UNT Libraries Government Documents Department - 176 Matching Results

Search Results

Results: 1 - 24 next
open access

Aerodynamic Characteristics and Flap Loads of the Brake-Flap Installation on the 0.40-Scale Model of the F4F-3 Left Wing Panel

Description: "The data are presented in coefficient form and include lift, drag, and pitching-moment coefficients of the airfoil-flap comoinations and the normal-force, chord-force, and hinge-moment coefficients of the upper (perforated split) flap and lower (slotted) flap" (p. 1).
Date: October 1942
Creator: Purser, Paul E. & Liddell, Robert B.
Item Type: Refine your search to only Report
open access

Aerodynamic Characteristics for Internal-Balance and Frise Type Ailerons on an NACA 6 Series Low-Drag Tip Section of the Wing for the XP-63 Airplane

Description: Report presenting testing in the two-dimensional turbulence tunnel of a model of the tip section of the wing of the XP-63 airplane. Several alterations of the skirts and balance on the internal-balance aileron were tested to obtain various aerodynamic characteristics of the aileron.
Date: October 1942
Creator: Underwood, William J.
Item Type: Refine your search to only Report
open access

Analysis of Heat and Compressibility Effects in Internal Flow Systems and High-Speed Tests of a Ram-Jet System

Description: Report presenting an analysis of the effects of heat and compressibility in the flow through the internal systems of aircraft. Equations and charts are developed whereby the flow characteristics at key stations in a typical internal system may be readily obtained.
Date: September 1942
Creator: Becker, John V. & Baals, Donald D.
Item Type: Refine your search to only Report
open access

Application of Balancing Tabs to Ailerons

Description: Analysis was made to determine characteristics required of a balancing-tab system for ailerons in order to reduce aileron stick forces to any desired magnitude. Series of calculations based on section data were made to determine balancing-tab systems of various chord tabs and ailerons that will give, for a particular airplane, zero rate of aileron hinge moment with aileron deflection and yet will produce same maximum rate of roll as a plain unbalanced 15-percent chord aileron of same span. Effe… more
Date: June 1942
Creator: Sears, Richard I.
Item Type: Refine your search to only Report
open access

Calculated effects of full-span slotted and Fowler flaps on longitudinal stability and control characteristics for a typical fighter-type airplane with various tail modifications

Description: Report presenting an analytical study of the influence of full-span slotted and Fowler flaps on the requirements for horizontal tail surfaces. The elevator deflection required to land at three-point attitude, elevator deflection required to stall the airplane at altitude, and permissible center-of-gravity range have been calculated for a fighter-type airplane.
Date: July 1942
Creator: Goranson, R. Fabian
Item Type: Refine your search to only Report
open access

Calculation of tab characteristics for flight conditions from wind-tunnel data

Description: Report presenting tail-surface characteristics calculated from wind-tunnel data, which have been reported to not correspond with flight-test measurements. The primary problem under consideration is the calculation of the effect of tab deflection on the free-floating angle of the elevator, as in a servocontrol.
Date: April 1942
Creator: Sears, Richard I.
Item Type: Refine your search to only Report
open access

Calibrations of pitot-static tubes at high speeds

Description: Report presenting the calibrations of three types of service pitot-static tubes over an approximate range of speeds of 150 to 600 miles per hour. The calibrations indicated a need for a pitot-static tube with greater accuracy, especially at higher speeds. Results regarding the service tubes, Prandtl tube, Eigh-speed tube, and a comparison of the tubes are provided.
Date: July 1942
Creator: Hensley, Reece V.
Item Type: Refine your search to only Report
open access

Characteristics of beveled-trailing-edge elevators on a typical pursuit fuselage at altitudes simulating-normal flight and spin conditions

Description: Report presenting lift and elevator hinge-moment characteristics were measured on horizontal tail provided with elevators having three different beveled trailing edges. Results regarding fuselage alone and fuselage interference, lift characteristics of fuselage-tail combination, elevator hinge-moment characteristics, drag, and comparison with data from two-dimensional-flow tests are provided.
Date: December 1942
Creator: Gillis, Clarence L.
Item Type: Refine your search to only Report
open access

Characteristics of plain and balanced elevators on a typical pursuit fuselage at attitudes simulating normal-flight and spin conditions

Description: Report presenting lift and elevator hinge-moment characteristics of a horizontal tail with various plain and balanced elevators and mounted on a typical pursuit fuselage as measured in the 7- by 10-foot wind tunnel at attitudes simulating normal-flight and spin conditions. The lift effectiveness of the elevator was practically independent of the size of the aerodynamic balance. Results regarding the fuselage alone and fuselage interference, lift characteristics of fuselage-tail combinations, li… more
Date: March 1942
Creator: Sears, Richard I. & Hoggard, H. Page, Jr.
Item Type: Refine your search to only Report
open access

