UNT Libraries Government Documents Department - 1,857 Matching Results

Search Results

open access

0-2 kv Flash Tube Supplies

Description: The power supplies designed and constructed to power high-intensity flash tubes are described. Three supplies, capable of charging 100 mfd to 2 kv with a repetltion rate of not less than 0.8 sec, are operated remotely from a control panel containing 3 powerstats. The power supplies are full wave center trapped rectifiers employing silicon rectifiers. (M.C.G.)
Date: March 15, 1962
Creator: Miller, D. M.
open access


Description: The power supplies designed and constructed to power high intensity flash tubes used in bubble chamber experiments are briefly described and are accompanied by a schematic diagram of the layout. (D.C.W.)
Date: March 15, 1962
Creator: Miller, D. M.
open access

12-INCH SODIUM FLOW CONTROLLER. Technical Manual 20357

Description: A manual is presented for the Sodium Flow Controller used in controlling flow to regulate heat transfer in a liquid metal nuclear power plant. A description of the controller, general installation and operational pointers, installation instructions, instructions for dismantling of the Sodium Flow Controller, instructions for assembly of Sodium Flow Controller, list of special tools and fixtures, and repair parts list are given. (M.C.G.)
Date: October 31, 1962
open access

190-DR steam turbine backup adequacy report

Description: Because of the questionable performance of the 190-DR steam backup system during the power outage of April 6, 1962, it is felt that a general review of the DR secondary water system capabilities and the standby status of the pumping units is warranted. This report shall briefly describe the performance of the steam backup system during the April 6 power outage and the subsequent power outage of July 10, 1962. Since the former outage, tests have been conducted on the steam pump units to determine their capabilities; the test results are presented in this report. A statement of the generally accepted criteria for secondary coolant system adequacy is included and recommendations for meeting the criteria at DR reactor are presented.
Date: November 8, 1962
Creator: Radtke, W. H. & Keplinger, E. R.
open access

333 Building preliminary survey potential equipment improvements

Description: In order to provide advance direction for 333 Building equipment development work, a survey of potential areas of significant savings through equipment improvement has been made. The purpose of this report is only to indicate areas for investigation, not to define a program. Equipment is adequate to maintain operating continuity and provide for safe operation of the building. Special attention should be given to ``one-of-a-kind`` pieces of equipment. These include the press, cutoff saw, beta heat treat facility and autoradiograph film developer. Manpower savings will result principally from refinement of each operation. There are no really outstanding areas for improvement. The greatest potential for savings is in material costs. These are illustrated in Tables I&IV. Maintenance costs provide for possible significant reductions at braze, vacu-blast, nondestructive test, autoclaves, and chemical processing equipment.
Date: August 22, 1962
Creator: Drumheller, K.
open access


Description: One of the major unsolved problems affecting the life of the SNAP II Power Conversion System is the mass transfer of corrosion products by mercury and subsequent deposition. It is feared that the corrosion products might tend to accumulate in critical areas such as orifices, bearings and so forth. Therefore, this test was conducted to evaluate a corrosion product separator and to determine the influence of corrosion product removal on corrosion rate. The corrosion product separator was successful in removing 85 percent of the elements corroded from the container walls. The loop and separator, both fabricated from Haynes alloy No. 25, operated for 1000 hours. The mercury was boiled and condensed at 1100 deg F, superheated to 1190 deg F and subcooled to 325 deg F. The flow rate in this loop was much higher than in previous loops, being approximately 37 pounds of mercury per hour as contrasted with approximately l2 pounds of raercury per hour. No increase in corrosion rate was noticed as a result of the higher flow rates and velocity or by the removal of corrosion products. If this type of separator or an improved type works equally as well in the final application, the danger of failure from corrosion products should be greatly reduced. (auth)
Date: March 1, 1962
Creator: Nejedlik, James F.
open access


Description: A study of the incorporation of {sup 14}CO{sub 2} into cell components of synchronously growing Chlorella pyrenoidosa has shown that DNA is synthesized primarily during the latter stages of the cell cycle prior to cell division. RNA was synthesized at an approximately equal rate during each of the three phases of the cell growth studied. No major differences were noted in the incorporation of {sup 14}CO{sub 2} into the soluble cell components in these long-term incorporation studies.
Date: March 8, 1962
Creator: Stange, Luise; Kirk, Martha; Bennett, Edward L. & Calvin, M.
open access


