UNT Libraries Government Documents Department - 35,725 Matching Results

Search Results

open access

0-D study of the compression of low temperature spheromaks

Description: Compression of low temperature spheromak plasmas has been studied with the aid of a O-D two-fluid computer code. It is found that in a plasma which is radiation dominated, the electron temperature can be increased by up to a factor of seven for a compression of a factor of two, provided the temperature is above some critical value (approx.25eV) and the electron density particle confinement time product n/sub e/tau/sub p/ greater than or equal to 1 x 10/sup 9/s/cm/sup 3/. If the energy balance i… more
Date: September 1, 1985
Creator: Meyerhofer, D. D.; Hulse, R. A. & Zweibel, E. G.
open access

1,3-Propanediol Made From Fermentation-Derived Malonic Acid: Office of Industrial Technologies (OIT) Agriculture Project Fact Sheet

Description: 1,3-Propanediol is one of two ingredients used in producing polytrimethylene terephthalate (PTT), a polymer which can be used in polyester and nylon applications. Researchers are developing a process to ferment biomass feedstock to malonic acid using filamentous fungi and then catalytically convert malonic acid to 1,3-propanediol.
Date: September 12, 2001
Creator: Carde, T.
open access

1.8.3 Site system engineering FY 1997 program plan

Description: The FY 1997 Multi-Year Work Plan (MYWP) technical baseline describes the functions to be accomplished and the technical standards that govern the work. The following information is provided in this FY 1997 MYWP: technical baseline, work breakdown structure, schedule baseline, cost baseline, and execution year.
Date: September 13, 1996
Creator: Grygiel, M. L.
open access

1. 8K conditioning (non-quench training) of a model SSC dipole

Description: The accepted hypothesis is that training quenches are caused by heat generation when conductors move under Lorentz force. Afterwards no conductor motion will occur until a higher field and greater Lorentz force acts. If superior heat transfer and/or greater temperature margin is provided by operating at lower bath temperature, one might expect that the heat generated by conductor motion will not cause a runaway temperature increase, or quench. To test this hypothesis, the central dipole field i… more
Date: September 1, 1986
Creator: Gilbert, W. S. & Hassenzahl, W. V.
open access

1-GeV Linac Upgrade Study at Fermilab

Description: A linac injector for a new proton source complex at Fermilab is assumed to have a kinetic energy of 1 GeV. This linac would be sized to accelerate 100 mA of H{sup -} beam in a 200 microsecond pulse at a 15 Hz repetition rate. This would be adequate to produce {approximately}10{sup 14} protons per pulse allowing for future improvements of the new proton source complex. An alternate proposal is to add 600 MeV of side coupled cavity linac at 805 MHz to the existing 400 MeV Linac. This addition may… more
Date: September 1998
Creator: Popovic, M.; Moretti, A.; Noble, R. & Schmidt, C. W.
open access

1-GWh diurnal load-leveling Superconducting Magnetic Energy Storage system reference design

Description: A point reference design has been completed for a 1-GWh Superconducting Magnetic Energy Storage system. The system is for electric utility diurnal load-leveling but can also function to meet much faster power demands including dynamic stabilization. This study explores several concepts of design not previously considered in the same detail as treated here. Because the study is for a point design, optimization in all respects is not complete. This report examines aspects of the coil, the superco… more
Date: September 1, 1979
Creator: Rogers, J. D.; Hassenzahl, W. V. & Schermer, R. I. (comps.)
open access

1-GWh diurnal load-leveling superconducting magnetic energy storage system reference design. Appendix A: energy storage coil and superconductor

Description: The technical aspects of a 1-GWh Superconducting Magnetic Energy Storage (SMES) coil for use as a diurnal load-leveling device in an electric utility system are presented. The superconductor for the coil is analyzed, and costs for the entire coil are developed.
Date: September 1, 1979
Creator: Schermer, R.I.
open access

