UNT Libraries Government Documents Department - Browse

ABOUT BROWSE FEED

10 MWe Sodium Deuterium Reactor Design Report

Description: From foreword: This report describes the goal of the overall SDR program to demonstrate the commercial generation of electrical power using a sodium-cooled reactor.
Date: 1959
Creator: Davis, Peter J.

20,000 KW Nuclear Power Plant Study for United States Atomic Energy Commission

Description: Introduction: In September of 156, Gilbert Associates, Inc., entered into a contract with the United States of America, acting through the United States Atomic Energy Commission, for the study and preliminary design of a nuclear power plant being considered for integration into a central station power system at an overseas site.
Date: July 7, 1957
Creator: Gilbert Associates, Inc.

Abnormal grain growth in M-252 and S-816 alloys

Description: Report discussing an experimental investigation was carried out on air- and vacuum-melted M-252 and S-816 alloys to find conditions of heating and hot-working which resulted in abnormal grain growth. The experiments were mainly limited to normal conditions of heating for hot-working and heat treatment and normal temperatures of solution treatment were used to allow grain growth after susceptibility to abnormal grain growth was developed by various experimental conditions. Results indicated that small reductions of essentially strain-free metal were the basic cause of such grain growth.
Date: November 1957
Creator: Decker, R F; Rush, A I; Dano, A G & Freeman, J W

Abnormal grain growth in nickel-base heat-resistant alloys

Description: From Introduction: "The data included in this report for Nimonic 80A alloy, for instance, represent experiments carried out to help clarify a production problem of grain-size control in an alloy which has been extensively used. The general procedure of the investigation was to carry out controlled laboratory experiments on samples of bar stock to find conditions of heating and hot-working which resulted in abnormal grain growth."
Date: December 1957
Creator: Decker, R F; Rush, A I; Dano, A G & Freeman, A G

Abnormal grain growth in S-816 alloy

Description: From Introduction: "This report presents the results obtained to date of an investigation to establish the fundamental causes of abnormal growth in S-816 alloy under conditions encountered during the forging of blades for the gas turbine of jet engines."
Date: April 1952
Creator: Rush, A I; Freeman, J W & White, A E

Acceleration of high-pressure-ratio single-spool turbojet engine as determined from component performance characteristics I : effect of air bleed at compressor outlet

Description: An analytical investigation was made to determine from component performance characteristics the effect of air bleed at the compressor outlet on the acceleration characteristics of a typical high-pressure-ratio single-spool turbojet engine. Consideration of several operating lines on the compressor performance map with two turbine-inlet temperatures showed that for a minimum acceleration time the turbine-inlet temperature should be the maximum allowable, and the operating line on the compressor map should be as close to the surge region as possible throughout the speed range. Operation along such a line would require a continuously varying bleed area. A relatively simple two-step area bleed gives only a small increase in acceleration time over a corresponding variable-area bleed. For the modes of operation considered, over 84 percent of the total acceleration time was required to accelerate through the low-speed range ; therefore, better low-speed compressor performance (higher pressure ratios and efficiencies) would give a significant reduction in acceleration time.
Date: March 10, 1953
Creator: Rebeske, John J , Jr & Rohlik, Harold E

Accelerations in fighter-airplane crashes

Description: From Introduction: "This report describes some measurements of these quantities obtained by crashing fighter aircraft under circumstances approximating those observed in service."
Date: November 4, 1957
Creator: Acker, Loren W; Black, Duglad O & Moser, Jacob C

Accelerations in transport-airplane crashes

Description: From Introduction: "A study of crash-impact survival in light airplanes is reported in references 1 and 2. A similar study for fighter airplanes is reported in reference 3. This report discusses crash-impact survival in transport airplanes."
Date: February 1958
Creator: Preston, G Merritt & Pesman, Gerard J

Accepted Limit Values of Air Pollutants

Description: Report issued by the U.S. Bureau of Mines discussing, as stated in the introduction, the "accepted maximum permissible concentrations of air pollutants from the standpoints of health, damage to vegetation, damage to property, and requirements of industrial processes" (p. 1). This report includes tables.
Date: May 1954
Creator: Barkley, J. F.

Accidental Radiation Excursion at the Y-12 Plant, June 16, 1958: Final Report

Description: This report describes the circumstances leading to the accident, attempts to reconstruct the nuclear reactivity conditions, and reviews the dosimetric means and results which were used to help determine the exposure of affected employees.
Date: September 12, 1958
Creator: Patton, F. S.; Bailey, J. C.; Callihan, A. D.; Googin, J. M.; Jasny, G. R.; McAlduff, H. J. et al.

Accidents from explosives at metal and nonmetallic mines

Description: Circular produced by the U.S. Bureau of Mines to promote safety through a series of reports on accident prevention in mines. According the the scope statement, "This is the fourth section of the revised series of circulars that cover various phases of accident prevention in metal and nonmetallic mines; it give information on accidents and injuries from storing, handling, and using explosive in metal and nonmetallic mines and discusses the precautions by which they can be prevented" (p. 2).
Date: 1957
Creator: Cash, Frank E.