UNT Libraries Government Documents Department - 1,166 Matching Results

This system will be undergoing maintenance April 18th between 9:00AM and 12:00PM CDT.

Search Results

open access

Acceleration Measurements During Landings of a 1/5.5-Size Dynamic Model of the Columbia XJL-1 Amphibian in Smooth Water and in Waves: Langley Tank Model 208M, TED No. NACA 2336

Description: A 1/5.5-size powered dynamic model of the Columbia XJL-1 amphibian was landed in Langley tank no. 1 in smooth water and in oncoming waves of heights from 2.1 feet to 6.4 feet (full-size) and lengths from 50 feet to 264 feet (full-size). The motions and the vertical accelerations of the model were continuously recorded. The greatest vertical acceleration measured during the smooth-water landings was 3.1g.
Date: September 25, 1947
Creator: Clement, Eugene P. & Havens, Robert F.
open access

Adaptation of a Cascade Impactor to Flight Measurement of Droplet Size in Clouds

Description: "A cascade impactor, an instrument for obtaining the size distribution of droplets borne in a low-velocity air stream, was adapted for flight cloud droplet-size studies. The air containing the droplets was slowed down from flight speed by a diffuser to the inlet-air velocity of the impactor" (p. 1).
Date: September 18, 1951
Creator: Levine, Joseph & Kleinknecht, Kenneth S.
open access

Additional results of an investigation at transonic speeds to determine the effects of a heated propulsive jet on the drag characteristics of a series of related afterbodies

Description: From Introduction: "Presented in this report are the basic data obtained from investigation. The data are presented with limited analysis in order to expedite their availability to those concerned with jet-exit-afterbody design."
Date: September 24, 1956
Creator: Henry, Beverly Z., Jr. & Cahn, Maurice S.
open access

Aerodynamic and Hydrodynamic Tests of a Family of Models of Flying-Boat Hulls Derived From a Streamline Body: NACA Model 84 Series

Description: Report presenting a series of related flying-boat hull forms with various combinations of aerodynamic and hydrodynamic requirements that were tested in an NACA tank and high-speed tunnel. Effects explored included varying the height of the bow, varying the height of the stern, increasing the angle of dead rise at the bow, decreasing the angle of dead rise on the afterbody, increasing the depth of step, increasing the angle of afterbody keel, adding chine flare, adding a third planing surface, a… more
Date: September 1943
Creator: Parkinson, John B.; Olson, Roland E.; Draley, Eugene C. & Luoma, Arvo A.
open access

Aerodynamic characteristics and pressure distributions of a 6-percent-thick 49 degree sweptback wing with blowing over half-span and full-span flaps

Description: From Introduction: "The investigation reported herein was initiated to define further the effects on the aerodynamic characteristics and load distribution of a thin, sweptback wing of a low-pressure blowing system and also to provide information on which to base a more thorough study of a complete airplane configuration."
Date: September 20, 1955
Creator: Whittle, Edward F., Jr. & McLemore, H. Clyde
open access

Aerodynamic characteristics at Mach numbers from 0.7 to 1.75 of a four-engine swept-wing airplane configuration as obtained from a rocket-propelled model test

Description: Report presenting flight testing of a rocket-propelled model of a typical multiengine airplane configuration to obtain data on drag, stability, and nacelle performance. Data were obtained at a variety of Mach numbers, lift coefficients, and subsonic and supersonic speeds. Results regarding airplane performance, nacelle performance, longitudinal characteristics, and lateral characteristics are provided.
Date: September 2, 1955
Creator: Chapman, Rowe, Jr.
open access

Aerodynamic Characteristics at Mach Numbers From 2.5 to 3.5 of a Canard Bomber Configuration Designed for Supersonic Cruise Flight

Description: Report presenting an investigation of a canard-type configuration designed for supersonic cruise flight in the Unitary Plan wind tunnel. Tests were conducted over a range of angles of attack and angles of sideslip. Results regarding the effect of forebody configuration, effects of Reynolds number and transition, effect of canard and elevon deflection, and effect of vertical surfaces are provided.
Date: September 10, 1958
Creator: Carmel, Melvin M.; Kelly, Thomas C. & Gregory, Donald T.
open access