1-GWh diurnal load-leveling superconducting magnetic energy storage system reference design. Appendix B: cost study, high-purity aluminum production

Description: Cost information is supplied for aluminum with purities of 200, 2000, and 5000 residual resistivity ratio. Two production situations were used for each purity: (1) 1 x 10/sup 6/ kg/yr production rate with a 30-yr sustaining market and (2) 1 x 10/sup 6/ kg/yr production rate for 2 yrs only. These productions and purities are of interest for manufacturing devices for Superconducting Magnetic Energy Storage. The cost study results are presented as a range and include (1) the selling price of the a… more
Date: September 1, 1979
Creator: Cochran, C. N.; Dawless, R. K. & Whitchurch, J. B.
open access

1-GWh diurnal load-leveling superconducting magnetic energy storage system reference design. Appendix C: dewar and structural support

Description: The mechanical aspects of the dewar to contain a 1-GWh superconducting coil in a 1.8 K helium bath and the means for supporting the coil and dewar against the rock of an underground excavation created for just that purpose are presented.
Date: September 1, 1979
Creator: Bennett, J. G. & Ju, F. D.
open access

1-GWh diurnal load-leveling superconducting magnetic energy storage system reference design. Appendix D: superconductive magnetic energy storage cavern construction methods and costs

Description: The excavation and preparation of an underground cavern to contain a 1-GWh diurnal load-leveling Superconducting Magnetic Energy Storage (SMES) unit is examined. The cavern's principal function is to provide a rock structure for supporting the magnetic forces from the charged storage coil. Certain economic considerations indicate the refrigerator cold box for the helium system should also be underground. The study includes such a provision and considers, among other things, rock bolting, water … more
Date: September 1, 1979
open access

A 2.14 ms candidate optical pulsar in SN1987A: Ten years after

Description: We have monitored Supernova 1987A in optical/near-infrared bands from a few weeks following its birth until the present time in order to search for a pulsar remnant. We have found an apparent pattern of emission near the frequency of 467.5 Hz - a 2.14 ms pulsar candidate, first detected in data taken on the remnant at the Las Campanas Observatory (LCO) 2.5-m Dupont telescope during 14-16 Feb. 1992 UT. We detected further signals near the 2.14 ms period on numerous occasions over the next four y… more
Date: September 1, 1997
Creator: Middleditch, J.; Kristian, J. A.; Kunkel, W. E.; Hill, K. M. & Watson, R. D.
open access

2-D image segmentation using minimum spanning trees

Description: This paper presents a new algorithm for partitioning a gray-level image into connected homogeneous regions. The novelty of this algorithm lies in the fact that by constructing a minimum spanning tree representation of a gray-level image, it reduces a region partitioning problem to a minimum spanning tree partitioning problem, and hence reduces the computational complexity of the region partitioning problem. The tree-partitioning algorithm, in essence, partitions a minimum spanning tree into sub… more
Date: September 1995
Creator: Xu, Y. & Uberbacher, E. C.
open access

2-D Reflectometer Modeling for Optimizing the ITER Low-field Side Reflectometer System

Description: The response of a low-field side reflectometer system for ITER is simulated with a 2?D reflectometer code using a realistic plasma equilibrium. It is found that the reflected beam will often miss its launch point by as much as 40 cm and that a vertical array of receiving antennas is essential in order to observe a reflection on the low-field side of ITER.
Date: September 2, 2005
Creator: Kramer, G. J.; Nazikian, R.; Valeo, E. J.; Budny, R. V.; Kessel, C. & Johnson, D.
open access

2-D skin-current toroidal-MHD-equilibrium code

Description: A two-dimensional, toroidal, ideal MHD skin-current equilibrium computer code is described. The code is suitable for interactive implementation on a minicomptuer. Some examples of the use of the code for design and interpretation of toroidal cusp experiments are presented.
Date: September 1, 1982
Creator: Feinberg, B.; Niland, R. A.; Coonrod, J. & Levine, M. A.
open access

