UNT Libraries Government Documents Department - 238 Matching Results

This system will be undergoing maintenance April 18th between 9:00AM and 12:00PM CDT.

Search Results

Results: 1 - 24 next
open access

The additional-mass effect of plates as determined by experiments

Description: From Introduction: "The apparent increase in the inertia properties of a body moving in a fluid medium has been called the additional-mass effect. This report presents a resume of test procedures and results of experimental determinations of the additional-mass effect of flat plates. In addition to data obtained from various foreign sources and from a NACA investigation in 1933, the results of tests recently conducted by the National Advisory Committee for Aeronautics are included."
Date: 1941
Creator: Gracey, William
Item Type: Refine your search to only Report
open access

Aerodynamic Characteristics of a Slot-Lip Aileron and Slotted Flap for Dive Brakes

Description: From Introduction: "As a part of this investigation, a study is being made of test results obtained during the development of devices designed primarily for other purposes, such as high lift or lateral control, but which may also be used for dive control. These results have been reanalyzed and are herein presented in a form that should make them convenient for design purposes."
Date: April 1941
Creator: Rogallo, F. M.
Item Type: Refine your search to only Report
open access

Aerodynamic Factors Affecting the Ability of a Pilot to Return an Airplane to Level From a Banked Attitude by Use of the Rudder Alone and Without Change of Heading

Description: Report presenting a study of the aerodynamic factors upon which the ability to perform the maneuver depends in an attempt to obtain a better understanding of the conditions involved and, if possible, to evolve criterions that may be used during design.
Date: October 1941
Creator: Harmon, S. M.
Item Type: Refine your search to only Report
open access

The aerodynamics of a wind-tunnel fan

Description: From Introduction: "This paper deals only with the aerodynamics of the fan proper and demonstrates the manner in which the radial distribution of axial velocity of fluid through a fan is governed by geometry of the fan itself."
Date: August 1941
Creator: Corson, Blake W.
Item Type: Refine your search to only Report
open access

Air Transport by Gliders: Some Technical Observations

Description: This short analysis may be useful in determining the real tactical possibilities of "glider trains" and in adopting the course to be followed in possible studies of these questions. In this analysis most prominent are: (a) the power required for the train in level flight; (b) its speed; (c) climb; and (d) the type of airplane best suited for towing as well as design requirements for transport gliders.
Date: June 1941
Creator: Stepniewski, Wieslaw
Item Type: Refine your search to only Report
open access

Aluminum-Zinc-Magnesium-Copper Casting Alloys

Description: From Introduction: "This paper contains data on the mechanical properties of sand-cast test bars having a considerable range in zinc, magnesium, and copper content and more detailed data on the properties and foundry characteristics of an aluminum-zinc-magnesium-copper alloy having a preferred composition for high strength and ductility."
Date: July 1941
Creator: Kempf, L. W.
Item Type: Refine your search to only Report
open access

Analysis of Ground Effect on the Lifting Airscrew

Description: "A study is presented of ground effect as applied to the lifting airscrew of the type used in modern gyroplanes and helicopters. The mathematical analysis of the problem has been verified by tests made of three rotor models in the presence of a large circular "ground plane." The results of the study are presented in the form of convenient charts" (p. 1).
Date: December 1941
Creator: Knight, Montgomery & Hefner, Ralph A.
Item Type: Refine your search to only Report
open access

An analytical study of wing and tail loads associated with an elevator deflection

Description: From Introduction: "The present paper covers step 1 of the outlined investigation, includes methods of computing the variation of wing and tail loads, and gives numerical results of the application of the theory to the BT-9B airplane. Finally, theoretical formulas are developed and charts are given for computing the maximum increments of wing load, the down-tail load, and the up-tail load following a given elevator displacement."
Date: June 1941
Creator: Pearson, H. A. & Garvin, J. B.
Item Type: Refine your search to only Report
open access

Annual Report of Research and Technologic Work on Coal: Fiscal Year 1941

Description: Report issued by the U.S. Bureau of Mines discussing the annual report over the research and technology of coal during 1941. As stated in the foreword, "these investigations increase our fund of exact knowledge on the properties and composition of American coals and lead to better methods in mining, preparing, storing, and utilizing coal" (p. 4). This report includes tables, illustrations, photographs, and a map.
Date: November 1941
Creator: Fieldner, Arno Carl & Schmidt, L. D.
Item Type: Refine your search to only Report
open access