Description: Given multigroup fluxes and adjoint fluxes of any cylindrical R-Z configuration, 2D PERT may compute: the prompt-neutron lifetime; the relative worth of various delayed neutrons; the integrals of capture, fission, etc., of given materials over any given region; local perturbations, i.e., danger coefflcients; and integrated perturbations, i.e., reactivity effect of uniform variation in the cross sections affecting a whole region. 2D PERT is programmed for a 32K IBM-704 using 3 tape units. The code is written in FORTRAN with the exception of two SAP subroutines. Input fluxes and adjoint fluxes are on tapes which may be obtained either directly from CUREM output or manufactured by a special tape-writing routine. Homogeneous cross sections and variations of these cross sections are either read in as input information or are computed by the code from a microscopic-cross-section library and atomic densities given as input. A combination of these methods may be used. (auth)
Date: May 1, 1962
Creator: Chaumont, J. M. & Koerner, J. A.
open access

3rd Annual Report

Description: The ACIR Library is composed of publications that study the interactions between different levels of government. This document is an annual report.
Date: January 1962
Creator: United States. Advisory Commission on Intergovernmental Relations.
open access

The Absolute Abundance of the Chromium Isotopes in Some Secondary Minerals

Description: From abstract: "Isotopic assays have been made on the chromium in samples from fourteen different chrominiferous minerals from different geographic and meteoritic sources. The results of the assays indicate that it is not possible to unequivocally state that variations in isotopic compositions have been observed."
Date: 1962
Creator: Svec, Harry J. (Harry John), 1918-; Flesch, G. D. & Capellen, J.
open access


Description: Isotopic assays have been made on the Cr in samples from 14 different chrominiferous minerals from different geographic and meteoritic sources. The results of the assays indicate that it is not possible to state unequivocally that variations in isotopic composition have been observed. (auth)
Date: March 14, 1962
Creator: Svec, H.J.; Flesch, G.D. & Capellen, J.
open access

Absorber Burn-Up Experiment. Final Report

Description: Experimental results are presented of pile oscillator measurements of cross sections of irradiated samples of seventeen elements. Mass spectrometer analysis of some samples was performed. Quantitative theory-experiment correlation yielded thermal absorption cross section information and also established the reliability of control rod lifetime calculations for each element investigated. Application of the results to calculation of the nuclear lifetime of reactor control rods is discussed. (auth)
Date: April 1962
Creator: Russell, J. L. Jr.; Carrothers, M. R. & Mosgovoy, W. V.
open access


Description: Possible experiments that could be performed at the Brookhaven alternating gradient synchrotron using highenergy deuterons and heavier nuclei are reviewed. Particular attention is given to production of high-energy neutrons by stripping. A brief analysis of changes needed to accelerate heavier nuclei reveals such modifications would not be prohibitive. (D.C.W.)
Date: December 18, 1962
Creator: Courant, E. D.
open access

Acceleration of Polarized Protons to Relativistic Energies

Description: Maintenance of poiarization of polarized protons in a linear accelerator is known to be feasible. Circular accelerators present a different problem, and the investigation of the interaction of orbit dynamics and particle polarization in general is undertaken. The equation of motion of the spin vector of a charged particle in a magnetic field as formulated by Bargman, Michel, and Telegdi is utilized in the study of depolarization for several accelerators. High values of depoiarization are obtained, and means for avoiding such depolarization are suggested. (D.C.W.)
Date: January 22, 1962
Creator: Courant, E. D.
open access

Acceptance test facility safeguards report

Description: This report covers only the tests and operations to be conducted with SNAP 10A system; acceptance tests of SNAP 2 and 8 systems, which will also be conducted in this facility, will be presented in an addendum to be published at a later date.
Date: October 1, 1962
Creator: Soske, P. L.; Ostenso, A. S. & Kamensky, F. J.
Back to Top of Screen