UNT Libraries Government Documents Department - 439 Matching Results

Search Results

Results: 1 - 24 next
open access

Acceleration of high-pressure-ratio single-spool turbojet engine as determined from component performance characteristics 1: effect of air bleed at compressor outlet

Description: From Summary: "An analytical investigation was made to determine from component performance characteristics the effect of air bleed at the compressor outlet on the acceleration characteristics of a typical high-pressure-ratio single-spool turbojet engine. Consideration of several operating lines on the compressor performance map with two turbine-inlet temperatures showed that for a minimum acceleration time the turbine-inlet temperature should be the maximum allowable, and the operating line on… more
Date: March 10, 1953
Creator: Rebeske, John J., Jr. & Rohlik, Harold E.
Item Type: Refine your search to only Report
open access

An active particle diffusion theory of flame quenching for laminar flames

Description: An equation for quenching distance based on the destruction of chain carriers by the surface is derived. The equation expresses the quenching distance in terms of the diffusion coefficients and partial pressures of the chain carriers and gas phase molecules, the efficiency of the surface as a chain breaker, the total pressure of the mixture, and a constant which depends on the geometry of the quenching surface. Quenching distances measured by flashback for propane-air flames are shown to be con… more
Date: March 4, 1952
Creator: Simon, Dorothy M. & Belles, Frank E.
Item Type: Refine your search to only Report
open access

Additional Abstracts Pertaining to Seaplanes

Description: "About 500 additional references pertaining to hydrodynamic design of seaplanes have been compiled, and the information is presented in the form of abstracts classified under six main headings:GENERAL INFORMATION, HYDROSTATICS, HYDRODYNAMICS, AERODYNAMICS, OPERATION, and RESEARCH. The compilation is an extension of NACA RM No. L6I13, entitled "Abstracts Pertaining to Seaplanes," by Jerold M. Bidwell and Douglas A. King. An author index and a subject index are included" (p. 1).
Date: March 9, 1948
Creator: Bidwell, Jerold M. & King, Douglas A.
Item Type: Refine your search to only Report
open access

Aerodynamic and inlet-flow-field characteristics at a free-stream Mach number of 3.0 for airplanes with circular fuselage cross sections and for two engine locations

Description: Report presenting an experimental investigation of several airplane configurations at Mach 3.0 in a continuous flow tunnel. The configurations had circular fuselage cross sections and a sweptback wing and either two nacelles or two side inlets.
Date: March 18, 1958
Creator: Dryer, Murray & Luidens, Roger W.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics at transonic and supersonic speeds of a rocket-propelled airplane configuration having a 52.5 degree delta wing and a low, swept horizontal tail

Description: Report presenting a flight investigation over a range of Mach numbers to determine the aerodynamic characteristics at low lift of a rocket model of an airplane with a 52.5 degree delta wing of aspect ratio 3.08 and NACA 65A003 airfoil sections in the streamwise direction and a low, swept horizontal tail. Results regarding the longitudinal trim, lift, drag, longitudinal static stability, damping in pitch, and directional static stability are provided.
Date: March 29, 1954
Creator: Kehlet, Alan B.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics including effects of wing fixes of a 1/20-scale model of the Convair F-102 airplane at transonic speeds

Description: From Introduction: "Results from the tests in the Langley 4- by 4-foot supersonic pressure tunnel at Mach numbers of 1.61 and 2.01 are presented in reference 1. Reported herein are results obtained from the tests in the Langley 8-foot transonic tunnel of the model with no control deflections at Mach numbers 0.6 to 1.12 for angles of attack up to 34^o
Date: March 18, 1954
Creator: Osborne, Robert S. & Wornom, Dewey E.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics of a 6-percent-thick symmetrical double-wedge airfoil at transonic speeds from tests by the NACA wing-flow method

Description: From Introduction: "The investigation covered a range of Mach numbers from 0.66 to 1.12 and included measurements of angle of attack, pitching moment, normal force, and chord force. The drag at zero lift obtained in this investigation was reported in reference 1, but without the correction for tare of the end plate."
Date: March 4, 1949
Creator: Lina, Lindsay J.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics of a canard and an outboard-tail airplane model at a Mach number of 2.01