Aerodynamic characteristics at transonic speeds of a 60 degree delta wing equipped with a constant-chord flap-type control with and without an unshielded horn balance: transonic-bump method

Description: Report presenting an investigation to determine the control hinge moments and effectiveness at transonic speeds of a delta wing equipped with a constant-chord flap-type control with and without an unshielded triangular horn balance in the 7- by 10-foot tunnel using the transonic-bump method. The data indicated that the horn balance control was consistently more effective in changing lift at all Mach numbers than was the plain control but there was no appreciable difference in pitching-moment ef… more
Date: September 16, 1952
Creator: Wiley, Harleth G. & Zontek, Leon
open access

The Aerodynamic Characteristics at Transonic Speeds of an All-Movable, Tapered, 45 Degree Sweptback, Aspect-Ratio-4 Tail Deflected About a Skewed Hinge Axis and Equipped with an Inset Unbalancing Tab

Description: From Introduction: "The present investigation presents the lift and moment characteristics of an aspect-ratio-4.0 tail, sweptback 45^o at the quarter-chord line and pivoted about an axis sweptback 55.5^o and passing through the leading edge of the root-chord line."
Date: September 29, 1953
Creator: Watson, James M.
open access

Aerodynamic Characteristics of a 0.5-Scale Model of the Fairchild XSAM-N-2 Lark Missile at High Subsonic Speeds

Description: "An investigation was conducted to determine the longitudinal- and lateral-stability characteristics of a 0.5-scale model of the Fairchild Lark missile. The model was tested with 0 deg and with 22.5 deg of roll. Three horizontal wings having NACA 16-009, 16-209, and 64A-209 sections were tested. Pressures were measured on both pointed and blunt noses" (p. 1).
Date: September 28, 1949
Creator: Martin, Andrew & Hunter, Harlo A.
open access

Aerodynamic Characteristics of a 0.04956-Scale Model of the Convair F-102A Airplane at Mach Numbers of 1.41, 1.61, and 2.01

Description: "Tests have been made in the Langley 4- by 4-foot supersonic pressure tunnel at Mach numbers of 1.41, 1.61, and 2.01 of various arrangements of a 0.04956-scale model of the Convair F-102A airplane with faired inlets. Tests made of the model equipped with a plain wing, a wing with 6.4 percent conical camber, and a wing with 15 percent conical camber. Body modifications including an extended nose, a modified canopy, and extended afterbody fillets were evaluated" (p. 1).
Date: September 30, 1955
Creator: Spearman, M. Leroy & Driver, Cornelius
open access

Aerodynamic characteristics of a wing with quarter-chord line swept back 60 degrees, aspect ratio 4, taper ratio 0.6, and NACA 65A006 airfoil section: transonic-bump method

Description: From Introduction: "This paper presents the results of the investigation of the wing-alone and wing-fuelage configurations employing a wing with the quarter-chord line swept back 60^o, aspect ratio 4, taper ratio 0.6, and an NACA 65A006 airfoil section parallel to the free stream."
Date: September 6, 1949
Creator: King, Thomas J., Jr. & Myers, Boyd C., II
open access

Aerodynamic Characteristics of Airfoils 4: Continuation of Reports Nos. 93, 124, and 182

Description: This collection of data on airfoils has been made from the published reports of a number of the leading Aerodynamic Laboratories of this country and Europe. The information which was originally expressed according to the different customs of the several laboratories is here presented in a uniform series of charts and tables suitable for the use of designing engineers and for purposes of general reference. The authority for the results here presented is given as the name of the laboratory at whi… more
Date: September 1926
open access

Aerodynamic Characteristics of an Airfoil-Forebody Swept Flying-Boat Hull With a Wing and Tail Swept Back 51.3 Degrees at the Leading Edge

Description: Report discussing an investigation of the aerodynamic characteristics of an airfoil-forebody swept flying boat hull with a wing and tail swept back 51.3 degrees at the leading edge. The swept hull's minimum drag coefficient was about the same as the parent model or streamline model. Various combinations of flaps were also utilized.
Date: September 9, 1949
Creator: Naeseth, Rodger L. & MacLeod, Richard G.
open access

