UNT Libraries Government Documents Department - 179 Matching Results

Search Results

Results: 1 - 24 next
open access

Determination of the 14-Mev Li7 (n,n'a)T Cross Section from Sphere Multiplication and Transmission Measurements

Description: By utilizing lithium spherical shell transmission and multiplication measurements, the Li7(n,n'y)Li7 and the He6-production cross sections, it is possible to deduce that the 14-Mev Li (n,n'a)T cross section is 325 ± 75 mb. A spectrum for neutrons degraded in energy between 0 and 12 Mev is also given.
Date: July 1054
Creator: Thomas, R. G.
Item Type: Refine your search to only Report
open access

Fraunhofer Diffraction Pattern Produced by a Slit of Varying Width and its Application to High Speed Cameras

Description: Abstract: "A theoretical and experimental investigation is made of the diffraction pattern produced by a slit, whose aperture varies uniformly from a constant value A to zero. The results of this investigation are applied to a proposed high speed camera. It is shown that diffraction effects are very serious and cannot be neglected. It seems, unless the suggested design of this high speed camera is changed, the camera will be of little use for accurate measurements, and photographs will show too… more
Date: November 11, 1947
Creator: Geiger, F. E. & Brixner, Berlyn
Item Type: Refine your search to only Report
open access

Methyl Methacrylate Casting Resin

Description: Abstract: "This report describes work done to improve the casting characteristics of methyl methacrylete resin under CMR-6-18 authorization. The experimental program was initiated with the objectives of decreasing casting time, bubble formation and shrinkage. It has been found that by use of a common solvent for monomer and polymer concentration in monomer can be attained greater than any previously reported in preparation of a methacrylate casting resign. Incorporation of this greater amount o… more
Date: January 8, 1948
Creator: Church, J. S. & Tyler, H. R.
Item Type: Refine your search to only Report
open access

Effect of Temperature and Reactivity Changes in Operation of the Los Alamos Plutonium Reactor

Description: The operation of the Fast Reactor is considered in terms of normal equilibrium conditions and normal shut-down. The proposed loading, control rod adjustment and subsequent "floating" operation are discussed. Safety devices and interlocks are described. Temperature and reactivity changes are examined with respect to various system failures, phase changes, and "flashing" of the reactor. Slow changes due to faulty slug cooling are also considered. The calculations were initially based upon 10 kw o… more
Date: May 28, 1948
Creator: Hall, David B. & Hall, Jane H.
Item Type: Refine your search to only Report
open access

An Analysis of Project Data on the Corrosion of Uranium in Various Media

Description: This is a summarizing and reviewing report in which almost all the experimental data representing Project work done prior to 1949 on the corrosion of pure uranium are brought together and analyzed. New data obtained in this laboratory on corrosion rates in laboratory atmosphere and on the identification of corrosion products by electron diffraction are included. The data for corrosion in each of several different media have been plotted according to logarithm-of-the-rate versus reciprocal-tempe… more
Date: December 22, 1948
Creator: Waber, James T. (James Thomas), 1920-
Item Type: Refine your search to only Report
open access

Fabrication of Uranium Wire

Description: From abstract: "The present report describes experimental work performed to establish a procedure for the production of uranium metal wire. In all cases, the size of the initial rod was 1/2 inch diameter. Three materials were used: hot extruded tuballoy rod, high purity cast tuballoy rod, and cast U-235 rod."
Date: October 25, 1949
Creator: Anderson, R. E.; Taub, J. M. & Doll, D. T.
Item Type: Refine your search to only Report
open access

Oralloy Hydride Critical Assemblies

Description: Part I of this report covers critical-mass determinations for pseudospheres of oralloy hydride composition (approximating UH3) in 8"-thick Tu and Ni tampers and in the Tu tamper with Ni liner. The critical mass of a hydride cube in the thick Tu also is given. Data on weight and dimensional changes of hydride pieces during the period of use are included. In Part II are presented the results of Rossi time-scale measurements on the hydride assemblies. Values of alpha at delayed critical and its va… more
Date: May 22, 1950
Creator: Paxton, Hugh Campbell; Orndoff, John D. & Linenberger, G. A. (Gustave Aaron)
Item Type: Refine your search to only Report
open access

Oralloy Shape Factor Measurements

Description: Measurements have been at the Pajarito remote control laboratory to determine the effect of change of shape on system reactivity for oralloy cylinders. Systems tested include cylindrical configurations with various height-to-diameter ratios ranging from slabs to rods. Each system reactivity is referred to that of a sphere in the same tamper. Reactivity tests were made on bare (untamped) Oy configurations, as well as on systems In tuballoy tampers 1.12,1.87,and 8.0 thick. The amount of reactivit… more
Date: August 8, 1950
Creator: Josephson, V. (Vernal), 1913-1997; Paine, R. W. Jr. & Woodward, L. L.
Item Type: Refine your search to only Report
open access

The Reaction of Tritium and Stopcock Grease

Description: This investigation was begun as a result of a mass spectrometric measurement of two samples of tritium which had been stored for several months in Pyrex glass bulbs using stopcocks. The first of these was originally supposed to be of extremely high isotopic and chemical purity. What was observed at this time was 1.45 H had accumulated, and that tritiated methane, CT4, was also present to the extent of 0.18%. A consistent attempt had been made in this sample to protect the gas from contact with … more
Date: August 8, 1950
Creator: McInteer, B. B.
Item Type: Refine your search to only Report
open access