Description: From Introduction: "In order to obtain some insight into the relative merits of canard and outboard-tail control systems at supersonic speeds, a preliminary investigation of a generalized canard and outboard-tail model has been conducted in the Langley 4- by 4-foot supersonic pressure tunnel at a Mach number of 2.01 and the results are presented herein."
Date: March 24, 1958
Creator: Spearman, M. Leroy & Robinson, Ross B.
Item Type: Refine your search to only Report
open access

Aerodynamic Characteristics of a Circular Cylinder at Mach Number 6.86 and Angles of Attack Up to 90 Degrees

Description: "Pressure-distribution and force tests of a circular cylinder have been made in the Langley 11-inch hypersonic tunnel at a Mach number of 6.86, a Reynolds number of 129,000 based on diameter, and angles of attack up to 90 degrees. The results are compared with the hypersonic approximation of Grimminger, Williams, and Young and with a simple modification of the Newtonian flow theory. The comparison of experimental results shows that either theory gives adequate general aerodynamic characteristic… more
Date: March 11, 1954
Creator: Penland, Jim A.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics of a full-span trailing-edge control on a 60 degree delta wing with and without a spoiler at Mach number 1.61

Description: Report presenting an investigation at Mach number 1.61. to determine the aerodynamic characteristics of a full-span trailing-edge control on a 60 degree delta wing with and without a partial-span spoiler mounted on the wing just ahead of the control. Pressure distribution and hinge-moment measurements were made over a range of angles of attack and control deflection. Results indicated that regions of increase pressure due to flow separation ahead of the control at the larger control deflections… more
Date: March 10, 1954
Creator: Lord, Douglas R. & Czarnecki, K. R.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics of a wing with unswept quarter-chord line, aspect ratio 2, taper ratio 0.78, and NACA 65A004 airfoil section: transonic-bump method

Description: From Introduction: "This paper presents the results of an investigation of force and moment characteristics for a wing with an unswept quarter-chord line, aspect ratio 2, taper ratio 0.78, and an NACA 65A004 airfoil section parallel to the free stream."
Date: March 8, 1950
Creator: Polhamus, Edward C. & Campbell, George S.
Item Type: Refine your search to only Report
open access

Aerodynamic Characteristics of Three Deep-Stepped Planing-Tail Flying-Boat Hulls

Description: "An investigation was made in the Langley 300 MPH 7- by 10-foot tunnel to determine the aerodynamic characteristics of three deep-stepped planing-tail flying-boat hulls differing only in the amount of step fairing. The hulls were derived by increasing the unfaired step depth of a planing-tail hull of a previous aerodynamic investigation to a depth about 92 percent of the hull beam. Tests were also made on a transverse-stepped hull with an extended afterbody for the purpose of comparison and in … more
Date: March 13, 1947
Creator: Riebe, John M. & Naeseth, Rodger L.
Item Type: Refine your search to only Report
open access

Aerodynamic loadings associated with swept and unswept spoilers on a flat-plate at Mach numbers of 1.61 and 2.01

Description: Report presenting an investigation at two Mach numbers to examine the flow, force, and moment characteristics associated with spoilers mounted on a flat plate at a range of sweep angles. Pressure measurements were obtained over the plate and spoiler faces. The pressures were integrated to determine the spoiler lift, pitching-moment, drag, and hinge-moment characteristics.
Date: March 12, 1956
Creator: Lord, Douglas R. & Czarnecki, K. R.
Item Type: Refine your search to only Report
open access

Air-flow and thrust characteristics of several cylindrical cooling-air ejectors with a primary to secondary temperature ratio of 1.0

Description: Report presenting an investigation to determine the performance of 17 cooling-air ejectors at primary-jet pressure ratios from 1 to 10, secondary pressure ratios to 4.0, and a temperature ratio of unity. Results regarding pumping characteristics, effect of spacing ratio on pumping, effect of diameter ratio on pumping, thrust characteristics, effect of spacing ratio on thrust, effect of diameter ratio on thrust, comparison of cylindrical and conical ejectors, comparison of performance with small… more
Date: March 6, 1953
Creator: Greathouse, W. K. & Hollister, D. P.
Item Type: Refine your search to only Report
open access

