04776)

Description: Report discussing testing on an F6F-3 with a spring-tab rudder to determine the directional stability and control characteristics. Using the spring-tab rudder was found to result in lower trim-force change with speed and lower pedal forces in sideslips than the original rudder. Pilots were found to prefer the maneuverability of this configuration.
Date: March 1945
Creator: Williams, Walter C.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Preliminary Vibration and Flutter Studies on P-47 Tail

Description: Report presenting a report illustrated by photographs and vibration records on the failure of the P-47 rudder in the high-speed tunnel at a true speed of 468 miles per hour and a density corresponding to 9000 feet altitude. The fin-rudder unit was tested as being at least representative of the tail design of the P-47 airplane.
Date: August 1943
Creator: Theodorsen, Theodore
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Vibration Surveys of the P-47-B Rudder and Fin-Rudder Assembly

Description: Report presenting a study of the flutter characteristics of the P-47 tail assembly, which included replacing the original fabric-covered rudder with a metal-covered rudder and reinforcing the fin. Figures are provided for different configurations and the cycles per second under the same conditions are provided.
Date: April 1943
Creator: Theodorsen, Theodore & Regier, Arthur A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Flight Investigation of Modifications to Improve the Elevator Control-Force Characteristics of the Curtiss SB2C-1C Airplane in Maneuvers

Description: Report discussing tests on three sets of elevators with various combinations of section contour, balancing tabs, bobweights, and control-system mechanical advantage on an SB2C-1C airplane. Effects on maneuvering stability, a comparison of production elevators and recommended arrangement, and internal elevator pressures are described.
Date: April 1945
Creator: White, Maurice D. & Reeder, John P.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

The Aerodynamic Tests of Three Edo Floats for the SB2U-3, 0S2U-2, and XSB2C-2 Seaplanes - NACA Models 106-K, 107-K, and 125-AH

Description: Report presenting aerodynamic testing of scale models of the Edo seaplane floats for the SB2U-3, OS2U-2, and XSB2C-2 seaplanes. Various coefficients, pitching moment, yawing moment, and drag coefficients are provided.
Date: March 1942
Creator: Liddell, Robert B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Flight tests of beveled-trailing-edge ailerons with various modifications on a North American XP-51 airplane (AAF No.41-38)

Description: Report presenting flight testing using a North American XP-51 airplane with several arrangements of beveled-trailing-edge ailerons to determine the most satisfactory arrangement. Results regarding the aileron configuration, trimming tabs, and factors affecting symmetry of aileron characteristics are provided.
Date: December 1943
Creator: White, Maurice D. & Hoover, Herbert H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Wind-Tunnel Investigation of a Beveled Aileron Shape Designed to Increase the Useful Deflection Range

Description: Report presenting a wind tunnel investigation of a beveled aileron shape designed to increase the useful deflection range. The purpose of the investigation was to determine the general aerodynamic characteristics of this aileron and, in particular, to determine its useful angular range. Results regarding the effect of the hinge-gap seal, the surface condition and Reynolds number, and effect of aileron profile are provided.
Date: April 1944
Creator: Jones, R. T. & Underwood, W. J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Tests of a 0.1475c Aileron With a Tab on Low-Drag Section for Curtiss XP-60 Airplane in the Low-Turbulence Tunnel

Description: "Preliminary two-dimensional tests of the hinge-moment characteristics of a 0.1725c internally balanced aileron on the subject XP-60 wing section indicated that more internal balance would be required if light stick forces were to be obtained at high speeds. The present series of tests were therefore undertaken in order to investigate methods of reducing the slope of the hinge-moment curve while still maintaining the required aileron effectiveness" (p. 1).
Date: November 1941
Creator: von Doenhoff, A. E. & Underwood, W. J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Two-Dimensional Wind-Tunnel Investigation of Spoiler Aileron Flap Model for the Hughes XF-11 Airplane

Description: Report discussing testing on a retractable spoiler aileron on the NACA 66(215)-216 airfoil with a 25-percent-chord slotted flap. The effects of spoiler thickness, spoiler gap, spoiler bevel angle, spoiler roughness, and flap deflection on aerodynamic characteristics are described.
Date: April 1945
Creator: Underwood, William J. & Fullmer, Felicien F., Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Measurement of Individual Aileron Hinge Moments and Aileron Control Characteristics of a P-40F Airplane

Description: "Flight measurements have been made of the individual aileron hinge moments, aileron rolling effectiveness pb/2V ,and stick-force characteristics in abrupt aileron rolls with a P-40F airplane (AAF No. 41-14119) over an indicated airspeed range from 108 to 304 miles per hour. Three methods for measuring the rate of change of hinge moment with angle of attack were investigated. Presented for comparison with the flight results are data from two-dimensional wind-tunnel tests of the wing-aileron pro… more
Date: January 29, 1945
Creator: Goranson, R. Fabian
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

An Investigation of the Mutual Interference Effects of a Tail-Surface: Stern Propeller Installation on a Model Simulating the Douglas XB-42 Empennage

Description: Report discussing the mutual interference effects of tail surfaces and a stern propeller on a model of the XB-42.The main focus was to determine the effect of tail surface-propeller spacing upon the periodic tail surface loading coincident with propeller blade passage.
Date: November 9, 1944
Creator: Bartlett, Walter A., Jr. & Marino, Alfred A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen