UNT Libraries Government Documents Department - 162 Matching Results

Search Results

open access

Aerodynamic and hydrodynamic characteristics of a deck-inlet multijet water-based-aircraft configuration designed for supersonic flight

Description: From Introduction: "In the present investigation, lift, drag, and pitching moment were determined over a Mach number range 0.6 to 1.42. Smooth-water takeoff and landing stability and resistance were investigated. A brief check of the rough-water spray and behavior was also made."
Date: December 5, 1956
Creator: Bielat, Ralph P.; Coffee, Claude W., Jr. & Petynia, William W.
open access

Aerodynamic and Lateral-Control Characteristics of a 1/28-Scale Model of the Bell X-1 Airplane Wing-Fuselage Combination: Transonic-Bump Method

Description: Report discussing an investigation into the lateral-control characteristics and the pitching-moment characteristics of a scale model of the X-1 wing-fuselage configuration. Information about the estimated variation of rolling effectiveness and wing-fuselage pitching-moment coefficient is described in detail.
Date: May 5, 1950
Creator: Lockwood, Vernard E.
open access

Aerodynamic Characteristics at a Mach Number of 1.25 of a 6-Percent-Thick Triangular Wing and 6- and 9-Percent-Thick Triangular Wings in Combination With a Fuselage: Wing Aspect Ratio 2.31, Biconvex Airfoil Sections

Description: Report discussing testing to determine the aerodynamic characteristics of two semispan delta-wing configurations. Information about the lift characteristics, drag characteristics, pitching-moment characteristics, and comparison with other results is provided.
Date: May 5, 1950
Creator: Hall, Albert W. & Morris, Garland J.
open access

Aerodynamic characteristics at high and low subsonic Mach numbers of four NACA 6-series airfoil sections at angles of attack from -2 to 31 degrees

Description: From Introduction: "The airfoil sections tested, which differ only in thickness ratio, were the NACA 64-006, 64-008, 64-010, and 641-012. Lift, drag, and pitching-moment data were obtained for Mach numbers of 0.3 to that for tunnel choke at angles of attack of -2^o to 31^o. The results of this investigation are reported herein."
Date: June 5, 1953
Creator: Wilson, Homer B., Jr. & Horton, Elmer A.
open access

The aerodynamic characteristics at transonic speeds of a model with a 45 degree sweptback wing, including the effect of leading edge slats and a low horizontal tail

Description: Report presenting an investigation in the 16-foot transonic tunnel to determine the effects of leading-edge slats on the aerodynamic and longitudinal stability characteristics of a model of a swept-wing fighter-type airplane. Two different spanwise extents of leading-edge slats were tested, from 35 to 95 percent semispan and from 46 to 95 percent semispan. Results regarding the lift characteristics, drag characteristics and lift-drag ratios, stability characteristics, and flow-study pictures ar… more
Date: April 5, 1954
Creator: Runckel, Jack F. & Schmeer, James W.
open access

Aerodynamic Characteristics of a 6-Percent-Thick Symmetrical Circular-Arc Airfoil Having a 30-Percent-Chord Trailing-Edge Flap at a Mach Number of 6.9

Description: Memorandum presenting an investigation of the flow characteristics over a 6-percent-thick symmetrical circular-arc airfoil section with a 30-percent-chord trailing-edge flap at a Mach number of 6.90 and a Reynolds number of 1.65 x 10(sub 6). The model was tested over an angle-of-attack range of 0 to 16 degrees and a flap-deflection range of -16 degrees to 16 degrees. Results regarding pressure results and aerodynamic characteristics are provided.
Date: June 5, 1956
Creator: Ridyard, Herbert W. & Fetterman, David E., Jr.
open access

Aerodynamic characteristics of a slender cone-cylinder body of revolution at a Mach number of 3.85

Description: "An experimental investigation of the aerodynamics of a slender cone-cylinder body of revolution was conducted at a Mach number of 3.85 for angles of attack of 0 degree to 10 degrees and a Reynolds number of 3.85x10(exp 6). Boundary-layer measurements at zero angle of attack are compared with the compressible-flow formulations for predicting laminar boundary-layer characteristics. Comparison of experimental pressure and force values with theoretical values showed relatively good agreement for s… more
Date: November 5, 1951
Creator: Jack, John R.
open access