Bending of Rectangular Plates With Large Deflections

Description: "The solution of Von Karman's fundamental equations for large deflections of plates is presented for the case of a simply supported rectangular plate under combined edge compression and lateral loading. Numerical solutions are given for square plates and for rectangular plates with a width-span ratio of 3:1. The effective widths under edge compression are compared with effective widths according to Von Karman, Bengston, Marguerre, and Cox and with experimental results by Ramberg, Mcpherson, and… more
Date: May 27, 1941
Creator: Levy, Samuel
Item Type: Refine your search to only Report
open access

Boundary Layer Removal by Suction

Description: Flight-test data and wind-tunnel data on suction profiles are substantially in agreement. The lift values found in the model test can be actually flown and used as a basis for the design. To visualize the action of the suction, the flow conditions with and without suction on the upper surface were photographed; figures 12 to 15 are sections of the film.
Date: April 1941
Creator: Schrenk, O.
Item Type: Refine your search to only Report
open access

Buckling Tests on Eccentrically Loaded Beam Columns

Description: "Formulas are obtained for computing the buckling load of rods eccentrically loaded at each end, the computation being extended in particular to the inelastic range. The test results are graphically presented on three sets of curves. Two of these, at least for the elastic range, are independent of the material tested. The third set, which is independent of the material, possesses greater clearness and is therefore used for comparing the test results with the theoretical" (p. 1).
Date: October 1941
Creator: Cassens, J.
Item Type: Refine your search to only Report
open access

The Calculation of Span Load Distributions of Swept-Back Wings

Description: "Span load distributions of swept-back wings have been calculated. The method used was to replace the wing with a bound vortex at the quarter-chord line and to calculate the downwash due to the system of bound and trailing vortices to conform at the three-quarter-chord line to the slope of the flat-plate wing surface. Results are given for constant-chord and 5:1 tapered plan forms, for sweep-back angles of 0 degrees, 30 degrees, and 45 degrees, and for aspect ratios of 3, 6, and 9" (p. 1).
Date: December 1941
Creator: Mutterperl, William
Item Type: Refine your search to only Report
open access

Characteristics of Naca 4400R Series Rectangular and Tapered Airfoils, Including the Effect of Split Flaps

Description: "At the request of the Bureau of Aeronautics, Navy Department, tests were made in the variable-density wind tunnel of a tapered wing of 3-10-18 plan form and based on the NACA 4400R series sections. The wing was also tested with 0.2 chord split flaps, deflected 60 degrees, in the center of the wing and having flat span to wing span ratios of 0.3, 0.5, 0.7, and 1.0, respectively" (p. 1).
Date: January 1941
Creator: Greenberg, Harry
Item Type: Refine your search to only Report
open access

Characteristics of NACA 4400R Series Rectangular and Tapered Airfoils, Including the Effect of Split Flaps

Description: "At the request of the Bureau of Aeronautics, Navy Department, tests were made in the variable-density wind tunnel of a tapered wing of 3-10-18 plan form and based on the NACA 4400R series sections. The wing was also tested with 0.2 chord spit flaps, deflected 60 deg span ratios of 0.3, 0.5, 0.7 and 1.0 respectively. In order to get data from which to calculate the characteristics of the flapped wing, the investigation was extended to include tests of the four rectangular airfoils of the NACA 4… more
Date: January 1941
Creator: Greenberg, Harry
Item Type: Refine your search to only Report
open access

Coal-Mine Accidents in the United States, 1938

Description: Report compiled by the U.S. Bureau of Mines including statistics on fatal and non-fatal accidents in coal mines located in the United States as well as data regarding the various operations (e.g., number of miners employed and average production). The information is organized into tables for comparison and the text draws some overall conclusions in the summary.
Date: 1941
Creator: Adams, W. W.; Geyer, L. E. & Parry, M. G.
Item Type: Refine your search to only Report
open access

Collecting and Examining Subsurface Samples of Petroleum

Description: Report issued by the Bureau of Mines discussing subsurface samples of petroleum. As stated in the scope of report, "the Bureau of Mines has developed special equipment and procedures for obtaining samples of petroleum under pressure from the bottom of wells and for examining these samples in the laboratory" (p. 4). This report includes tables, illustrations, and a photograph.
Date: 1941
Creator: Grandone, Peter & Cook, Alton B.
Item Type: Refine your search to only Report
Back to Top of Screen