11 Matching Results

Search Results

Advanced search parameters have been applied.

Enhancing the soil organic matter pool through biomass incorporation.

Description: A study was installed in the upper Coastal Plains of South Carolina, USA that sought to examine the impact of incorporating downed slash materials into subsoil layers on soil chemical and physical properties as compared with the effect of slash materials left on the soil surface. Two sites were examined which differed in soil textural composition: sandy vs. clay.
Date: January 1, 2003
Creator: Sanchez, Felipe G.; Carter, Emily A. & Klepac, John F.
Partner: UNT Libraries Government Documents Department

Carbon Sequestration in Reclaimed Mined Soils of Ohio

Description: Assessment of soil organic carbon (SOC) sequestration potential of reclaimed minesoils (RMS) is important for preserving environmental quality and increasing agronomic yields. The experimental sites were characterized by distinct age chronosequences of reclaimed minesoil and were located in Guernsey, Morgan, Noble, and Muskingum Counties of Ohio. These sites are owned and maintained by Americal Electrical Power. These sites were reclaimed (1) with topsoil application, and (2) without topsoil application, and were under continuous grass or forest cover. In this report results are presented from the sites reclaimed without topsoil application between 1956 and 1969. Three sites are under continuous grass cover and the three under forest cover since reclamation. Three core and three bulk soil samples were collected from each site from three slope positions (upper; middle, and lower) for 0-15 cm and 15-30 cm depths, and texture, pH and electrical conductivity (EC), soil bulk density ({rho}{sub b}), SOC, total nitrogen (TN) stocks were determined. No differences in sand and clay contents, bulk density, SOC and TN stocks were observed within different slope positions within each site. However, sand [R56-G (17.1%) < R69-G (29.1%) = R62-G (29.1%)], and silt [R56-G (58.3%) > R69-G (47.7%)] contents, bulk density [R62-G (1.25 Mg ha{sup -1}) > R69-G (0.94 Mg ha{sup -1}) = R62-G (0.90 Mg ha{sup -1})] varied significantly on the upper slope position among sites under continuous grass cover. Smaller but significant differences were also observed for pH [R69-G (8.3) > R56-G (7.7) = R62-G (7.9)] and EC [R56-G (0.66 dS m{sup -1}) > R62-G (0.25 dS m{sup -1}) = R69-G (0.24 dS m{sup -1})] on upper slope positions among sites under grass. Comparing all sites stochastically, sand and clay contents were similar among all sites except R62-F for both depths. Similarly, soil bulk density was also similar among all sites except ...
Date: January 1, 2005
Creator: Shukla, M.K. & Lal, R.
Partner: UNT Libraries Government Documents Department

Leonid meteor ablation, energy exchange and trail morphology

Description: This paper describes theoretical model studies of the interaction of Leonid meteoroids with the earth's atmosphere. Subject to some modest-to-strenuous approximations we compute the rates of ablation and deceleration, energy deposition, and terminal altitudes of the meteors as functions of their initial mass and bulk density, velocity, trajectory entry angle, drag coefficient, heat of ablation, and an ablation energy transfer fraction. We find that the dominant energy deposition in the atmosphere is associated with the stopping of the ablated meteor particles and vapor by the surrounding air. Then having computed the energy deposition rates versus altitude we compute the hydrodynamic and radiative expansion of the hot wake material in the radial direction, along with the associated air chemistry. From the computed results we can then plot two-dimensional temperature contours -- as functions of the instantaneous distance behind the meteor and radial distance from the center of the wake, at various altitudes along the meteor's path. We also compute the rates of emission of radiation and the radiative efficiency, and discuss comparisons with observations.
Date: January 1, 2002
Creator: Zinn, John; Judd, O'Dean P. & ReVelle, D. O. (Douglas O.)
Partner: UNT Libraries Government Documents Department

A parametric pressing study using a plastic-bonded explosive

Description: Pressed plastic-bonded explosives, PBXs, are commonly used by defense and private industry. PBX 9501 is composed of HMX crystals held together with a plastic binder 'softened' with plasticizers. The detonation behavior of any explosive is very dependent upon its density, with the desire to have a uniform, high density throughout the explosive component. A parametric study has been performed pressing PBX 9501 hydrostatically and uniaxially. The effects of several pressing parameters on the bulk density and density profile, as well as mechanical properties, have been measured. The parameters investigated include pressure, temperature, number of cycles, dwell time, rest time, sack thickness, and particle distribution and size. Density distributions within the pressed explosives were also compared.
Date: January 1, 2002
Creator: Hayden, D. J. (David J.); Maez, L. R. (Leland R.); Olinger, B. W. (Barton W.) & Powell, S. J. (Sandra J.)
Partner: UNT Libraries Government Documents Department

Laboratory measurements on reservoir rocks from The Geysers geothermal field

Description: A suite of laboratory measurements have been conducted on Geysers metagraywacke and metashale recovered from a drilled depth of 2599 to 2602 meters in NEGU-17. The tests have been designed to constrain the mechanical and water-storage properties of the matrix material. Various measurements have been made at a variety of pressures and at varying degrees of saturation. Both compressional and shear velocities exhibit relatively little change with effective confining pressure. In all of the samples, water saturation causes an increase in the compressional velocity. In some samples, saturation results in a moderate decrease in shear velocity greater in magnitude than would be expected based on the slight increase in bulk density. It is found that the effect of saturation on the velocities can be quantitatively modeled through a modification of Biot-Gassmann theory to include weakening of the shear modulus with saturation. The decrease is attributed to chemo-mechanical weakening caused by the presence of water. The degree of frame weakening of the shear modulus is variable between samples, and appears correlated with petrographic features of the cores. Two related models are presented through which we can study the importance of saturation effects on field-scale velocity variations. The model results indicate that the saturation effects within the matrix are significant and may contribute to previously observed field anomalies. The results help to define ways in which we may be able to separate the effects of variations in rock properties, caused by phenomena such as degree of fracturing, from similar effects caused by variations in matrix saturation. The need for both compressional and shear velocity data in order to interpret field anomalies is illustrated through comparisons of model results with the field observations.
Date: January 26, 1995
Creator: Boitnott, G.N.
Partner: UNT Libraries Government Documents Department


Description: The Savannah River National Laboratory (SRNL) was requested by SRR to provide sample preparation and analysis of the Tank 5F final characterization samples to determine the residual tank inventory prior to grouting. Two types of samples were collected and delivered to SRNL: floor samples across the tank and subsurface samples from mounds near risers 1 and 5 of Tank 5F. These samples were taken from Tank 5F between January and March 2011. These samples from individual locations in the tank (nine floor samples and six mound Tank 5F samples) were each homogenized and combined in a given proportion into 3 distinct composite samples to mimic the average composition in the entire tank. These Tank 5F composite samples were analyzed for radiological, chemical and elemental components. Additional measurements performed on the Tank 5F composite samples include bulk density and water leaching of the solids to account for water soluble species. With analyses for certain challenging radionuclides as the exception, all composite Tank 5F samples were analyzed and reported in triplicate. The target detection limits for isotopes analyzed were based on customer desired detection limits as specified in the technical task request documents. SRNL developed new methodologies to meet these target detection limits and provide data for the extensive suite of components. While many of the target detection limits were met for the species characterized for Tank 5F, as specified in the technical task request, some were not met. In a few cases, the relatively high levels of radioactive species of the same element or a chemically similar element precluded the ability to measure some isotopes to low levels. The Technical Task Request allows that while the analyses of these isotopes is needed, meeting the detection limits for these isotopes is a lower priority than meeting detection limits for the other specified ...
Date: January 20, 2012
Creator: Oji, L.; Diprete, D.; Coleman, C. & Hay, M.
Partner: UNT Libraries Government Documents Department

Estimating canopy fuel parameters for Atlantic Coastal Plain forest types.

Description: Abstract It is necessary to quantify forest canopy characteristics to assess crown fire hazard, prioritize treatment areas, and design treatments to reduce crown fire potential. A number of fire behavior models such as FARSITE, FIRETEC, and NEXUS require as input four particular canopy fuel parameters: 1) canopy cover, 2) stand height, 3) crown base height, and 4) canopy bulk density. These canopy characteristics must be mapped across the landscape at high spatial resolution to accurately simulate crown fire. Currently no models exist to forecast these four canopy parameters for forests of the Atlantic Coastal Plain, a region that supports millions of acres of loblolly, longleaf, and slash pine forests as well as pine-broadleaf forests and mixed species broadleaf forests. Many forest cover types are recognized, too many to efficiently model. For expediency, forests of the Savannah River Site are categorized as belonging to 1 of 7 broad forest type groups, based on composition: 1) loblolly pine, 2) longleaf pine, 3) slash pine, 4) pine-hardwood, 5) hardwood-pine, 6) hardwoods, and 7) cypress-tupelo. These 7 broad forest types typify forests of the Atlantic Coastal Plain region, from Maryland to Florida.
Date: January 15, 2007
Creator: Parresol, Bernard, R.
Partner: UNT Libraries Government Documents Department

