Search Results

open access

A flight evaluation of the longitudinal stability characteristics associated with the pitch-up of a swept-wing airplane in maneuvering flight at transonic speeds

Description: This report presents the results of flight measurements of longitudinal stability and control characteristics made on a swept-wing jet aircraft to determine the origin of the pitch-up encountered in maneuvering flight at transonic speeds. For this purpose measurements were made of elevator angle, tail angle of attack, and wing-fuselage pitching moments (obtained from measurements of the balancing tail loads).
Date: September 12, 1951
Creator: Anderson, Seth B. & Bray, Richard S.
open access

Analytical Derivation and Experimental Evaluation of Short-Bearing Approximation for Full Journal Bearing

Description: From Introduction: "This report extends the short-bearing pressure-distribution function of Michell and Cardullo to give equations for the various bearing characteristics. This short-bearing approximation makes available formulas relating eccentricity ratio to applied load, attitude angle, angular position of peak film pressure to unit pressure on projected area."
Date: June 12, 1953
Creator: DuBois, George B. & Ocvirk, Fred W.
open access

Analysis of Turbulent Free-Convection Boundary Layer on Flat Plate

Description: "With the use of Karman's integrated momentum equation for the boundary layer and data on the wall-shearing stress and heat transfer in forced-convection flow, a calculation was carried out for the flow and heat transfer in the turbulent free-convection boundary layer on a vertical flat plate. The calculation is for a fluid with a Prandtl number that is close to 1. A formula was derived for the heat-transfer coefficient that was in good agreement with experimental data in the range of Grashof n… more
Date: July 12, 1950
Creator: Eckert, E. R. G. & Jackson, Thomas W.
open access

A numerical method for the stress analysis of stiffened-shell structures under nonuniform temperature distributions

Description: A numerical method is presented for the stress analysis of stiffened-shell structures of arbitrary cross section under nonuniform temperature distributions. The method is based on a previously published procedure that is extended to include temperature effects and multicell construction. The application of the method to practical problems is discussed and an illustrative analysis is presented of a two-cell box beam under the combined action of vertical loads and a nonuniform temperature distrib… more
Date: September 12, 1950
Creator: Heldenfels, Richard R.
open access

Two-and Three-Dimensional Unsteady Lift Problems in High-Speed Flight

Description: "The problem of transient lift on two- and three-dimensional wings flying at high speeds is discussed as a boundary-value problem for the classical wave equation. Kirchoff's formula is applied so that the analysis is reduced, just as in the steady state, to an investigation of sources and doublets. The applications include the evaluation of indicial lift and pitching-moment curves for two-dimensional sinking and pitching wings flying at Mach numbers equal to 0, 0.8, 1.0, 1.2 and 2.0" (p. 393).
Date: October 12, 1950
Creator: Lomax, Harvard; Heaslet, Max A.; Fuller, Franklyn B. & Sluder, Loma
open access

Effect on longitudinal stability and control characteristics of a Boeing B-29 airplane of variations in stick-force and control-rate characteristics obtained through use of a booster in the elevator-control system

Description: A longitudinal stability and control characteristics of a Boeing B-29 airplane have been measured with a booster incorporated in the elevator-control system. Tests were made to determine the effects on the handling qualities of the test airplane of variations in the pilot's control-force gradients as well as the effects of variations in the maximum rate of control motion supplied by the booster. The results of the control-rate investigation indicate that large airplanes may have satisfactory ha… more
Date: April 12, 1950
Creator: Mathews, Charles W.; Talmage, Donald B. & Whitten, James B.
open access

Extrapolation techniques applied to matrix methods in neutron diffusion problems

Description: "A general matrix method is developed for the solution of characteristic-value problems of the type arising in many physical applications. The scheme employed is essentially that of Gauss and Seidel with appropriate modifications needed to make it applicable to characteristic-value problems. An iterative procedure produces a sequence of estimates to the answer; and extrapolation techniques, based upon previous behavior of iterants, are utilized in speeding convergence. Theoretically sound limit… more
Date: May 12, 1955
Creator: McCready, Robert R.
open access

Relative importance of various sources of defect-producing hydrogen introduced into steel during application of vitreous coatings

Description: "When porcelain enamels or vitreous-type ceramic coatings are applied to ferrous metals, there is believed to be an evolution of hydrogen gas both during and after the firing operation. At elevated temperatures rapid evolution may result in blistering while if hydrogen becomes trapped in the steel during the rapid cooling following the firing operation gas pressures may be generated at the coating-metal interface and flakes of the coating literally blown off the metal. To determine experimental… more
Date: July 12, 1951
Creator: Moore, Dwight G.; Mason, Mary A. & Harrison, William N.
open access

Analysis and Calculation by Integral Methods of Laminar Compressible Boundary-Layer With Heat Transfer and With and Without Pressure Gradient

Description: From Introduction: "The purpose of the present report is to present a comprehensive summary of theoretical investigations of comprehensible laminar boundary layers which have been carried out since 1949 at the Polytechnic Institute of Brooklyn under the sponsorship and with the financial assistance of the National Advisory Committee for Aeronautics. The results of these investigations are contained primarily in references 1 to 7."
Date: April 12, 1955
Creator: Morduchow, Morris
open access

Calibration of strain-gage installations in aircraft structures for the measurement of flight loads

Description: "A general method has been developed for calibrating strain-gage installations in aircraft structures, which permits the measurement in flight of the shear or lift, the bending moment, and the torque or pitching moment on the principal lifting or control surfaces. Although the stress in structural members may not be a simple function of the three loads of interest, a straightforward procedure is given for numerically combining the outputs of several bridges in such a way that the loads may be o… more
Date: August 12, 1952
Creator: Skopinski, T. H.; Aiken, William S., Jr. & Huston, Wilber B.
open access

A comparison of theory and experiment for high-speed free-molecule flow

Description: A comparison is made of free-molecule-flow theory with the results of wind-tunnel tests performed to determine the drag and temperature-rise characteristics of a transverse circular cylinder. The measured values of the cylinder center-point temperature confirmed the salient point of the heat-transfer analysis which was the prediction that an insulated cylinder would attain a temperature higher than the stagnation temperature of the stream. Good agreement was obtained between the theoretical and… more
Date: September 12, 1950
Creator: Stalder, Jackson R.; Goodwin, Glen & Creager, Marcus O.
Back to Top of Screen