Aerodynamic characteristics of several tip controls on a 60 degree wing at a Mach number of 1.61

Description: Report presenting an investigation at a Mach number of 1.61 to determine the control effectiveness characteristics of seven tip controls on a 60 degree delta wing. Pressure distribution measurements were made for a range of angles of attack and control deflections. Results regarding the effect of control deflection, effect of wing angle of attack, effect of hinge-line location, effect of fences, and effect of control size and location are provided.
Date: August 5, 1954
Creator: Lord, Douglas R. & Czarnecki, K. R.
open access

Aerodynamic load distribution over a 45 degree swept wing having a spoiler-slot-deflector aileron and other spoiler ailerons for Mach numbers from 0.60 to 1.03

Description: Report discussing an investigation of a 45 degree swept-back-wing-body combination with flap spoiler ailerons, deflector ailerons, and a spoiler-slot-deflector aileron. The pressures were measured from Mach numbers 0.60 to 1.03 and at various angles of attack.
Date: December 5, 1957
Creator: West, F. E., Jr.; Whitcomb, Charles F. & Schmeer, James W.
open access

Aerodynamic Study of a Wing-Fuselage Combination Employing a Wing Swept Back 63 Degrees: Effects at Subsonic Speeds of a Constant-Chord Elevon on a Wing Cambered and Twisted for a Uniform Load at a Lift Coefficient of 0.25

Description: Report presenting testing of a cambered and twisted wing with constant-chord elevons with a slender fuselage to determine the longitudinal and lateral control from the elevons for a range of Mach numbers. Results regarding lift, drag, pitching-moment, and rolling-moment characteristics for various elevon deflections are provided.
Date: December 5, 1949
Creator: Jones, J. Lloyd & Demele, Fred A.
open access

Aircraft configurations developing high lift-drag ratios at high supersonic speeds

Description: From Introduction: "Range in more or less steady level flight depends directly on aerodynamic lift-drag ratio at high supersonic speeds, just as it does at lower speeds. This result follows from the classical Breguet range equation in the case of powered flight, and it may be easily deduced from the equations of motion for unpowered or gliding flight (see refs. 1 and 2)."
Date: March 5, 1956
Creator: Eggers, A. J., Jr. & Syvertson, Clarence A.
open access

Altitude investigation of performance of turbine-propeller engine and its components

Description: From Introduction: "Results presented herein show the altitude performance of the turbine-propeller engine and its components and the applicability of the generalization method for predicting engine and component performance at altitudes other than the test altitude. Data from a brief investigation of windmilling and altitude starting characteristics of the engine also presented."
Date: October 5, 1950
Creator: Wallner, Lewis E. & Saari, Martin J.
open access

Altitude performance of annular combustor type turbojet engine with JFC-2 fuel

Description: An investigation was made comparing the performance of JFC-2 fuel and unleaded, clear gasoline in a 3000-pound-thrust turbojet engine. The JFC-2 fuel was a blend of percent diesel fuel and 25 percent aviation gasoline. Engine combustion efficiency was equal to that obtained with gasoline at rated engine speed and altitudes up to 35,000 feet, but at lower engine speeds or at higher altitudes the JFC-2 fuel gave lower combustion efficiency. No discernible difference was obtained in starting or lo… more
Date: February 5, 1952
Creator: Useller, James W.; Harp, James L., Jr. & Barson, Zelmar
open access

Altitude-Wind-Tunnel Investigation of a 4000-Pound-Thrust Axial-Flow Turbojet Engine, 3, Performance Characteristics with the High-Flow Compressor

Description: A wind tunnel investigation was conducted to determine the performance of a 4000-pound-thrust axial-flow turbojet engine with a high flow compressor. Pressure altitudes included 5000 to 40000 feet with ram pressure ratios from 1.00 to 1.82. Altitudes included 20000 to 40000 feet and ram pressure ratios from 1.09 to 1.75. A comparison is made between engine performance with high flow and low flow compressors.
Date: August 5, 1948
Creator: Fleming, William A. & Golladay, Richard L.
open access

