Search Results

open access

Directional Stability of Towed Airplanes

Description: "So far, very careful investigations have been made regarding the flight properties, in particular the static and dynamic stability, of engine-propelled aircraft and of untowed gliders. In contrast, almost no investigations exist regarding the stability of airplanes towed by a towline. Thus, the following report will aim at investigating the directional stability of the towed airplane and, particularly, at determining what parameters of the flight attitude and what configuration properties affe… more
Date: January 1956
Creator: Söhne, W.
open access

Remark on the Theory of Lifting Surfaces

Description: First, the Weissinger method, as it applies to a rectangular wing,is discussed. By building on this framework it is shown how to treat the lift problem for any thin wing of arbitrary plan form. The result of using this method may be arrived at by examination of the general equations applying to lifting surfaces.
Date: January 1956
Creator: Muggia, Aldo
open access

Laminar Flow About a Rotating Body of Revolution in an Axial Airstream

Description: We have set ourselves the problem of calculating the laminar flow on a body of revolution in an axial flow which simultaneously rotates about its axis. The problem mentioned above, the flow about a rotating disk in a flow, which we solved some time ago, represents the first step in the calculation of the flow on the rotating body of revolution in a flow insofar as, in the case of a round nose, a small region about the front stagnation point of the body of revolution may be replaced by its tange… more
Date: February 1956
Creator: Schlichting, H.
open access

Formation of a Vortex at the Edge of a Plate

Description: The flow about the plate of infinite width may be represented as a potential flow with discontinuity surfaces which extend from the plate edges. On the basis of a similitude requirement one succeeds in finding a solution of this problem for the plate of infinite width which is correct for the very beginning of the motion of the fluid. Starting from this solution, the further development of the vortex distribution and shape of the surface are observed in the case of a plate of finite width.
Date: March 1956
Creator: Anton, Leo
open access

Interim Report on Fatigue Characteristics of a Typical Metal Wing

Description: Constant amplitude fatigue tests of seventy-two P-51D "Mustang" wings are reported. The tests were performed by a vibrational loading system and by an hydraulic loading device for conditions with and without varying amounts of pre-load. The results indicate that: (a) the frequency of occurrence of fatigue at any one location is related to the range of the loads applied, (b) the rate of propagation of visible cracks is more or less constant for a large portion of the life of the specimen, and (c… more
Date: March 1956
Creator: Kepert, J. L. & Payne, A. O.
open access

On the Gas Dynamics of a Rotating Impeller

Description: It is shown that for a compressible flow with constant entropy the pressure rise maintains the direct relation to the circulation around the blades existing for incompressible flow. In contrast, however, the torque, and with it the power consumption, is increased because of sound waves traveling to infinity already at subsonic circumferential speeds.
Date: March 1956
Creator: Busemann, Adolf
open access

Boundary Layer

Description: From Introduction: "The fundamental, practically the most important branch of the modern mechanics of a viscous fluid or a gas, is that branch which concerns itself with the study of the boundary layer. The presence of a boundary layer accounts for the origin of the resistance and lift force, the breakdown of the smooth flow about bodies, and other phenomena that are associated with the motion of a body in a real fluid. The concept of boundary layer was clearly formulated by the founder of aero… more
Date: May 1956
Creator: Loitsianskii, L. G.
open access

Flat Plate Cascades at Supersonic Speed

Description: A brief review of exact two-dimensional supersonic flow theory and Ackeret's linearized theory are first presented. The lift and drag coefficients of a cascade of flat plates are calculated exactly and compared to those obtained using the linearized theory. The forces on the cascade are determined for unsteady inlet flow. The flat plate cascade theory is extended to compute the efficiency of a supersonic propeller with friction and finite blade thickness.
Date: May 1956
Creator: El Badrawy, Rashad M.
open access

Flow of Gas Through Turbine Lattices

Description: This report is concerned with fluid mechanics of two-dimensional cascades, particularly turbine cascades. Methods of solving the incompressible ideal flow in cascades are presented. The causes and the order of magnitude of the two-dimensional losses at subsonic velocities are discussed. Methods are presented for estimating the flow and losses at high subsonic velocities. Transonic and supersonic flows in lattices are then analyzed. Some three-dimensional features of the flow in turbines are not… more
Date: May 1956
Creator: Deich, M. E.
open access

