UNT Libraries Government Documents Department - 191 Matching Results

Search Results

Results: 1 - 24 next
open access

Acceleration Characteristics of R-3350 Engine Equipped with NACA Injection Impeller

Description: From Summary: "Qualitative investigations have shown that use of the NACA injection impeller with the R-3350 engine increases the inertia of the fuel-injection system and, when the standard fuel-metering system is used, this increase in inertia results in poor engine acceleration characteristics. This investigation was therefore undertaken to determine whether satisfactory acceleration characteristics of the engine equipped with the injection impeller could be obtained by simple modifications t… more
Date: January 8, 1947
Creator: Hickel, Robert O. & Snider, William E.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics of a wing with unswept quarter-chord line, aspect ratio 2, taper ratio 0.78, and NACA 65A004 airfoil section: transonic-bump method

Description: From Introduction: "This paper presents the results of an investigation of force and moment characteristics for a wing with an unswept quarter-chord line, aspect ratio 2, taper ratio 0.78, and an NACA 65A004 airfoil section parallel to the free stream."
Date: March 8, 1950
Creator: Polhamus, Edward C. & Campbell, George S.
Item Type: Refine your search to only Report
open access

Aerodynamic characteristics of a wing with unswept quarter-chord line, aspect ratio 4, taper ratio 0.6, and NACA 65A004 airfoil section: Transonic-bump method

Description: From Introduction: "This paper presents the results of the investigation of the wing alone and of the wing-fuselage configurations employing a wing with an unswept quarter-chord line, aspect ratio 4, taper ratio 0.6, and an NACA 65A004 airfoil section parallel to the air stream. The experimental results of a wing of identical plan from having an NACA 65A006 airfoil section which was tested as part of the transonic program are presented in reference 1.
Date: May 8, 1950
Creator: Myers, Boyd C., II & Wiggins, James W.
Item Type: Refine your search to only Report
open access

Aerodynamic Investigation of a Parabolic Body of Revolution at Mach Number of 1.92 and Some Effects of an Annular Jet Exhausting From the Base

Description: Report discussing an investigation of a parabolic body of revolution with and without the effects of an annular jet exhausting from the base. The aerodynamic characteristics, pressures, lift-curve slope, and other characteristics with the jet in operation and inoperative were compared.
Date: February 8, 1950
Creator: Love, Eugene S.
Item Type: Refine your search to only Report
open access

Aerodynamic study of a wing-fuselage combination employing a wing swept back 63 degrees : effectiveness of an elevon as a longitudinal control and the effects of camber and twist on the maximum lift-drag ratio at supersonic speeds

Description: Report presenting an investigation concerned with the measurement of the characteristics of longitudinal-control devices for a wing-fuselage combination with a wing with the leading edge swept back 63 degrees. Most of the investigation was devoted to testing a 30-percent-chord, 50-percent-semispan elevon, but some used upper-surface spoilers. Results regarding the characteristics of the wing with the elevon undeflected and control-surface effectiveness are provided.
Date: May 8, 1950
Creator: Olson, Robert N. & Mead, Merrill H.
Item Type: Refine your search to only Report
open access

Aerodynamics of slender bodies at Mach number of 3.12 and Reynolds numbers from 2 x 10(exp 6) to 15 x 10(exp 6) 2: aerodynamic load distributions of series of five bodies having conical noses and cylindrical afterbodies

Description: Report presenting an experimental investigation to determine the aerodynamic load distributions of a series of five bodies with conical or slightly blunted noses and cylindrical afterbodies in the 1- by 1-foot supersonic wind tunnel. Pressure distributions and viscous drags were measured at Mach number 3.12 for a range of Reynolds numbers and angles of attack.
Date: May 8, 1952
Creator: Jack, John R. & Gould, Lawrence I.
Item Type: Refine your search to only Report
open access

Air-Stream Surveys in the Vicinity of the Tail of a 1/8.33-Scale Powered Model of the Republic XF-12 Airplane

Description: "The XF-12 airplane was designed by Republic Aviation Corporation to provide the Army Air Forces with a high performance, photo reconnaissance aircraft. A series of air-stream surveys were made n the vicinity of the empennage of a 1/8.33-scale powered model of the XF-12 airplane in the Langley 19-foot pressure tunnel. Surveys of the vortical-tail region were made through a range of yaw angles of plus or minus 20 degrees at a high and low angle of attack" (p. 1).
Date: April 8, 1947
Creator: Foster, Gerald V.
Item Type: Refine your search to only Report
open access

Altitude operational characteristics of a prototype model of the J47D (RX1-1 and RX1-3) turbojet engines with integrated electronic control

Description: Report presenting an investigation of the altitude operational characteristics of a prototype model of the J47D turbojet engines, which includes an afterburner, a variable-area exhaust nozzle, and an integrated electronic control in an altitude wind tunnel. Results regarding compressor stall, compressor unstall, combustor blow-out during acceleration, stall and blow-out protection, acceleration characteristics, deceleration characteristics, and altitude starting characteristics, afterburner ope… more
Date: January 8, 1952
Creator: Bloomer, Harry E.; Conrad, E. William & Sobolewski, Adam E.
Item Type: Refine your search to only Report
open access

Altitude performance and operational characteristics of 29-inch-diameter tail-pipe burner with several fuel systems and flame holders on J35 turbojet engine

Description: From Summary: "An investigation of turbojet-engine thrust augmentation by means of tail-pipe burning has been conducted in the NACA Lewis altitude wind tunnel. Several fuel systems and flame holders were investigated in a 29-inch-diameter tail-pipe burner to determine the effect of fuel distribution and flame-holder design on tail-pipe-burner performance and operational characteristics over a range of simulated flight conditions. At an altitude of 5000 feet, the type of flame holder used had on… more
Date: November 8, 1949
Creator: Conrad, E. William & Prince, William R.
Item Type: Refine your search to only Report
open access

Altitude Performance of AN-F-58 Fuels in British Rolls-Royce Nene Single Combustor

Description: "An investigation was conducted with a single combustor from a British Rolls-Royce Nene turbojet engine to determine the altitude performance characteristics of AN-F-58 fuels. Three fuel blends conforming to AN-F-58 specifications were prepared in order to determine the influence of fuel boiling temperatures and aromatic content on combustion efficiencies and altitude operational limits. The performance of the three AN-F-58 fuels was compared in the range of altitudes from sea level to 65,000 f… more
Date: July 8, 1949
Creator: Cook, William P. & Koch, Richard G.
Item Type: Refine your search to only Report
open access

An analysis of the transonic and supersonic performance of several fixed-geometry air inlets

Description: Report presenting an analysis of the maximum power thrust-minus-drag performance of several turbojet-engine air-inlet combinations over a wide range of flight conditions. The primary objective of the analysis was to use the experimentally determined drag and total-pressure-recovery characteristics to show the range of satisfactory performance of each of several fixed-geometry inlet configurations. Results regarding the performance at 35,000 feet, inlet design considerations, speed range of effi… more
Date: March 8, 1955
Creator: Pendley, Robert E. & Howell, Robert R.
Item Type: Refine your search to only Report
open access

Analysis of turbojet-engine controls for afterburning starting

Description: From Introduction: "The object of this report is to investigate the effects of after-burner lighting on the engine behavior and control-system requirements of a controlled turbojet engine. In this report, a simulation procedure for the afterburner is developed (based on ref. 3), this afterburner simulation is coordinated with previously developed nonafterburning-engine simulation procedures (ref. 4), and the compensated interacting control systems of references 1 and 2 are used. The results of … more
Date: October 8, 1956
Creator: Phillips, W. E., Jr.
Item Type: Refine your search to only Report
open access

Analysis of Wind-Tunnel Tests at Low Speeds of a Four-Engine Propeller-Driven Airplane Configuration Having a Wing With 40 Degrees of Sweepback

Description: Report presenting an investigation to determine the effects of operating propellers on the longitudinal characteristics of a four-engine tractor airplane with a 40 degree swept wing with an aspect ratio of 10. Results regarding components of the lift changes due to operating propellers, components of the pitching-moment changes due to operating propellers, effect of configuration changes on the pitching-moment characteristics of the model, stick-fixed longitudinal stability of the model, reduct… more
Date: October 8, 1954
Creator: Edwards, George G. & Buell, Donald A.
Item Type: Refine your search to only Report
open access

Analytical and experimental investigation of the effects of compressor interstage air bleed on performance characteristics of a 13-stage axial-flow compressor

Description: Air was bled over the fifth-and tenth-stage rotor-blade rows through ports designed to pass 11 and 9 percent of the inlet flow, respectively, at 80 percent speed. Along the rated operating line the maximum speed at which rotating stall was encountered was lowered by either of these bleeds, and the stall patterns below these speeds were altered so that no dangerous resonant rotor-blade bending vibrations were excited. The combination of the two bleeds completely eliminated rotating stall to at l… more
Date: February 8, 1957
Creator: Lucas, James G.; Geye, Richard P. & Calvert, Howard F.
Item Type: Refine your search to only Report
open access

