Search Results

open access

The Knock-Limited Performance of S Reference Fuel Plus 2 Milliliters of Triethylthallium Per Gallon

Description: Report discusses the results of testing of thallium as an antiknock agent in an internal-combustion engine. From Introduction: "On a weight basis, the thallium vapors were found to have several times the antiknock value of tetraethyl lead, which was added to the fuel. The amount of thallium vapor necessary to raise the antiknock properties of a gasoline up to exact equivalence with a benzol-gasoline mixture was determined in these engine tests."
Date: November 1945
Creator: Meyer, Carl L.
Partner: UNT Libraries Government Documents Department
open access

Emergency Measures for Increasing the Range of Fighter Airplanes

Description: "An analysis was made to show the relative effectiveness of streamline external fuel tanks, a fuel tank in the form of a wing mounted in a biplane position, and auxiliary wing panels attached at the wing tips to increase the span as temporary means for increasing the range of a fighter-type airplane. Figures and charts for the various devices considered show the results of calculations of range, duration of flight, and take-off distance for both land-base and carrier operation. The results indi… more
Date: May 1943
Creator: Jones, Robert T. & Wetmore, Joseph W.
Partner: UNT Libraries Government Documents Department
open access

Fuel-Evaporation Loss as Determined by the Change in the Specific Gravity of the Fuel in an Aircraft Fuel Tank

Description: Report discusses the results of an investigation to determine the feasibility of using the change in the specific gravity of fuels in aircraft fuel tanks to measure fuel-vaporization loss. Six fuels were tested via fuel-distillation tests and simulated-flight tests. An equation based on the specific gravity of the fuel is also described.
Date: May 1945
Creator: Stone, Charles S. & Kramer, Walter E.
Partner: UNT Libraries Government Documents Department
open access

The Use of Geared Spring Tabs for Elevator Control

Description: Report discussing the use of two types of geared spring tabs for elevator control: ordinary (or ungeared) spring tabs and geared spring tabs. Their use in airplanes of various sizes and in comparison to conventional control systems is described.
Date: February 1945
Creator: Phillips, William H.
Partner: UNT Libraries Government Documents Department
open access

Flight Investigation at High Mach Numbers of Several Methods of Measuring Static Pressure on an Airplane Wing

Description: Report discusses an investigation into static pressures in subsonic and supersonic flow over an airplane wing as measured by static-pressure tubes, a static-pressure belt, and orifices flush with the wing surface. The results obtained from the three types of measuring devices and a comparison to theoretical calculations are presented.
Date: November 1944
Creator: Zalovcik, John A. & Daum, Fred L.
Partner: UNT Libraries Government Documents Department
open access

Calculation of tab characteristics for flight conditions from wind-tunnel data

Description: Report presenting tail-surface characteristics calculated from wind-tunnel data, which have been reported to not correspond with flight-test measurements. The primary problem under consideration is the calculation of the effect of tab deflection on the free-floating angle of the elevator, as in a servocontrol.
Date: April 1942
Creator: Sears, Richard I.
Partner: UNT Libraries Government Documents Department
open access

Some Effects of Propeller Operation on the Distribution of the Load on the Vertical Tail Surface of a Typical Pursuit Airplane

Description: Report discusses the results of testing on the pressure distribution at several longitudinal sections of the vertical tail surface of the Curtiss P-40K airplane at various angles of attack and angles of yaw and with the propeller removed and propeller operating. Results regarding the chordwise pressure distributions, effects of propeller operation on the spanwise distribution of normal-force coefficient, total normal-force coefficients, and effect of propeller operation on the variation of vert… more
Date: March 1944
Creator: Sweberg, Harold H. & Dingeldein, Richard C.
Partner: UNT Libraries Government Documents Department
open access

