UNT Libraries Government Documents Department - 726 Matching Results

Search Results

Dibutyl Carbitol Solvent Extraction of Polonium-210 from Nitric Acid Solutions of Irradiated Bismuth

Description: Abstract: "A continuous countercurrent solvent extraction process utilizing dibutyl carbitol as the extractant has been developed for separating 210Po from large amounts of associated bismuth. Both laboratory and pilot plant data demonstrate the process is a suitable headend step in recovery of kilogram quantities of 210Po. Typically, the extraction process recovers over 98% of the 210Po, essentially free from bismuth (Bi DF>1500), in a dilute HNO3 solution suitable as a starting material for final concentration and purification steps."
Date: February 1968
Creator: Schulz, Wallace W. & Richardson, G. L.

Quarterly Progress Report, Research and Development Activities Fixation of Radioactive Residues: April-June 1965

Description: Introduction: "This progress report is the twenty-sixth in a series presenting research and development activities in the field of radioactive wastes. Experimental work charged to programs other than those of the Division of Reactor Development is included for general interest and completeness; such work is identified in the headings."
Date: September 1965
Creator: Pacific Northwest Labortoary. Chemistry Department.

Reactor Shielding Design Manual

Description: The purpose of this manual is to help an engineer or scientist to design a practical shield by making available to them the techniques and data developed by the Naval Reactors Program and Pressurized Water Reactor Program.
Date: March 1956
Creator: Rockwell, Theodore, III

The Fabrication of Subassemblies for the Supercritical-Water Reactor

Description: In studies of the fabrication of fuel subassemblies for the supercritical-water reactor, the limited ductility of stainless steel-UO₂ fuel sheet made the fabrication of corrugated-flat-plate-type subassemblies impractical. A fabricable MTR-type assembly, 5/8 in. square and 30 in. long, was developed. Methods for edge cladding fuel sheet were developed and a brazing alloy, GE-75, was found to be corrosion resistant in supercritical water.
Date: August 16, 1954
Creator: Keeler, J. R. & Hare, Alan W.

Magnetic Acceleration of a Plasma by a Rail Source

Description: Abstract: "Two parallel wires close together with an arc between them form a hairpin-type of current configuration which should magnetically propel the plasma of the arc. By the time-of-flight measurements with probes it has been demonstrated that directed translational energies of 290 ev can be imparted to deuterons in a plasma produced by a high-current pulsed arc at the tips of two titanium wires loaded with deuterium. It is believed that three deuterons are actually magnetically propelled."
Date: March 18, 1955
Creator: Bostick, Winston H.

Li⁶ and Li⁷ (n. 2n) Cross Sections at 14.1 Mev

Description: Abstract: "An absolute measurement of the 14.1-Mev (n, 2n) cross sections of Li-6 and Li-7 has been made using the large scintillator technique, resulting in cross sections in barns of 0.070 +/- 0.006 and 0.056 +/- 0.005 for Li-6 and Li-7, respectively."
Date: May 29, 1958
Creator: Ashby, V. J.; Catron, H. C.; Newkirk, Lester L.; Taylor, C. J. & Williamson, M. A.

Grain Refinement of the As-Cast Uranium-5 w/o Chromium Alloy by Ternary Additions

Description: Abstract: "Refinement of grain size of the base uranium-chromium eutectic alloy (uranium-5 w/o chromium) by ternary additions is discussed. Thirteen additions to the base alloy were investigated, and three additions were found to exhibit worthwhile grain-refinement tendencies. The three alloys, uranium-5 w/o chromium-0.2 w.o molybdenum, uranium-5 w/o chromium-0.2 w/o germanium, and uranium-5 w/o chromium-0.2 w/o niobium, were heat treated to produce final grain-size structures of between 0.015 and 0.033 mm."
Date: July 5, 1955
Creator: Saller, Henry A.; Dickerson, Ronald F.; Murr, William E. & Bauer, Arthur A.

Transient Temperature Variations During the Self-Heating of a Plasma by Thermonuclear Reactions

Description: Abstract: "The possibility of transient temperature variations during the self-heating of a plasma by thermonuclear reactions was investigated. Calculations were performed on an IBM Card Program Calculator. Estimates of the time scale for self-heating were obtained. It was concluded that it would be unsafe to assume that the nuclear temperature is always equal to or greater than the electron temperature in a discussion of plasma instabilities for a plasma with 10 percent or greater tritium concentration."
Date: March 21, 1955
Creator: Greyber, Howard D.

