5 Matching Results

Search Results

Bibliography and Index on Vacuum and Low Pressure Measurement

Description: From Introduction: "This paper consists essentially of a) a bibliography, b) an author index, and c) an index of the subject matter of the bibliography. While the primary objective is to focus on vacuum measurement, it was believed essential to include in the bibliography articles on vacuum technology in some measure accessory or essential to vacuum measurement. For maximum usefulness, an index of the subject matter of the references has been prepared. The abstract publications listed in the previous paragraph have been freely drawn upon in preparing the bibliography."
Date: November 10, 1961
Creator: Brombacher, W. G.
Partner: UNT Libraries Government Documents Department

Bibliography and Index on Vacuum and Low Pressure Measurement, January 1960 to December 1965

Description: From Abstract: "The bibliography, a supplement to NBS Monograph 35, of the same title, covers the years 1960 to 1965, inclusive, and include 109 references for prior years not listed in Monograph 35. It contains 1787 references, 38 of which are to books. The references, besides those directly concerned with pressure measurement, include those on vacuum technology which may bear on the technique of vacuum measurement, such as on adsorption and desorption, diffusion of gases into solids, gas conductance and hardware such as pumps, seals and traps."
Date: May 31, 1967
Creator: Brombacher, W. G.
Partner: UNT Libraries Government Documents Department

Evaporation of Iron-, Nickel-, and Cobalt-Base Alloys at 760 to 980°C in High Vacuums

Description: Report issued by the Oak Ridge National Laboratory discussing the evaporation of alloys in high vacuums. As stated in the introduction, "the investigation encompasses measurements of the evaporation rates, identification of the evaporating elements, and correlation of these measurements to the alloy composition for specimens in both the polished and oxidized conditions" (p. 2). This report includes tables, illustrations, and photographs.
Date: November 1964
Creator: Bourgette, D. T.
Partner: UNT Libraries Government Documents Department

Effect of Explosive Impacting on Uranium

Description: Abstract: The tensile and yield strengths of both cast and wrought uranium discs were substantially increased by explosively impacting them at room temperature and at 375 deg F. However, the room-temperature impacting caused gross damage in the cast material and slight internal damage in the wrought material at the highest impacting pressures. Impacting at 375 deg F, which is just above the brittle-ductile transition temperature for uranium, was the most effective method for increasing the strengths with no damage to either the cast or wrought material. This impacted material retained some of its increased strength after a low temperature (425 deg C) vacuum anneal that greatly increased the elongation. A salt anneal caused a partial recrystallization in the impacted cast uranium. (auth).
Date: April 23, 1964
Creator: Burditt, R. B.; Carey, W. T. & Coughlen, C. P.
Partner: UNT Libraries Government Documents Department