Altitude-Wind-Tunnel Investigation of a 4000-Pound-Thrust Axial-Flow Turbojet Engine, 4 - Analysis of Compressor Performance

Description: Operating characteristics of the 11-stage 4000-pound-thrust axial-flow turbojet engine were determined. A standard compressor and a compressor with the blade angles of the rotor and stator blades increased 5 degrees to obtain greater air flow, were investigated.
Date: August 5, 1948
Creator: Dietz, Robert O., Jr. & Suozzi, Frank L.
open access

Altitude-Wind-Tunnel Investigation of Performance Characteristics of a J47D Prototype (RX1-1) Turbojet Engine With Variable-Area Exhaust Nozzle

Description: Performance of a J47D (RX1-1) turbojet engine equipped with afterburner, variable-area exhaust nozzle, and integrated electronic control was determined over a range of flight conditions. These data were obtained with the electronic control both operative and inoperative. For operation with scheduled exhaust nozzle area, the minimum specific fuel consumption of 1.15 pounds of fuel per hour per pound of net thrust occurred at about 7200 rpm at altitudes from 5000 to 25,000 feet at a flight Mach n… more
Date: September 5, 1951
Creator: Conrad, E. William & McAulay, John E.
open access

Analysis of Off-Design Performance of a 16-Stage Axial-Flow Compressor With Various Blade Modifications

Description: "The over-all performance of a 16-stage axial-flow compressor was determined with various stator-blade resettings and a reduction in solidity of the rotor blades in the last three stages. It was shown that little control over the sudden change in slope of the surge-limit line at intermediate speeds was obtained with the blade modifications attempted, except that some change in speed at which the change in slope occurred could be effected by stator-blade resettings" (p. 1).
Date: March 5, 1953
Creator: Medeiros, Arthur A.; Benser, William A. & Hatch, James E.
open access

Analysis of rocket, ramjet, and turbojet engines for supersonic propulsion of long-range missiles. 3: Ramjet engine performance

Description: Report presenting ramjet engine performance data over a range of engine design variables to permit selection and evaluation of a ramjet engine configuration for a long-range supersonic missile. Results include engine thrust, drag, fuel consumption, area ratios, and weight, and are suitable for use in design studies of missiles incorporating either internally or externally mounted ramjet engines.
Date: August 5, 1954
Creator: Weber, Richard J. & Luidens, Roger W.
open access

Analysis of the turbojet for propulsion of supersonic bombers

Description: From Introduction: "The investigation is discussed in the present report is an analysis of the turbojet engine as the power plant for bombers capable of supersonic flight speeds. A similar analysis, in which the turbojet engine is considered for the propulsion of supersonic fighter aircraft, is presented in reference 1. Two plans are considered in this report."
Date: April 5, 1954
Creator: Krebs, Richard P. & Wilcox, E. Clinton
open access

Analysis of transonic rotor-blade passage loss with hot-wire anemometers

Description: From Introduction: "This report presents data from measurements of the flow in a single-stage research compressor, which supports the model of reference 1. A calculated shock technique similar to that of reference 1 is incorporated with these experimental results. Another approach for estimating passage shock loss given a flow rate and blade geometry was reported in reference 2."
Date: June 5, 1958
Creator: Lewis, George W.; Tysl, Edward R. & Fessler, Theodore E.
open access

Analytical study of static and low-speed performance of thin propellers using two-speed gear ratios to obtain optimum rotational speeds

Description: From Introduction: "The purpose of the present paper is to investigate the effect of two-speed gearing on the take-off efficiency under certain conditions. The present paper gives charts from which the efficiencies can be readily computed for optimum rotational speeds. Also included is a brief discussion of the static thrust of thin propellers, including the effect of camber on the static thrust."
Date: November 5, 1952
Creator: Gilman, Jean, Jr.
Back to Top of Screen