Maximum Rates of Control Motion Obtained From Ground Tests

Description: Report discusses the results of testing to determine the maximum rates of control stick (elevator) motion and corresponding maximum stick forces that could be exerted based on experiments with several pilots. The main topics explored were the comparison of the maximum rates of push and pull, maximum rates of push and pull when a mental restriction was placed on the pilot, and maximum rates at which the pilot though he would apply the elevator control forces versus the actual application of forc… more
Date: May 1944
Creator: Beeler, De E.
Partner: UNT Libraries Government Documents Department
open access

An Automatically Variable Control Linkage and Its Effect on the Lateral-Control Characteristics of a High-Speed Fighter Airplane

Description: Report discusses an analysis and preliminary design of a control linkage that varies automatically with dynamic pressure. The advantages of the device, including greater lateral control than a fixed control linkage without additional aerodynamic balance, are detailed. The effect of variable linkage on lateral-control characteristics is also described.
Date: May 1944
Creator: Gillis, Clarence L.
Partner: UNT Libraries Government Documents Department
open access

Resume of Hinge-Moment Data for Unshielded Horn- Balanced Control Surfaces

Description: Report summarizes the available hinge-moment data for unshielded horn-balanced control surfaces. The purpose is to correlate the available data to assist with estimating the balance characteristics for use in the design and alteration of control surfaces with horn balances. Plan forms and variation of incremental hinge-moment-coefficient slopes with balance coefficients are presented.
Date: June 1943
Creator: Lowry, John G.
Partner: UNT Libraries Government Documents Department
open access

Calculation of Stick Forces for an Elevator With a Spring Tab

Description: "Formulas for the calculation of hinge-moment characteristics of an elevator with a spring tab have been developed in terms of basic aerodynamic parameters, spring stiffness, and airspeed. The formulas have been used in a study of the stick-force gradients on a pursuit airplane equipped with an elevator with a spring tab. Charts are presented showing the variation of stick-force gradient in accelerated flight over a large range of speed and the complete range of spring stiffness for various cen… more
Date: June 1944
Creator: Greenberg, Harry
Partner: UNT Libraries Government Documents Department
open access

Use of Variable-Ratio Geared Tabs to Improve Stick-Force Characteristics in Turning Flight

Description: Report discussing the use of variable-ratio geared tabs with an experimental elevator to improve stick-force characteristics in turning flight. The stick forces with the tabs were found to be satisfactory for a variety of center-of-gravity ranges. The ability of pilots to use the controls is also described.
Date: October 1945
Creator: Kleckner, Harold F.
Partner: UNT Libraries Government Documents Department
open access

A Study of the Effects of Radii of Gyration and Altitude on Aileron Effectiveness at High Speed

Description: "The variation in the necessary aileron control and in the time required to bank to 45 degrees and 90 degrees with altitude and radii of gyration for a typical fighter or a pursuit airplane have been computed and are presented herein." The lateral motions and impact pressure for several conditions of flight are provided. The report concludes that "the aileron system...should be designed for rolling-moment requirements at high altitude and the hinge-moment limitations at low altitude".
Date: April 1943
Creator: Fehlner, Leo F.
Partner: UNT Libraries Government Documents Department
open access

Application of Balancing Tabs to Ailerons

Description: Analysis was made to determine characteristics required of a balancing-tab system for ailerons in order to reduce aileron stick forces to any desired magnitude. Series of calculations based on section data were made to determine balancing-tab systems of various chord tabs and ailerons that will give, for a particular airplane, zero rate of aileron hinge moment with aileron deflection and yet will produce same maximum rate of roll as a plain unbalanced 15-percent chord aileron of same span. Effe… more
Date: June 1942
Creator: Sears, Richard I.
Partner: UNT Libraries Government Documents Department
open access

NACA Procedure for Flight Tests of Aileron Characteristics of Airplanes

Description: Report describes the standard procedure that NACA used for evaluating the aileron characteristics of airplanes. The variables measured in the testing are rolling velocity, aileron positions, aileron stick forces or tangential wheel force, indicated airspeed, altitude, free-air temperature, and rudder position. The step-by-step flight procedure is described and information regarding evaluation of the control data and general suggestions is included.
Date: July 1943
Creator: Johnson, Harold I.
Partner: UNT Libraries Government Documents Department
open access

