Search Results

Advanced search parameters have been applied.
open access

De-entrainment on vertical elements in air droplet cross flow. [PWR]

Description: De-entrainment phenomena on vertical elements in air-water droplet cross flow are generated using a horizontal array of water spray nozzles and a draft-induced wind tunnel. These conditions are used to obtain experimental values of the de-entrainment efficiency of isolated elements (25.4-, 63.5-, and 101.6-mm-diam cylinders and a 76.2-mm-square tube), and of an array of 101.6-mm-diam cylinders. A flow model is developed that extrapolates the de-entrainment efficiency of isolated elements throug… more
Date: January 1, 1980
Creator: Dallman, J.C. & Kirchner, W.L.
Partner: UNT Libraries Government Documents Department
open access

SPXCPL: two-dimensional modeling program of self-potential effects from cross-coupled fluid and heat flow (User's Guide and documentation for Version 1. 0)

Description: The program is applicable to the calculation of self-potential effects due to fluid flow (electrokinetic effects) and heat flow (thermoelectric effects). The geological structure is two dimensional but the sources can be either finite line sources or point sources. The accuracy of the calculated potentials depends on the model discretization and the distance from the source(s). For the default mesh, the accuracy is usually a few percent at a distance of about one unit from the source. Surface b… more
Date: March 1, 1982
Creator: Sill, W. R. & Killpack, T. J.
Partner: UNT Libraries Government Documents Department
open access

Establishment of viscometer capability for geopressured fluids. Project 61024 final report, November 19, 1978-December 31, 1979

Description: The feasibility of modifying the IGT capillary viscometer for the measurement of methane-saturated brines at 10,000 psi and 200/sup 0/C was evaluated. The viscometer was cleaned, modified, reassembled and pressure treated. The density cells were calibrated to a precision of approximately 7%. The viscosity of pure value was measured and the best value obtained was 6% below values reported in the literature. The operation of the viscometer was time-consuming and required meticulous cleaning betwe… more
Date: October 1, 1980
Creator: Rockar, E. & Randolph, P.
Partner: UNT Libraries Government Documents Department
open access

SCORE-EVET: a computer code for the multidimensional transient thermal-hydraulic analysis of nuclear fuel rod arrays. [BWR; PWR]

Description: The SCORE-EVET code was developed to study multidimensional transient fluid flow in nuclear reactor fuel rod arrays. The conservation equations used were derived by volume averaging the transient compressible three-dimensional local continuum equations in Cartesian coordinates. No assumptions associated with subchannel flow have been incorporated into the derivation of the conservation equations. In addition to the three-dimensional fluid flow equations, the SCORE-EVET code ocntains: (a) a one-… more
Date: February 1, 1978
Creator: Benedetti, R. L.; Lords, L. V. & Kiser, D. M.
Partner: UNT Libraries Government Documents Department
open access

Energy Program annual report

Description: The national economy is particularly dependent on efficient electrical generation and transportation. Electrical demand continues to grow and will increasingly rely on coal and nuclear fuels. The nuclear power industry still has not found a solution to the problem of disposing of the waste produced by nuclear reactors. Although coal is in ample supply and the infrastructure is in place for its utilization, environmental problems and improved conversion processes remain technical challenges. In … more
Date: February 1, 1988
Creator: Borg, I.Y. (ed.)
Partner: UNT Libraries Government Documents Department
open access

Adaptive Mesh Refinement for 1-Dimensional Gas Dynamics

Description: We consider the solution of the one-dimensional equation of gas-dynamics. Accurate numerical solutions are difficult to obtain on a given spatial mesh because of the existence of physical regions where components of the exact solution are either discontinuous or have large gradient changes. Numerical methods treat these phenomena in a variety of ways. In this paper, the method of adaptive mesh refinement is used. A thorough description of this method for general hyperbolic systems is given else… more
Date: 1982-08~
Creator: Hedstrom, Gerald; Rodrigue, Garry; Berger, Marsha & Oliger, Joseph
Partner: UNT Libraries Government Documents Department
open access

Coolant mixing in LMFBR rod bundles and outlet plenum mixing transients. Progress report, December 1, 1979-February 29, 1980

Description: Information is presented concerning bundle geometry with wrapped and bare rods; LMFBR outlet plenum flow mixing; and theoretical determination of local temperature fields in LMFBR fuel rod bundles.
Date: January 1, 1980
Creator: Todreas, N.E.; Golay, M.W. & Wolf, L.
Partner: UNT Libraries Government Documents Department
open access