Aerodynamic Characteristics of Four Republic Airfoil Sections from Tests in Langley Two-Dimensional Low-Turbulence Tunnels

Description: "Four airfoils sections, designed by the Republic Aviation Corporation for the root and tip sections of the XF-12 airplane, were tested in the Langley two-dimensional low-turbulence tunnels to obtain their aerodynamic characteristics. Lift characteristics were obtained at Reynolds numbers of 3,000,000, 6,000,000, 9,000,000, and 14,000,000, whereas drag characteristics were obtained at Reynolds numbers of 3,000,000, 6,000,000, and 9,000,000. Pressure distributions were obtained for one of the ro… more
Date: September 27, 1945
Creator: Klein, Milton M.
open access

Aerodynamic Characteristics of the NACA 747A315 and 747A415 Airfoils From Tests in the NACA Two-Dimensional Low-Turbulence Pressure Tunnel

Description: Report presenting two low-drag airfoils, the NACA 747A315 and the NACA 747A415, which are designed to have reduced pitching moments about the quarter-chord point and moderately high values of the design lift coefficient and are tested in the tow-dimensional low-turbulence pressure tunnel.
Date: September 1944
Creator: von Doenhoff, Albert E. & Stivers, Louis S., Jr.
open access

Aerodynamic characteristics of the NACA RM-10 research missile in the Ames 1- by 3-foot supersonic wind tunnel no. 2: Pressure and force measurements at Mach numbers of 1.52 and 1.98

Description: Report presenting an experimental investigation of the aerodynamic characteristics of a fin-stabilized body of revolution, designated as RM-10, in a supersonic wind tunnel. Pressure distributions and force characteristics were determined at two different Mach numbers. Results regarding pressure distributions, body-alone force tests, and body-tail combination force tests are provided.
Date: September 19, 1951
Creator: Perkins, Edward W.; Gowen, Forrest E. & Jorgensen, Leland H.
open access

Aerodynamic Computation of Gliders

Description: From Introduction: "In the following discussion, a knowledge of the theoretical principles of airplane construction is assumed, as presented in detail by Vogt and Lippisch in Nos. 7 and 10-19 of the 1919 volume of this publication. A few quantities will however be otherwise designated, in accordance with the Gottingen symbols."
Date: September 1922
Creator: Schrenk, M.
open access

The aerodynamic forces and moments on a 1/10-scale model of a fighter airplane in spinning attitudes as measured on a rotary balance in the Langley 20-foot free-spinning tunnel

Description: From Introduction: "This investigation provides general information on the magnitudes and directions of the aerodynamic forces and moments acting on a fighter airplane in fully developed spins. The investigation includes the determination of the effects on the aerodynamic forces and moments of varied rudder setting with and against the spin, of tail modifications, and of deflected flaps and lowered landing gear."
Date: September 1950
Creator: Stone, Ralph W., Jr.; Burk, Sanger M., Jr. & Bihrle, William, Jr.
open access

Aerodynamic heat transfer and zero-lift of a flat windshield canopy on the NACA RM-10 research vehicle at high Reynolds numbers for a flight Mach number range from 1.5 to 3.0

Description: Report presenting the aerodynamic heat-transfer properties and zero-lift drag of a typical pilot's canopy as determined by a rocket-model flight test through a range of Mach and Reynolds numbers. The canopy had a 63 degree sweptback flat windshield, circular cross section, and an equivalent body fineness ratio of 7.0. Results regarding the canopy temperature distribution, canopy pressure distribution, heat-transfer coefficient, and drag are provided.
Date: September 26, 1956
Creator: Hoffman, Sherwood & Chauvin, Leo T.
open access

Aerodynamic heating of a wing as determined from a free-flight rocket-model test to Mach number 3.64

Description: From Introduction: "The primary purpose of the wing instrumentation was to obtain data for use in design of NACA research missiles; however, it is believed that the wing is representative of typical supersonic designs and that the data will be of general use and interest. Only the wing data are reported herein."
Date: September 11, 1956
Creator: Swanson, Andrew G. & Rumsey, Charles B.
Back to Top of Screen