On Landing Gear Stresses

Description: Information on landing gear stresses is presented on the following: vibratory phenomena, tangential forces applied to landing gear, fore and aft oscillations of landing gears, examples of fatigue failures, vibration calculations, and improvement of existing test equipment.
Date: July 1956
Creator: Gentric, A.
open access

Effects of Intermittent Versus Continuous Heating upon the Tensile Properties of 2024-T4, 6061-T6 and 7075-T6 Alloys

Description: In some applications, aluminum alloys are subjected to intermittent heating at elevated temperature. It is generally considered that the effects of such intermittent heating are cumulative, and therefore are the same as if the heating had been continuous for the same total length of time. The object of these tests was to determine the effects of intermittent and continuous heating at 300 and 400 F, for total periods of 100 and 200 hr, upon the tensile properties of 2024-T4 and 6061-T6 alloy rol… more
Date: August 1956
Creator: Stickley, G. W. & Anerson, H. L.
open access

The Fatigue Strength of Riveted Joints and Lugs

Description: This report deals with a number of tests on riveted joints and lugs for the primary purpose of comparing the several types of riveted joints and to study the effect of various factors on the fatigue strength of lugs. A check was made to ascertain whether or not an estimate of the fatigue life at a certain loading could be made from the dimensions of the joint and the fatigue data of the unnotched materials. Recommendations are made on the proportioning of joints to obtain better fatigue behavio… more
Date: August 1956
Creator: Schijve, J.
open access

Safeguards Against Flutter of Airplanes

Description: This report is a compilation of practical rules, derived at the same time from theory and from experience, intended to guide the aeronautical engineer in the design of flutter-free airplanes. Rules applicable to the wing, the ailerons, flaps, tabs,tail surfaces, and fuselage are discussed.
Date: August 1956
Creator: De Vries, Gerhard
open access

Tests to Determine the Adhesive Power of Passenger-Car Tires

Description: "The concept of the adhesive power of a tire with respect to the road involves several properties which result from the purpose of the tire; namely, connecting link between vehicle and road: (1) The tire must transfer the tractive and braking forces acting in the direction of travel (tractive and braking adhesion); (2) The tire is to prevent lateral deviations of the vehicle from the desired direction of travel (track adhesion)" (p. 1).
Date: August 1956
Creator: Förster, B.
open access

Finite Span Wings in Compressible Flow

Description: Equations are developed using the source distribution method for the velocity potential function and pressure on thin wings in steady and unsteady motion. Closed form solutions are given for harmonically oscillating wings of general plan form including the effect of the wing wake. Some useful examples are presented in an appendix for arrow, semielliptical, and hexagonal plan form wings.
Date: September 1956
Creator: Krasilschchikova, E. A.
open access

Aeroelastic Problems of Airplane Design

Description: The technical memorandum briefly summarizes the growth of interest in aeroelastic phenomena as aircraft speed increased and wing designs changed for faster aircraft. Different types of aircraft vibrations are then introduced, and the mathematical basis for the theory behind them is described. Special attention is given to static oscillations, wing flutter, and the flutter of skin panels. The last section of the memorandum deals with the prevention of flutter by design specifications.
Date: November 1956
Creator: Küssner, H. G.
open access

On the Calculation of Shallow Shells

Description: This paper considers a sufficiently thin shallow shell of nonzero Gaussian curvature. It also presents a system of symmetrically constructed differential equations, constructed by the mixed method through the stress function and the displpacement function.
Date: December 1956
Creator: Ambartsumyan, S. A.
open access

On the Contribution of Turbulent Boundary Layers to the Noise Inside a Fuselage

Description: "The following report deals in preliminary fashion with the transmission through a fuselage of random noise generated on the fuselage skin by a turbulent boundary layer. The concept of attenuation is abandoned and instead the problem is formulated as a sequence of two linear couplings: the turbulent boundary layer fluctuations excite the fuselage skin in lateral vibrations and the skin vibrations induce sound inside the fuselage. The techniques used are those required to determine the response … more
Date: December 1956
Creator: Corcos, G. M. & Liepmann, H. W.
open access

On the Theory of Thin Shallow Shells

Description: This report is concerned with the theory of thin shallow shells. It does not employ the lines of curvature as the coordinate system, but employs "almost cartesian coordinates" or the coordinates obtained by cutting the surface into two mutually orthogonal systems of parallel planes.
Date: December 1956
Creator: Nazarov, A. A.
Back to Top of Screen