A Design for a Rotary Reactivity Control for a Test Reactor

Description: Tests made on the Oy-Tu reacting assembly at Pajarito indicate that the lateral displacement of two halves of the active material within the assembly can be used as a control mechanism on this type of reacting assembly. This report describes a reacting assembly using a rotary control mechanism based on this principle and indicates the sensitivity of control possible with such a device.
Date: September 18, 1950
Creator: Josephson, V. (Vernal)
Item Type: Refine your search to only Report
open access

Development of Forging Techniques for Uranium

Description: Uranium has been successfully forged using a Lobdell-Nazel forging hammer and a forging temperature range of 500 to 650 degrees centigrade. Using standard forging techniques, the metal readily flowed at the temperature chosen. A noticeable increase in tensile strength, yield strength and percent elongation was obtained in forged metal as compared with cast metal. To obtain complete recrystallization and uniform grain size, a minimum of approximately 75 percent reduction in cross section by forg… more
Date: November 1, 1950
Creator: Anderson, R. E.; Taub, J. M. & Doll, D. T.
Item Type: Refine your search to only Report
open access

Development for Techniques for Rolling Uranium Metal

Description: Uranium can be rolled from cast metal or forged ingot to sheet satisfactory for cupping, deep drawing, and similar fabrication procedures by a combination of hot breakdown in the neighborhood of 600 deg C and warm finishing at 225 to 325 deg C. Sheet may also be obtained by hot rolling alone and by warm rolling alone. However, it is difficult to secure a uniform, controlled grain size by hot rolling only and warm rolling is time consuming because of the limited reduction per pass obtainable. Th… more
Date: November 15, 1950
Creator: Deutsch, D. E.; Hanks, G. S.; Taub, J. M. & Doll, D. T.
Item Type: Refine your search to only Report
open access

Neutron Energy Distributions Inside the Fast Reactor

Description: This technical report presents results of nuclear plate work carried out to determine the neutron energy distribution inside the Los Alamos fast reactor. Most of the distributions which were investigated are valid over the energy region from 0.4 to 6 Mev. The results show that at the center of the reactor pot about 65% of the neutrons are located below 1 Mev in a rather narrow energy region which has a maximum in the neighborhood of 0.5 to 0.6 Mev. Above 2 Mev the energy distribution is similar… more
Date: December 15, 1950
Creator: Nereson, Norris G., 1918-2007
Item Type: Refine your search to only Report
open access

Impact Extrusion of Uranium

Description: Uranium has been successfully impact extruded into typical cylindrical shapes of conventional design. Extrusion was carried out in the "gamma" region by heating cast uranium slugs to a temperature of approximately 1050 degrees C. Protection against oxidation was afforded by surrounding the slugs during heating with an inert atmosphere of argon gas. Impact extruded shapes possessed physical properties which are better than the properties of as-cast metal. Also, extruded shapes show a uniform int… more
Date: January 10, 1951
Creator: Hanks, G. S.; Jaynes, G. E.; Taub, J. M. & Doll, D. T.
Item Type: Refine your search to only Report
open access

Short Period Gamma-Rays from U235 Fission Products

Description: A search for gamma-ray activities with period 1-100 msec from thermal neutron fission of U235 gave negative results. 0.43 +- 0.03 sec was the shortest observed. The period of B12 was found to be 27 +- 3 msec. The cyclotron beam was pulsed to supply 1-10 msec neutron bursts. coincidence scintillation deters were employed.
Date: January 15, 1951
Creator: Brolley, John Edward, 1919- & Livingston, M. Stanley (Milton Stanley)
Item Type: Refine your search to only Report
open access

A Spectrophotometric Determination of Multimicrogram Amounts of Plutonium

Description: A spectrophotometric method for the determination of plutonium wing sodium alizarin sulfonate has been developed. The red plutonium-alizarin sulfonate color is developed in solutions having a pH of about three in the presence of a formic acid-sodium formate buffer, and the resulting absorption is measured at 530 millimicrons. Most interfering cations, particularly iron(III), are removed from the plutonium solutions by means of electrolysis using a mercy cathode. Aluminum(III), in quantities up… more
Date: January 26, 1951
Creator: King, Glendall L.
Item Type: Refine your search to only Report
open access

Energy Distribution of Fast Neutron Beam

Description: Experimental techniques are described for the spectral measurement of a collimated fast neutron beam. A hydrogen filled cloud chamber, proton recording nuclear plates, and threshold fission foils were used as neutron detectors in the measurements. As an application of the above technique, the energy distribution and absolute flux of the fast neutron beam emerging from port 5W of the Los Alamos fast rector has been measured from 0.1 Mev to 18 Mev. The result show a spectral curve possessing a ma… more
Date: February 15, 1951
Creator: Nereson, Norris G., 1918-2007
Item Type: Refine your search to only Report
open access

The Nickel-Plutonium System

Description: A tentative nickel-plutonium constitutional diagram was based on data obtained by thermal analysis, metallography, and x-ray-diffraction techniques. The systema is a complex one with the following important features. Nickel is soluble in epsilon plutonium, extending the epsilon field to 4.3 at.% nickel at 465 deg C. Nickel and plutonium form six intermetallic compounds, PuNi, EnNi/sub 2/, PuNi/sub 3/, PuNi/sub 4/, PuNi/sub 5/, and PuNi/sub 9/. The compound PuNi/ sub 5/ forms congruently from th… more
Date: March 1, 1951
Creator: Wensch, Glen William, 1917-; Whyte, D D.; Cramer, E M.; Ellinger, F H.; Schonfeld, F W. & Struebing, V O.
Item Type: Refine your search to only Report
Back to Top of Screen