Progress Summary Number 1: Mechanical Properties of Flush-Riveted Joints Submitted by Five Airplane Manufacturers

Description: Summary presenting information on flush-riveted joints for aircraft construction, including the strength, occurrence of defects, and effect of the angle of rivet head. The current tests covers specimens from 15 manufacturers of which 5 series have been completed and are described in this report.
Date: February 1942
Creator: Brueggeman, William Charles
Partner: UNT Libraries Government Documents Department
open access

Theoretical and Experimental Dynamic Loads for a Prismatic Float Having an Angle of Dead Rise of 22-1/2 Degrees

Description: Report discusses the maximum load, time to reach maximum load, and variation of load with time for prismatic floats in order to improve understanding of hydrodynamic theory for the landing impact of seaplane floats. Comparison of theoretical and experimental results and their applicability to flight impact are provided.
Date: July 1945
Creator: Mayo, Wilbur L.
Partner: UNT Libraries Government Documents Department
open access

Wind-Tunnel Tests of a Piston-Type Control Booster on an Airfoil and Aileron Model

Description: "Measurements of control moments were made in the NACA stability tunnel to determine the operational characteristics of a piston-type control booster on an aileron. The booster was so constructed and installed that pressures picked up from the air stream below the wing acted on a pair of pistons. The data are presented in the form of curves of pressure coefficients acting on the pistons, hinge-moment coefficients, and booster coefficients plotted against aileron deflection" (p. 1).
Date: November 1943
Creator: Bird, J. D. & Mendelsohn, Robert A.
Partner: UNT Libraries Government Documents Department
open access

An Approximate Determination of the Power Required to Move Control Surfaces as Related to Control-Booster Design

Description: "As a part of a general investigation of control boosters, preliminary calculations were made to indicate the sizes of control boosters necessary to move the controls of airplanes of various sizes. The analysis was based on the assumption that the controls were moved with a rapidity and amplitude equal to that measured with a fighter airplane in simulated combat. A corollary purpose consisted in determining the effect on reducing booster-power unit size of incorporating an energy accumulator in… more
Date: September 1945
Creator: Johnson, Harold I.
Partner: UNT Libraries Government Documents Department
open access

Effect of Changes in Aileron Rigging on the Stick Forces of a High-Speed Fighter Airplane

Description: "The effects of changes in aileron rigging between 2 deg up and 2 deg down on the stick forces were determined from wind-tunnel data for a finite-span wing model. These effects were investigated for ailerons deflecting equally in both directions and linearly with stick deflection. Data were analyzed for a Frise, a sealed internally balanced, and a beveled-trailing-edge aileron" (p. 1).
Date: May 1944
Creator: Murray, Harry E. & Warren, S. Anne
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Four NACA Airfoil Sections Designed for Helicopter Rotor Blades

Description: "The purpose of the present work is to extend the previous investigation and to derive additional airfoil sections designed to minimize the undesirable characteristics of the previously tested airfoils. The tests of these additional airfoils were made in the Langley two-dimensional low-turbulence tunnel (LTT)" (p. 2).
Date: February 1946
Creator: Stivers, Louis S., Jr. & Rice, Fred J., Jr.
Partner: UNT Libraries Government Documents Department
open access

Some Notes on the Determination of the Stick-Fixed Neutral Point From Wind-Tunnel Data

Description: "Two methods are presented for determining the horizontal location of the stick-fixed neutral point from wind-tunnel data. One method involves the solution of a mathematical equation; whereas the other method is a graphical solution for the same mathematical equation. The combined horizontal and vertical variation of the neutral point completely describes the stick-fixed longitudinal stability of airplanes that have large allowable center-of-gravity shifts" (p. 1).
Date: September 1943
Creator: Schuldenfrei, Marvin
Partner: UNT Libraries Government Documents Department
Back to Top of Screen