UNT Libraries Government Documents Department - Browse

ABOUT BROWSE FEED

Design of a Basin-Type Solar Still

Description: From Introduction: "This report describes the design, construction, operation, and maintenance of a particular solar still that has been shown to be a practical for converting saline water to fresh water at low cost in localities where there is a reasonable amount of sunshine. A series of photographs is included which illustrate the steps in constructing a still."
Date: June 1964
Creator: Bloemer, J. W.; Irwin, J. R. & Eibling, J. A.

Development of Direct Contact Condensation Multistage Flash Distillation Process: Phase 1

Description: Report investigating the feasibility of the Atomics International Direct Contact Condensation Multistage Flash (DCC-MSF) Distillation process using "analytical and experimental studies on a direct contact condensation module and a plastic film heat exchanger. (p. iii)
Date: September 1969
Creator: Kohl, A. L.; Shimazaki, T. T.; Wetch, J. R. & Bienvenue, L. L.

Development of Direct Contact Condensation Multistage Flash Distillation Process Phase 2

Description: Report investigating the feasibility of the Atomics International Direct Contact Condensation Multistage Flash (DCC-MSF) Distillation process using "analytical and experimental studies on a direct contact condensation module and a plastic film heat exchanger. (p. iii) Contains further studies and evaluations of the direct-contact condensation unit and plastic film heat exchanger.
Date: May 1970
Creator: Kohl, A. L.; Shimazaki, T. T.; Wetch, J. R. & Suratt, W. B.

Development of Direct Contact Condensation Multistage Flash Distillation Process Phase IIIA

Description: Report investigating the feasibility of the Atomics International Direct Contact Condensation Multistage Flash (DCC-MSF) Distillation process using "analytical and experimental studies on a direct contact condensation module and a plastic film heat exchanger. (p. iii) Contains further studies and evaluations of the direct-contact condensation unit and plastic film heat exchanger.
Date: January 1971
Creator: Kohl, A. L.; Shimazaki, T. T.; Suratt, W. B. & Westerman, S.

Development of Polyphenylene Oxide Membranes

Description: Report concerning manufacturing variables on sulfonated polyphenylene oxide reverse osmosis membranes. The effects these variables have membrane performance are discussed as well as procedures to increase membrane reproducibility and performance.
Date: June 1971
Creator: Chludzinski, Paul; Austin, J. F. & Enos, J.

Development of the Direct Freeze Separation Process

Description: Report regarding the construction and testing of a sea water to fresh water conversion plant which uses a freezing method to remove salt. The report also presents information regarding the plant's economic and technical feasibility.
Date: June 1964
Creator: Hahn, Wilfred J.; Burns, Rodney C.; Fullerton, Robert S. & Sandell, Dewey J.

Development of Tubular Reverse Osmosis Module Assembly Techniques

Description: Report concerning the development of equipment and processes required for the production of porous wall reverse osmosis tubes lined with membrane material deposited by extrusion. These include a chilled water membrane gellation system, "a heat treat fixture permitting simultaneous heat treatment of several reverse osmosis tubes" (p. 1), and the optimization of the structure of fiberglass filament/resin composite material.
Date: August 1970
Creator: Fluke, G. A.