UNT Libraries Government Documents Department - 160 Matching Results

Search Results

Preliminary Appraisal of the Carnotite Resources of the Carrizo Mountains Area, San Juan County, New Mexico, and Apache County, Arizona

Description: From introduction: A rapid appraisal of the carnotite resources of the Salt Wash sandstone member of the Morrison formation in the Carrizo Mountains area was undertaken by the U. S. Geological Survey late in 1951 in connection with its current project of geologic mapping of the area. Though brief and preliminary, this report provides a summary of production trends and estimated reserves in the area and indicates as far as possible the total potential of the area as a source of uranium. This information may be helpful in planning new milling facilities or other measures to encourage a higher rate of production.
Date: May 1952
Creator: Strobell, J. D., Jr.

Mechanical Properties of Zirconium and Zirconium-Uranium Alloys Containing Tin

Description: Abstract: "The mechanical properties of a large number of zirconium alloys have been investigated. These alloys include zirconium-tin and zirconium-tin-uranium. Tensile tests have been run on these alloys at room temperature, 500 F, and 600 F. Hot-hardness data have been obtained from room temperature to 1600 F, with particular emphasis on the hot-rolling range. Creep tests and fatigue tests have been run on a number of zirconium-tin alloys at 500 F."
Date: September 29, 1952
Creator: Schwope, A. D.; Muehlenkamp, G. T. & Chubb, Walston

Mechanical Properties of Zirconium and Zirconium-Uranium Alloys Containing Tin

Description: Abstract: "The mechanical properties of a large number of zirconium alloys have been investigated. These alloys include zirconium-tin and zirconium-tin-uranium. Tensile tests have been run on these alloys at room temperature, 500 F, and 600 F. Hot-hardness data have been obtained from room temperature to 1600 F, with particular emphasis on the hot-rolling range. Creep tests and fatigue tests have been run on a number of zirconium-tin alloys at 500 F."
Date: September 29, 1952
Creator: Schwope, A. D.; Muehlenkamp, G. T. & Chubb, Walston

The Ductility of Brazed Stainless Steel Joints

Description: Abstract: "The ductility of Type 310 stainless steel T-joints brazed with GE-62 brazing alloy was measured at room temperatures 1200, 1650, and 1800 F. The measure of ductility was taken as the plastic axial strain required to crack braze fillets in T-section tensile specimens. At elevated temperatures, the ductility of as-brazed joints approximated that of the stainless steel, but at room temperature the brazed joints had only one-tenth the ductility of the base metal. Annealing for 16 hr at 1800 F in air was found to triple the room-temperature ductility of the brazed joint."
Date: July 8, 1953
Creator: Saller, Henry A.; Stacy, J. T. & Eddy, N. S.

The Fabrication of Subassemblies for the Supercritical-Water Reactor

Description: In studies of the fabrication of fuel subassemblies for the supercritical-water reactor, the limited ductility of stainless steel-UO₂ fuel sheet made the fabrication of corrugated-flat-plate-type subassemblies impractical. A fabricable MTR-type assembly, 5/8 in. square and 30 in. long, was developed. Methods for edge cladding fuel sheet were developed and a brazing alloy, GE-75, was found to be corrosion resistant in supercritical water.
Date: August 16, 1954
Creator: Keeler, J. R. & Hare, Alan W.

The Effects of Chemical Impurities on the Quality of Rolled Uranium Rod

Description: Abstract: "Thirty-four uranium ingots containing controlled amounts of carbon, nitrogen, and Mgl2 slag were cast, rolled, and examined to investigate the relation between these impurities and the quality of the rolled rod. Carbon in concentrations up to 1400 ppm and nitrogen up to 170 ppm, either singly or in combination, had no significant effect on the number of defects observed in the rolled rod. The quality of the rods, however decreased with increasing amount of slag necessary to cause observable differences in the rod could not be detected on analysis, but was visible in the microstructure."
Date: October 1, 1954
Creator: Saller, Henry A.; Keeler, J. R. & Cuddy, L. J.

Measurement of the Behavior of a Plasma in a Magnetic Field by Means of Probes

Description: Abstract: "Probes were used to measure certain properties of the cloud of positive ions and electrons ejected from a pulsed ion source having two hydrogen-loaded electrodes. Time-of-flight measurements show: the presence of H+ ions with 50 ev directed energy; an increase of this energy with increasing pulse current in the source; a higher peak yield of ions with higher peak currents in the source; and higher yields and higher ion energies up to 110 ev have been recorded with the use of a pulsed magnetic field impressed upon the source. The neutral positive ion-electron beam from the source has been projected against an increasing magnetic field and the reflected and transmitted signals have been recorded and compared as a function of the magnetic field. Probe signals from the plasma as it encounters the magnetic field are oscillatory, suggesting that magnetohydrodynamic phenomena are presented."
Date: December 1, 1954
Creator: Bostick, W. H.; Zizzo, S. G. & Cook, Buford

An Exact Analysis of Limited Plane Plasma in a Magnetic Field

Description: Introduction: "Prior analyses of a plasma in a magnetic field have been limited, as far as the writer is aware, to cases in which the relative change in field over the orbital distance and the relative change in ion concentration are both small, or in which the relations have been viewed in a purely hydrodynamical way. The first approach excludes cases which can be of considerable interests, for it fails near a plasma edge. The second loses all sight of the structure imposed by the orbital motions."
Date: December 2, 1954
Creator: Tonks, Lewi, 1897-1971

Bonding of uranium to uranium

Description: From abstract: "Some mechanical properties of uranium joined to uranium by means of sinter welding described. The types of uranium investigated were powdered and cast material. Comparison of results obtained by the testing of the whole and joined material are presented. Although the joined material to date does not possess strength of the whole material, the results are promising. Work is continuing."
Date: 1955
Creator: Hum, Jack K. Y.