The Characteristics of Two Model Six-Blade Counterrotating Pusher Propellers of Conventional and Improved Aerodynamic Design

Description: Two airfoil plans were used for propeller blades. One is modified Clark Y section designed for structural reliability and the second an NACA 16 airfoil section designed to produce minimum aerodynamic losses. At low air speeds, the propeller designed for aerodynamic effects showed a gain of from 1.5 to 4.0 percent in propulsive efficiency over the conventional type depending on the pitch. Because of the numerous variables involved, the effect of each one on the aerodynamic characteristics of the… more
Date: June 1942
Creator: McHugh, James G. & Pepper, Edward
Item Type: Refine your search to only Report
open access

Comparison of Intercooler Characteristics

Description: Report presenting a method of comparing the performance, weight, and general dimensional characteristics of intercoolers. The performance and dimensional characteristics covered in the comparisons include cooling effectiveness, pressure drops and weight flows of the charge and cooling air, power losses, volume, frontal area, and width.
Date: November 1942
Creator: Reuter, J. George & Valerino, Michael F.
Item Type: Refine your search to only Report
open access

Comparison of tightness of 78 degrees machine-countersunk rivets driven in holes prepared with 78 degrees and 82 degrees countersinking tools

Description: Report presenting an investigation to determine whether the use of a 78 degree countersinking tool instead of a 82 degree countersinking tool for riveting would substantially alter the conclusion reached in a previous paper regarding the placement of rivets for maximum strength.
Date: September 1942
Creator: Gottlieb, Robert & Mandel, Merven W.
Item Type: Refine your search to only Report
open access

Construction of Finned Aluminum Muffs for Aircraft Engine Cylinder Barrels

Description: "This report describes the material, cutting-tool development, and machining procedure used in constructing an air-cooled cylinder barrel having a cooling muff with 2-inch fins spaced 1/8 inch. Details of two types of thread form used for the barrel to head assembly with the cooling muff are also presented" (p. 1).
Date: April 1942
Creator: Langley Memorial Aeronautical Laboratory
Item Type: Refine your search to only Report
open access

Control-Motion Studies of the PBM-3 Flying Boat in Abrupt Pull-Ups

Description: Report presenting a control-motion study in flight that is part of series covering a range of types and sizes of modern airplanes. This particular one involves the PBM-3 flying boat, which is equipped with a control mechanism typical of the cable-type systems in large transport, cargo, or bomber airplanes as well as those employed in flying boats. The elasticity of the elevator control system of the PBM-3 was such to limit the obtainable acceleration to about 3g for center-of-gravity positions … more
Date: November 1942
Creator: Pearson, Henry A. & Smull, Leland K.
Item Type: Refine your search to only Report
open access

Cooling in Cruising Flight With Low Fuel-Air Ratios

Description: Report presenting testing of a Pratt & Whitney R-1830-43 engine mounted in a B-24D nacelle in the full-scale wind tunnel in order to investigation the potential improvements of fuel economy. Suggestions for improving the cruising power and cruising range by operating at specified fuel-air ratios are provided.
Date: June 1942
Creator: Silverstein, Abe & Wilson, Herbert A., Jr.
Item Type: Refine your search to only Report
open access

Cooling Investigation of a B-24D Engine-Nacelle Installation in the NACA Full-Scale Tunnel

Description: Report presenting an investigation conducted in the full-scale tunnel to determine methods of improving the cooling of the B-24D engine installation. The B-24D is a four-engine high-wing monoplane having a span of 110 feet, a wing area of 1048 square feet, and a gross weight of 56,000 pounds.
Date: November 1942
Creator: Lehr, Robert R.; Kinghorn, George F. & Guryansky, Eugene R.
Item Type: Refine your search to only Report
open access

Cooling Tests of an Air-Cooled Engine Cylinder With Copper Fins on the Barrel

Description: Report presenting the results of comparative cooling tests run on two Wright C9GC (G-200) cylinders, one with the original steel fins and one with 1-inch spiral copper fins brazed on the barrel. Calculations were also performed using copper and aluminum fins with the same weight as the original steel fins, which showed positive results. Results regarding cylinder-temperature correlation, piston-temperature correlation, and comparative performance are also provided.
Date: July 1942
Creator: Sanders, J. C.; Wilsted, H. D. & Mulcahy, B. A.
Item Type: Refine your search to only Report
Back to Top of Screen