Energetic Neutral Injection into Thermonuclear Machines

Description: Abstract: "A scheme is discussed in which D+ ions would be accelerated to about 100 kev in a conventional accelerator, then be sent through a gas target frmo which about half the ions would emerge neutral with very little scattering or energy loss; the neutral beam would then cross into a magnetic field and part of the atoms would be ionized and trapped by colliding with the already trapped ions. The smallest mirror machine with a central field of 30-40 kilogauss, 2;1 mirror ratio and β = 01 to 0.5 that would trap most of the neutral beam in the steady state, would be about a meter in diameter and require the order of hundreds of amperes of D+ ions into the neutralizer. The smallest stellerator with a field of 30 kilogauss and β = 0.1 that would trap most of the neutral beam would be about a meter long and require about 10 amperes of D+ ions. A preliminary mirror machine experiment that might be done using the 1/2-ampere, 100-kev D+ beam from the UCRL spare MTA injector is discussed. A method of starting these machine is discussed."
Date: August 10, 1955
Creator: Lauer, Eugene J.

Evaluation and Consolidation of Electrolytic Thorium

Description: Abstract: "Sound, fabricable ingots of thorium were produced by triple are melting of electrolytic thorium. Consumable electrodes were fabricated by tack welding of cold-pressed and vacuum-sintered bars of the granular thorium electrodeposited from a molten-salt bath. The hydrogen content of the electrodeposited material was reduced from 80 to 4 ppm by vacuum sintering at 1250 C at pressures below 1 x 10-(-3) mm of mercury. Both sodium and chlorine content were reduced during melting; sodium from 250 to 25 ppm and chlorine from 1000 to 30 ppm. Oxygen and HCl acid-insoluble contents increased during sintering and melting. Oxygen content increased from 0.35 to 0.50 w/o and HCl acid-insoluble content from 0.8 to 4.0 w/o. A starlike includion revealed by metallographic examination of the as-cast thorium was identified as ThO2."
Date: June 15, 1955
Creator: Saller, Henry A.; Dickerson, Ronald F. & Foster, Ellis L.

An Exact Analysis of Limited Plane Plasma in a Magnetic Field

Description: Introduction: "Prior analyses of a plasma in a magnetic field have been limited, as far as the writer is aware, to cases in which the relative change in field over the orbital distance and the relative change in ion concentration are both small, or in which the relations have been viewed in a purely hydrodynamical way. The first approach excludes cases which can be of considerable interests, for it fails near a plasma edge. The second loses all sight of the structure imposed by the orbital motions."
Date: December 2, 1954
Creator: Tonks, Lewi, 1897-1971

Energy Transfer Between Modified Maxwell Distributions

Description: Abstract: "A particularly conventional modified form of Maxwell distribution is chosen. The modified expressions for (a) the energy transfer from the ions to the electrons in a plasma and (b) the brehmestrahlung from the electrons are calculated. Using the expressions some possible steady-state conditions for the ion and electron gases are derived and compared with those for the usual Maxwell distributions."
Date: September 20, 1956
Creator: Greyber, Howard D. & Bing, G.

The Elimination of Microwave Reflections

Description: Abstract: "The reflections of microwaves from the walls of a plasma-containing vessel are studied. The probable cause of the reflections is discussed, and several suggestions are made for eliminating the reflections from the waveguide in the vessel and particularly from the pyrex vessel wall and copper tubing surrounding the pyrex. Quarter-wave-thick carbon-filled plastics or glasses having a very low vapor pressure room most promising when placed inside the pyrex cylinder. BaTiO3 appears to be an excellent material when placed outside the vacuum."
Date: February 1, 1955
Creator: Beard, David

Mechanical Properties of Zirconium and Zirconium-Uranium Alloys Containing Tin

Description: Abstract: "The mechanical properties of a large number of zirconium alloys have been investigated. These alloys include zirconium-tin and zirconium-tin-uranium. Tensile tests have been run on these alloys at room temperature, 500 F, and 600 F. Hot-hardness data have been obtained from room temperature to 1600 F, with particular emphasis on the hot-rolling range. Creep tests and fatigue tests have been run on a number of zirconium-tin alloys at 500 F."
Date: September 29, 1952
Creator: Schwope, A. D.; Muehlenkamp, G. T. & Chubb, Walston