State-of-the-art for evaluating the potential impact of flooding on a radioactive waste repository

Description: This report is a review of the state-of-the-art for evaluating the potential impact of flooding on a deep radioactive-waste repository, namely, for predicting the future occurrence of catastrophic flooding and for estimating the effect of such flooding on waste containment characteristics. Several detrimental effects are identified: flooding can increase groundwater seepage velocities through a repository within the framework of the existing hydrologic system and thus increase the rate of radio… more
Date: July 16, 1980
Partner: UNT Libraries Government Documents Department
open access

Pressure losses in fracture-dominated reservoirs: the wellbore constriction effect

Description: Improved energy production from many types of energy reservoirs such as hot dry rock geothermal as well as hydraulically fractured oil, gas, and other geothermal reservoirs requires a better understanding of the fluid mechanics in the vicinity of the fracture-wellbore intersection. Typically, the aperture (smallest dimension) of a hydraulic fracture is only of the order of 1 mm (0.04 in.) so that reasonable energy production rates from geothermal systems require fairly large flow velocities wit… more
Date: January 1, 1980
Creator: Murphy, H.
Partner: UNT Libraries Government Documents Department
open access

The collaborative program of research in engineering sciences

Description: Research programs in the following areas are briefly described: High-Temperature Gas-Particle Reactions; Mathematical Modelling of Plasma Systems; Metal Transfer in Gas Metal-Arc Welding; Multivariable Control of Gas Metal-Arc Welding; Synthesis of Heat and Work Integration Systems for Chemical Process Plants; Parity Simulation of Dynamic Processes; Fundamentals of Elastic-Plastic Fracture: Three-Dimensional and Mechanistic Modelling; and Comminution of Energy Materials. Publications from each … more
Date: August 1, 1989
Creator: White, D.C.
Partner: UNT Libraries Government Documents Department
open access

LLL total flow geothermal program: summary of two-phase nozzle tests for scale control and materials performance

Description: A series of nozzle and wearblade tests to evaluate scale control and materials performance under total flow nozzle inlet conditions and simulated turbine blade environments was completed using Magmamax No. 1 well fluid. Brine acidification was effective in preventing scale in nozzles and on wearblade flow surfaces. Acid consumption measurements indicate that acid cost will be less than 2 mills/100 lb. brine. Measured erosion rates were low and the results indicate that available materials will … more
Date: December 1, 1977
Creator: Tardiff, G.E. (ed.)
Partner: UNT Libraries Government Documents Department
open access

A semi-analytical method for heat sweep calculations in fractured reservoirs

Description: An analytical approximation is developed for purely conductive heat transfer from impermeable blocks of rock to fluids sweeping past the rocks in fractures. The method was incorporated into a multi-phase fluid and heat flow simulator. Comparison with exact analytical solutions and with simulations using a multiple interacting continua approach shows very good accuracy, with no increase in computing time compared to porous medium simulations. 14 refs., 3 figs., 5 tabs.
Date: January 1, 1988
Creator: Pruess, K. & Wu, Y.S.
Partner: UNT Libraries Government Documents Department
open access

Analytical model for a vertical buoyant jet

Description: An analytical model for a round and two-dimensional turbulent buoyant jet which is discharged vertically into a stagnant ambient is developed. The buoyant jet is considered to have three separate zone models which are matched to form a complete solution. The velocity field is determined for the entire jet and plume regions by the use of an eddy viscosity which varies along the axis of the jet. The centerline decay of buoyancy is determined throughout and the results are compared to existing num… more
Date: October 1, 1980
Creator: Lee, D. W.
Partner: UNT Libraries Government Documents Department
open access

FLOWTRAN benchmarking with onset of flow instability data from 1988 Columbia University single-tube OFI experiment

Description: Benchmarking FLOWTRAN, Version 16.2, with an Onset of Significant Voiding (OSV) criterion against measured Onset of Flow Instability (OFI) data from the 1988--89 Columbia University downflow tests has shown that FLOWTRAN with OSV is a conservative OFI predictor. Calculated limiting flow rates based on the Savannah River Site (SRS) OSV criterion were always higher than the measured flow rates at OFI. This work supplements recent FLOWTRAN benchmarking against 1963 downflow tests at Columbia Unive… more
Date: June 1, 1990
Creator: Chen, K.; Paul, P. K. & Barbour, K. L.
Partner: UNT Libraries Government Documents Department
open access

