UNT Libraries Government Documents Department - Browse

ABOUT BROWSE FEED

Addition of heat to a compressible fluid in motion

Description: From Introduction: "The purpose of this report is to summarize, without extended proofs, the results of a study of a simplified model of nonadiabiatic, compressible fluid flow, both subsonic and supersonic, and to state these results in a form that will make them immediately useful in providing a theoretical background for current technical problems of high-speed combustion.
Date: February 1945
Creator: Hicks, Bruce L

Aerodynamic characteristics and flap loads of the brake-flap installation on the 0.40-scale model of the F4F-3 left wing panel

Description: From Introduction: "The data are presented in coefficient form and include lift, drag, and pitching-moment coefficients of the airfoil-flap comoinations and the normal-force, chord-force, and hinge-moment coefficients of the upper (perforated split) flap and lower (slotted) flap."
Date: October 1942
Creator: Liddell, Robert B

Aerodynamic characteristics of a 4-engine monoplane showing comparison of air-cooled and liquid-cooled engine installations

Description: From Introduction: "An investigation has been conducted in the N.A.C.A. full-scale wind tunnel to determine the aerodynamic characteristics of a 1/4-scale model of a 4-engine monoplane when equipped with comparable air-cooled engine and liquid-cooled engine installations. The air-cooled engine installation consisted of nacelles equipped with N..A.C.A. cowlings and oil coolers located in the leading edge of the wing."
Date: July 1939
Creator: Wilson, Herbert A , Jr & Silverstein, Abe

Aerodynamic characteristics of a slot-lip aileron and slotted flap for dive brakes

Description: From Introduction: "As a part of this investigation, a study is being made of test results obtained during the development of devices designed primarily for other purposes, such as high lift or lateral control, but which may also be used for dive control. These results have been reanalyzed and are herein presented in a form that should make them convenient for design purposes."
Date: April 1941
Creator: Rogallo, F M

Aerodynamic characteristics of four NACA airfoil sections designed for helicopter rotor blades

Description: From Introduction: "The purpose of the present work is to extend the previous investigation and to derive additional airfoil sections designed to minimize the undesirable characteristics of the previously tested airfoils. The tests of these additional airfoils were made in the Langley two-dimensional low-turbulence tunnel (LTT)."
Date: February 1946
Creator: Rice, Fred J , Jr

Aerodynamic characteristics of several modifications of a 0.45-scale model of the vertical tail of the Curtiss XP-62 airplane

Description: From Introduction: "In the course of an investigation to find a satisfactory vertical tail for the XP-62 airplane, a 0.45-scale vertical tail model on a stub fuselage was tested in the Langley 7- by 10-foot tunnel. This model was fitted with a flat plate to represent the horizontal tail surface. The data are presented herein for their general interest value rather than their application to this particular airplane."
Date: July 1946
Creator: Liddell, Robert B.