UNT Libraries Government Documents Department - 101 Matching Results

Search Results

open access

25 content of initial lots of Hanford UO{sub 3}

Description: At the time the first UO{sub 3} from so-called ``full-level`` Redox runs was shipped from 224U, the % U{sub 235} as determined in 222-S appeared high when compared with theoretical values from the burn-out curve. Close agreement between the 222-S results and % U{sub 235} determined by K-25 on lots 007, 008, and 009, however, indicated that a considerable heel of cold uranium in Redox had been blended with the first ``full level`` material. This explanation has been verified by data collected ov… more
Date: May 28, 1952
Creator: Work, J. B.
open access

Aerodynamic characteristics of two-plane, unswept tapered wings of aspect ratio 3 and 3-percent thickness from tests on a transonic bump

Description: From Introduction: "The Ames Aeronautical Laboratory has in progress an experimental investigation of the aerodynamic characteristics of wings of interest in the design of high-speed fighter aircraft. This program included an investigation in the Ames 6-by 6-foot supersonic wind tunnel at both subsonic and supersonic Mach numbers of a wing-body combination having a 3-percent-thick, unswept, tapered wing with circular-arc sections and an aspect ratio of 3.1 (reference 1).
Date: May 2, 1952
Creator: Emerson, Horace F. & Gale, Bernard M.
open access

Aerodynamic Loading Characteristics of a Wing-Fuselage Combination Having a Wing of 45 Degrees Sweepback Measured in the Langley 8-Foot Transonic Tunnel

Description: Report presenting an investigation of the aerodynamic loading characteristics of a wing-fuselage combination in the slotted test section of the transonic tunnel. The test was part of a systematic investigation of the effects of varying the amount of sweepback on wings in order to determine their suitability for transonic flight. Results regarding span load characteristics, normal-force characteristics, wing-tip angle of twist, spanwise distribution of section pitching-moment coefficient, pitchi… more
Date: May 19, 1952
Creator: Loving, Donald L. & Williams, Claude V.
open access

Aerodynamics of slender bodies at Mach number of 3.12 and Reynolds numbers from 2 x 10(exp 6) to 15 x 10(exp 6) 2: aerodynamic load distributions of series of five bodies having conical noses and cylindrical afterbodies

Description: Report presenting an experimental investigation to determine the aerodynamic load distributions of a series of five bodies with conical or slightly blunted noses and cylindrical afterbodies in the 1- by 1-foot supersonic wind tunnel. Pressure distributions and viscous drags were measured at Mach number 3.12 for a range of Reynolds numbers and angles of attack.
Date: May 8, 1952
Creator: Jack, John R. & Gould, Lawrence I.
open access

Aircraft Nuclear Propulsion Project Quarterly Progress Report for Period Ending March 10, 1952

Description: This quarterly progress discusses the ongoing work at the Oak Ridge National Laboratory for the quarter ending in March 10, 1952. Topics discussed include reactor theory and design, shielding research, materials research, and includes appendixes with supplemental information.
Date: May 7, 1952
Creator: Briant, R. C.; Miller, A. J. & Cottrell, William B.
open access

Altitude performance investigation of two flame-holder and fuel-system configurations in short afterburner

Description: From Introduction: "The results of this complete evaluation of the altitude performance and operational characteristics of the two types of flame-holder and fuel-system configurations are reported herein.The starting limits of both configurations at a flight Mach number of 0.6 are also discussed."
Date: May 6, 1952
Creator: Huntley, S. C. & Wilsted, H. D.
open access

Aluminium Corrosion in High Purity Water

Description: Summary: "A corrosion test of aluminum components in a 4-ft. section of a fuel tube has been tested under conditions simulating plant geometry and, as nearly as possible, the operating conditions of water purity, temperature, and flow rate. Results: 1. None of the aluminum components, 63S fuel tube, 2S solid fillers and 43S spacers showed any corrosion effects beyond normal oxide film formation. This was carried out in flowing water, maintained at a specific resistivity greater than 1 x 10(… more
Date: May 1952
Creator: Nielsen, N. A.
open access

Analysis of a liquid-metal turbine-propeller cycle for propulsion of low-speed nuclear- powered aircraft

Description: From Introduction: "The intermediate subsonic speed range is considered and the liquid-metal turbine-propeller cycle discussed in this report. In this report, compressor pressure ratio, heat-exchanger air-inlet Mach number, and turbine-inlet temperature were optimized for maximum engine net thrust per engine-plus-heat exchanger weight (minimum airplane gross weight) for a range of heat-exchanger effective wall temperature."
Date: May 27, 1952
Creator: Rom, F. E. & Wachtl, W. W.
open access

Analysis of a liquid-metal turbine-propeller cycle for propulsion of low-speed nuclear-powered aircraft