Bonding topologies in diamondlike amorphous-carbon films

Description: The carbon ion energy used during filtered cathodic vacuum arc deposition determines the bonding topologies of amorphous-carbon (a-C) films. Regions of relatively low density occur near the substrate/film and film/surface interfaces and their thicknesses increase with increasing deposition energy. The ion subplantation growth results in mass density gradients in the bulk portion of a-C in the growth direction; density decreases with distance from the substrate for films grown using ion energies < 60 eV and increases for films grown using ion energies > 160 eV. Films grown between these energies are the most diamondlike with relatively uniform bulk density and the highest optical transparencies. Bonding topologies evolve with increasing growth energy consistent with the propagation of subplanted carbon ions inducing a partial transformation of 4-fold to 3-fold coordinated carbon atoms.
Date: January 27, 2000
Partner: UNT Libraries Government Documents Department

Ultrahard carbon nanocomposite films

Description: Modest thermal annealing to 600 C of diamondlike amorphous-carbon (a-C) films grown at room temperature results in the formation of carbon nanocomposites with hardness similar to diamond. These nanocomposite films consist of nanometer-sized regions of high density a-C embedded in an a-C matrix with a reduced density of 5--10%. The authors report on the evolution of density and bonding topologies as a function of annealing temperature. Despite a decrease in density, film hardness actually increases {approximately} 15% due to the development of the nanocomposite structure.
Date: January 27, 2000
Creator: Siegal, Michael P.; Tallant, David R.; Provencio, Paula P.; Overmyer, Donald L.; Simpson, Regina L. & Martinez-Miranda, L. J.
Partner: UNT Libraries Government Documents Department

Physical response of backfill materials to mineralogical changes in a basalt environment. [Sand-clay mixture containing 25% bentonite]

Description: Backfill materials surrounding waste canisters in a high-level nuclear waste repository are capable of ensuring very slow flow of groundwater past the canisters, and thereby increase the safety of the repository. However, in the design of a repository it will be necessary to allow for possible changes in the backfill. In this experimental program, changes in permeability, swelling behavior, and plastic behavior of the backfill at the temperatures, pressures, and radiation levels expected in a repository are investigated. The emphasis is on investigation of relevant phenomena and evaluation of experimental procedures for use in licensing procedures. The permeability of a slightly compacted sand-clay mixture containing 25% bentonite, with a dry bulk density of 1.59 g/cm/sup 3/, was determined to be 0.9 x 10/sup -18/ m/sup 2/ in liquid water at 25 and 200/sup 0/C, respectively. This is sufficiently low to demonstrate the potential effectiveness of proposed materials. In practice, fractures in the host rock may form short circuits around the backfill, so an even lower flow rate is probable. However, alteration by any of several mechanisms is expected to change the properties of the backfill. Crushed basalt plus bentonite is a leading candidate backfill for a basalt repository. Experiments show that basalt reacts with groundwater vapor or with liquid groundwater producing smectites, zeolites, silica, and other products that may be either beneficial or detrimental to the long-term performance of the backfill. Concentration of groundwater salts in the backfill by evaporation would cause immediate, but possibly reversible, reduction of the swelling abaility of bentonite. Moreover, under some circumstances, gamma radiolysis of moist air in the backfill could produce up to 0.5 mole of nitric acid or ammonia per liter of pore space. 27 references, 7 figures, 4 tables.
Date: January 1, 1983
Creator: Couture, R.A. & Seitz, M.G.
Partner: UNT Libraries Government Documents Department

Birch's law and the properties of high temperature fluid metals

Description: By comparing acoustic velocities in fluid metals over a very wide range of densities we have established Birch's Law as an approximate representation over the entire liquid range. For a given liquid metal the acoustic velocity is close to linear in density, with a slope determined by the atomic weight. The measurements include isobaric expansion to less than half normal density, ultrasonics on molten metals at 1 atmosphere, and shock-melted metals to greater than twice normal density. We also find unusual behavior of the Gruneisen gamma, which can be explained in terms of simple fluid models. 15 refs.
Date: January 1, 1987
Creator: Shaner, J.W.
Partner: UNT Libraries Government Documents Department