An air-flow-direction pickup suitable for telemetering use on pilotless aircraft

Description: From Summary: Test results are presented which indicate that the pickup is aerodynamically stable and has accuracy, obtained from a bench calibration, of better than 0.3^o under conditions including acceleration up to 20g in any direction, Mach numbers from 0.5 to 2.8, and dynamic pressures up to at least 65 psi. Equations and curves which can be used to obtain flow direction at the center of gravity of a maneuvering model are presented."
Date: March 10, 1954
Creator: Ikard, Wallace L.
Item Type: Refine your search to only Report
open access

Aircraft configurations developing high lift-drag ratios at high supersonic speeds

Description: From Introduction: "Range in more or less steady level flight depends directly on aerodynamic lift-drag ratio at high supersonic speeds, just as it does at lower speeds. This result follows from the classical Breguet range equation in the case of powered flight, and it may be easily deduced from the equations of motion for unpowered or gliding flight (see refs. 1 and 2)."
Date: March 5, 1956
Creator: Eggers, A. J., Jr. & Syvertson, Clarence A.
Item Type: Refine your search to only Report
open access

Altitude Acceleration Investigation of the RA-14 Avon Turbojet Engine

Description: As a part of this investigation, the acceleration characteristics of the engine, using the standard engine fuel-control system, were obtained for conditions simulating flight at altitudes of 35,000 and 50,000 feet with a flight Mach number of 0.4. Rapid and wave-off type accelerations were made at each flight condition, and the transient performance of the engine was recorded with a multiple-channel oscillograph. The parameters are presented graphically in the form of time histories, augmented … more
Date: March 13, 1956
Creator: Russey, Robert E.
Item Type: Refine your search to only Report
open access

Altitude performance and operational characteristics of an XT38-A-2 turboprop engine

Description: From Introduction: "Reported herein are the over-all engine performance and the starting and windmilling characteristics. Data are presented in the form of performance maps at each flight condition to show the effects of altitude and flight Mach number on various engine-performance variables. The effect of engine deterioration with operating time on performance is also discussed."
Date: March 12, 1954
Creator: Essig, R. H. & Schulze, F. W.
Item Type: Refine your search to only Report
open access

Altitude performance evaluation of J71-A-11 turbojet engine

Description: From Summary: "Data were obtained with five exhaust-nozzle areas and with the variable-area exhaust nozzle interlinked with the control system at conditions simulating flight at a Mach number of 0.8 and altitudes of 35,00 and 45,000 feet. Data simulating operation at zero flight Mach number at an altitude of 15,000 feet are also included. Engine component performance data are presented in addition to the overall engine performance."
Date: March 30, 1956
Creator: Useller, James W. & Pappas, George E.
Item Type: Refine your search to only Report
open access

Altitude performance of compressor, turbine, and combustor components of 600-B9 turbojet engine

Description: From Introduction: "The purpose of this report is (1) to describe the performance of each component over a range of altitudes, (2) to show the effect of flight conditions on operating point of each component, and (3) to summarize briefly the effects of changes in component performance with flight condition on the over-all engine performance."
Date: March 15, 1954
Creator: Prince, William R. & Wile, Dorwin B.
Item Type: Refine your search to only Report
open access

Altitude-Wind-Tunnel Investigation of R-4360-18 Power-Plant Installation for XR60 Airplane, 3, Performance of Induction and Exhaust Systems

Description: From Summary: "A study has been made of the performance of the induction and the exhaust systems on the XR60 power-plant installation as part of an investigation conducted in the Cleveland altitude wind tunnel. Altitude flight conditions from 5000 to 30,000 feet were simulated for a range of engine powers from 750 to 3000 brake horsepower."
Date: March 28, 1947
Creator: Dupree, David T. & Hawkins, W. Kent
Item Type: Refine your search to only Report
Back to Top of Screen