Evaluation of proposed designs for streamflow monitoring structures at waste disposal sites

Description: Design of small surface water monitoring stations associated with waste sites requires an approach that balances several problems. The monitoring site must have a capacity for a wide range of flows, allow accurate measurements over the full performance range, minimize effects from accumulation of contaminated sediments, and minimize costs of construction and operation. Selecting a station design that takes these factors into consideration can be done systematically through use of formal decisio… more
Date: January 1, 1991
Creator: Clapp, R. B.; Borders, D. M.; Tardiff, M. F. & Huff, D. D.
Partner: UNT Libraries Government Documents Department
open access

FY 90 annual research plan

Description: The National Institute for Petroleum and Energy Research (NIPER) was established by the DOE to perform contract research for government and industrial clients. The emphasis of the DOE program is immediate near- and mid-term concerns of domestic oil and gas producibility. Its primary purpose is to improve the fundamental understanding of domestic oil and gas resources and the chemical, physical, and biological phenomena that govern the occurrence and recovery of these resources in addition to th… more
Date: January 1, 1990
Partner: UNT Libraries Government Documents Department
open access

Two-phase flow studies. Final report

Description: Progress on the following is reported: literature survey, design of two-phase flow testing facility, design of nozzle loop, thermophysical properties, design manual, and advanced energy conversion systems. (MHR)
Date: August 1, 1980
Creator: Kestin, J. & Maeder, P. F.
Partner: UNT Libraries Government Documents Department
open access

Permeability damage to natural fractures caused by fracturing fluid polymers

Description: Formation damage studies using artificially fractured, low-permeability sandstone cores indicate that viscosified fracturing fluids can severely restrict gas flow through these types of narrow fractures. These studies were performed in support of the Department of Energy's Multiwell Experiment (MWX). Extensive geological and production evaluations at the MWX site indicate that the presence of a natural fracture system is largely responsible for unstimulated gas production. The laboratory format… more
Date: April 1, 1988
Creator: Gall, B. L.; Sattler, A. R.; Maloney, D. R. & Raible, C. J.
Partner: UNT Libraries Government Documents Department
open access

Coarse-node computations with an adaptive node structure

Description: The analysis with COMMIX of liquid metal reactor (LMR) intermediate heat exchanger (IHX) transients that are characterized by low flows, and especially imbalanced low flows, shows that if a coarse-node structure is used the predicted temperatures are significantly different than those given by a fine-node structure. If a fine-node structure is used, for problems that involve a large part of the plant, the computation time becomes excessive. This paper presents an improved version of an adaptive… more
Date: January 1, 1988
Creator: Tzanos, C.P.
Partner: UNT Libraries Government Documents Department
open access

Complex temporal and spatial patterns in nonequilibrium systems

Description: Dynamical systems methods are being developed and used to characterize the formation and evolution of temporal and spatial patterns in systems maintained far from equilibrium. In particular, experiments and analyses are considering electrodeposition of fractal metallic clusters, pattern formation in reaction-diffusion systems, and the primary instabilities of some fluid flows. Novel reactors have been developed to search for chemical patterns (spatial variations in the chemical composition), an… more
Date: September 1, 1991
Creator: Swinney, H. L.
Partner: UNT Libraries Government Documents Department
open access

Kilowatt Isotope Power System: component report for the Ground Demonstration System Accumulator

Description: The Model Number ORC1A3A01 System Accumulator for the Kilowatt Isotope Power System was expulsion tested and demonstrated to be in compliance with the requirements of Sundstrand Explusion Test Procedure, TP 400. Test requirements of TP 400 were extracted from the Kilowatt Isotope Power System, Ground Demonstration System Test Plan.
Date: January 31, 1978
Creator: Brainard, E.L.
Partner: UNT Libraries Government Documents Department
open access

Feasibility demonstration of the Sperry down-well pumping system. Final report

Description: Advantages of down-well pumping (vs. free-flowing) of geothermal hot-water wells are presented, and criteria for such a system are discussed. The main body of the report is presented under the following section headings: the Sperry down-well pumping system; field test program; field operations; test results; and, conclusions and recommendations. The appendix includes a summary of boiler heat transfer and pressure drop calculations. (JGB)
Date: May 1, 1977
Partner: UNT Libraries Government Documents Department
Back to Top of Screen