An analytical method for evaluating factors affecting application of transpiration cooling to gas turbine blades

Description: From Introduction: "A survey of some of the advantages and problems associated with transpiration cooling of gas-turbine engines is given in reference 1, and its is shown therein that high pressure gradients around the periphery of gas-turbine blades require that the blade wall permeability be varied around the blade periphery in order for uniform cooling to be obtained over the entire blade surface. This fact is verified in experimental investigations of transpiration-cooled turbine blades mou… more
Date: September 8, 1952
Creator: Esgar, Jack B.
Item Type: Refine your search to only Report
open access

An analytical study of sideslip angles and vertical-tail loads in rolling pullouts as affected by some characteristics of modern high-speed airplane configurations

Description: From Introduction: "The rolling-pullout maneuver (any maneuver in which rolls occur during high g flight conditions) has been shown to be pertinent to design considerations from the standpoint of the loads produced on a vertical tail (refs. 1 to 3). In order to understand this problem better, the results of an analytical study of effects of large variations of some of the lateral-stability-derivative coefficients on the maximum angle of sideslip at first peak of its oscillation are presented in… more
Date: October 8, 1953
Creator: Stone, Ralph W., Jr.
Item Type: Refine your search to only Report
open access

Characteristics of Five Propellers in Flight

Description: "This investigation was made for the purpose of determining the characteristics of five full-scale propellers in flight. The equipment consisted of five propellers in conjunction with a VE-7 airplane and a Wright E-2 engine. The propellers were of the same diameter and aspect ratio. Four of them differed uniformly in thickness and pitch and the fifth propeller was identical with one of the other four with exception of a change of the airfoil section" (p. 267).
Date: November 8, 1927
Creator: Crowley, J. W., Jr. & Mixson, R. E.
Item Type: Refine your search to only Report
open access

Characteristics of perforated diffusers at free-stream Mach number 1.90

Description: "An investigation was conducted at Mach number 1.90 to determine pressure recovery and mass-flow characteristics of series of perforated convergent-divergent supersonic diffusers. Pressure recoveries as high as 96 percent were obtained, but at reduced mass flows through the diffuser. Theoretical considerations of effect of perforation distribution on shock stability in converging section of diffuser are presented and correlated with experimental data. A method of estimating relative importance … more
Date: May 8, 1950
Creator: Hunczak, Henry R. & Kremzier, Emil J.
Item Type: Refine your search to only Report
open access

Chemical igniters for starting jet fuel - nitric acid rockets

Description: Report presenting experiments in a 200-pound-thrust jet fuel-nitric acid rocket with an axial-flow igniter employing the hypergolic alkyl thiosphosphite-nitric acid system. No combustion instability was observed in the igniter, but many of the main-stage runs exhibited low-frequency oscillations.
Date: October 8, 1957
Creator: Morrell, Gerald & Ladanyi, Dezso J.
Item Type: Refine your search to only Report
open access

Comparative Drag Measurements at Transonic Speeds of 6-Percent-Thick Airfoils of Symmetrical Double-Wedge and Circular-Arc Sections From Tests by the NACA Wing-Flow Method

Description: Report presenting comparative drag measurements at zero lift at transonic speeds for two sharp-leading-edge airfoils using the NACA wing-flow method. One airfoil had a symmetrical circular-arc section and one had a symmetrical double-wedge section. The primary difference in the drag characteristics of the two airfoils at zero lift is the earlier drag rise of the double-wedge section.
Date: April 8, 1947
Creator: Silsby, Norman S.
Item Type: Refine your search to only Report
open access

Comparison between prediction and experiment for all-movable wing and body combinations at supersonic speeds: Lift, pitching moment, and hinge moment

Description: From Summary: "A simple method is presented for estimating lift, pitching-moment, and hinge-moment characteristics of all-movable wings in the presence of a body as well as the characteristics of wing-body combinations employing such wings. In general, good agreement between the method and experiment was obtained for the lift and pitching moment of the entire wing-body combination and for the lift of the wing in the presence of the body. The method is valid for moderate angles of attack, wing d… more
Date: August 8, 1952
Creator: Nielsen, Jack N.; Kaattari, George E. & Drake, William C.
Item Type: Refine your search to only Report
Back to Top of Screen