Description: From Introduction: "The intermediate subsonic speed range is considered and the liquid-metal turbine-propeller cycle discussed in this report. In this report, compressor pressure ratio, heat-exchanger air-inlet Mach number, and turbine-inlet temperature were optimized for maximum engine net thrust per engine-plus-heat-exchanger weight (minimum airplane gross weight) for a range of heat-exchanger effective wall temperature."
Date: May 27, 1952
Creator: Wachtl, William W. & Rom, Frank E.
open access

Analysis of a Pneumatic Probe for Measuring Exhaust-Gas Temperatures with Some Preliminary Experimental Results

Description: "A pneumatic probe based on continuity of mass flow through two restrictions separated by a cooling chamber was constructed to measure gas temperature at and beyond the limit of thermocouples. This probe consisted of a subsonic flat-plate orifice for the first restriction and a sonic-flow converging-diverging nozzle for the second restriction. The effect of variation in gas constants on the calibration is examined for common engine-exhaust gases" (p. 1).
Date: May 21, 1952
Creator: Scadron, Marvin D.
open access

Boundary Disturbances in High Explosive Shock Tubes

Description: From abstract: High velocity disturbances are observed to propagate along the walls of a high explosive operated shock tube in advance of the plane shock. Experiments are presented which determine the dependence of the geometry, energy, and velocity of the disturbance on such variables as the gas contained in the shock tube, the shock strength, and the roughness and composition of the supporting boundary. A model is constructed to explain the flow within the disturbance. Arguments are presented… more
Date: May 26, 1952
Creator: Shreffler, R. G. & Christian, R. H.
open access

Calculations on U235 Fission Product Decay Chains

Description: Report of equations for calculating decay of U235. The introduction states" Calculations have been made on the U235 fission product decay schemes. The results for a typical example, that of a reactor operating at 1000 kilowatts for 180 days, have been tabulated and graphed. General formulae have been used so that the results can be applied for any power level and any time of irradiation" (p. 2).
Date: May 1952
Creator: Faller, I. L.; Chapman, T. S. & West, J. M.
open access

Calibration of AWS instrument shelter in Langley 300 MPH 7- by 10-foot tunnel

Description: From Summary: "Tests and calibrations of an AWS instrument shelter were made in the Langley 300 MPH 7- by 10-foot tunnel for the Signal Corps, U.S. Army. The behavior of the wind vane, the 3-cup anemometer, and the shelter cover was determined in wind speeds up to 150 miles per hour. It was discovered that the rotational speed of the anenometer was greatly influenced by the location, with respect to the wind direction, of three spacer posts that held two upper bays of instruments above the anen… more
Date: May 12, 1952
Creator: McKee, John W.
open access

The Colorimetric Determination of Total Iron With O-Phenanthroline

Description: From Abstract: "A study of the critical factors in the colorimetric determination of total iron in silicate and phosphate rocks, and in other nonmetallic materials is presented. It was desired to ascertain the wavelength of maximum absorbancy, the optimum concentration range for iron, the effect of different substances on the ferrous-o-phenanthroline system, and reproducibility of results."
Date: May 1952
Creator: Cuttitta, Frank
open access

Critical mass studies of plutonium solutions

Description: The chain reacting conditions for plutonium nitrate in water solution have been examined experimentally for a variety of sizes of spheres and cylinders. The effects on the critical mass of the displacement of hydrogen and the addition of poisons to the fuel were measured in water tamped and bare reactors. In this report the data obtained in the investigation is presented graphically and in tables. Some preliminary analysis has been made yielding the results: (i) the absorption cross-section of … more
Date: May 19, 1952
Creator: Kruesi, F. E.; Erkman, J. O. & Lanning, D. D.
open access

The Determination of Rare Earths in Thorium

Description: Abstract: "A quantitative method for the determination of individual rare earths in thorium down to a level of 0.05 ppm, is described. The procedure consists of a chromatographic cellulose-columns separation followed by a solution-type spectrographic determination. Values are given for the recovery of a number of rare earths using this combined procedure."
Date: May 15, 1952
Creator: Center, E. J.; Henry, W. M. & Householder, R. D.
open access

The Effect of an Operating Propeller on the Aerodynamic Characteristics of a 1/10-Scale Model of the Lockheed XFV-1 Airplane at High Subsonic Speeds (TED No. NACA DE-377)

Description: "An investigation was conducted in the Ames 12-foot pressure wind tunnel to determine the effect of an operating propeller on the aerodynamic characteristics of a 1/19-scale model of the Lockheed XFV-1 airplane. Several full-scale power conditions were simulated at Mach numbers from 0.50 to 0.92; the.Reynolds number was constant at 1.7 million. Lift, longitudinal force, pitch, roll, and yaw characteristics, determined with and without power, are presented for the complete model and for various … more
Date: May 6, 1952
Creator: Sutton, Fred B. & Buell, Donald A.
Back to Top of Screen