2 MW 110 GHz ECH heating system for DIII-D

Description: A 2 MW 110 GHz ECH system using Varian 0.5 MW gyrotrons is under construction for use on the DIII-D tokamak by late 1991. Most of the components are being design and fabricated at General Atomics, including the gyrotron tanks, superconducting magnets, and transmission line. These components are intended for operation with 10 second pulses and, in the future, with 1 MW gyrotrons. 6 refs., 5 figs.
Date: September 1990
Creator: Moeller, C.; Prater, R.; Callis, R.; Remsen, D.; Doane, J.; Cary, W. et al.
open access

A 2 to 4 nm high power FEL on the SLAC linac

Description: We report the results of preliminary studies of a 2 to 4 nm SASE FEL, using a photoinjector to produce the electron beam, and the SLAC linac to accelerate it to an energy up to 10 GeV. Longitudinal bunch compression is used to increases ten fold the peak current to 2.5 kA, while reducing the bunch length to the subpicosecond range. The saturated output power is in the multi-gigawatt range, producing about 10{sup 14} coherent photons within a bandwidth of about 0.2% rms, in a pulse of several mi… more
Date: September 1, 1992
Creator: Pellegrini, C.; Rosenzweig, J.; Nuhn, H. D.; Pianetta, P.; Tatchyn, R.; Winick, H. et al.
open access

2 x 2 Polyethylene Reflected and Moderated Highly Enriched Uranium System with Rhenium

Description: The 2 × 2 array HEU-Re experiment was performed on the Planet universal critical assembly machine on November 4th, 2003 at the Los Alamos Critical Experiments Facility (LACEF) at Los Alamos National Laboratory (LANL). For this experiment, there were 10 ½ units, each full unit containing four HEU foils and two rhenium foils. The top unit contained only two HEU foils and two rhenium foils. A total of 42 HEU foils were used for this experiment. Rhenium is a desirable cladding material for space nu… more
Date: September 1, 2010
Creator: Ellis, A. Nichole; Hutchinson, Jesson; Bess, John D.; Polyakov, Dmitry N.; Glushkov, Evgeny S. & Glushkov, Alexey E.
open access

3.1.1.2 Feed Processing and Handling DL2 Final Report

Description: This milestone report is the deliverable for our Feed Processing and Handling project. It includes results of wet biomass feedstock analysis, slurry pumping information, fungal processing to produce a lignin-rich biorefinery residue and two subcontracted efforts to quantify the amount of wet biomass feedstocks currently available within the corn processing and paper processing industries.
Date: September 30, 2006
Creator: Elliott, Douglas C.; Magnuson, Jon K. & Wend, Christopher F.
open access

A 3.3 MJ, Rb{sup +1} Driver Design Based on an Integrated Systems Analysis

Description: A computer model for systems analysis of heavy ion drivers has been developed and used to evaluate driver designs for inertial fusion energy (IFE). The present work examines a driver for a close-coupled target design that requires less total beam energy but also smaller beam spots sizes than previous target designs. Design parameters and a cost estimate for a 160 beam, 3.3 MJ driver using rubidium ions (A = 85) are reported, and the sensitivity of the results to variations in selected design pa… more
Date: September 15, 2000
Creator: Meier, W. R.; Barnard, J. J. & Bangerter, R. O.
open access

3-D computer simulations of EM fields in the APS vacuum chamber: Part 1, Frequency-domain analysis

Description: The vacuum chamber proposed for the storage ring of the 7-GeV Advanced Photon Source (APS) basically consists of two parts: the beam chamber and the antechamber, connected to each other by a narrow gap. A sector of 1-meter-long chamber with dosed end plates, to which are attached the 1-inch-diameter beampipes centered at the beam chamber, has been built for experimental purposes. The 3-D code MAFIA has been used to simulate the frequency-domain behaviors of EM fields in this setup. The results … more
Date: September 4, 1990
Creator: Chou, W. & Bridges, J.
Back to Top of Screen