UNT Libraries Government Documents Department - 1,263 Matching Results

Search Results

Accelerations and bottom pressures measured on a B-24D airplane in a ditching test

Description: From Introduction: "This report presents only that portion of the data from the first ditching which was to be used roughly establish the accelerations experienced by the pilot and the amount of water pressure to which the fuselage structure was subjected during the ditching."
Date: November 1944
Creator: Steiner, Margaret F.

Addition of heat to a compressible fluid in motion

Description: From Introduction: "The purpose of this report is to summarize, without extended proofs, the results of a study of a simplified model of nonadiabiatic, compressible fluid flow, both subsonic and supersonic, and to state these results in a form that will make them immediately useful in providing a theoretical background for current technical problems of high-speed combustion.
Date: February 1945
Creator: Hicks, Bruce L

Additional design charts relating to the stalling of tapered wings

Description: From Introduction: "The present report, therefore, may be considered a supplement to reference 1. The combined scope of the stall charts of reference 1, designated A, and of the present work, designated B, is summarized in the following table: For the wing with root thickness ratio to 18 was also investigated.
Date: January 1943
Creator: Harmon, Sidney M

Aerodynamic characteristics of a 4-engine monoplane showing comparison of air-cooled and liquid-cooled engine installations

Description: From Introduction: "An investigation has been conducted in the N.A.C.A. full-scale wind tunnel to determine the aerodynamic characteristics of a 1/4-scale model of a 4-engine monoplane when equipped with comparable air-cooled engine and liquid-cooled engine installations. The air-cooled engine installation consisted of nacelles equipped with N..A.C.A. cowlings and oil coolers located in the leading edge of the wing."
Date: July 1939
Creator: Wilson, Herbert A , Jr & Silverstein, Abe

Aerodynamic characteristics of a slot-lip aileron and slotted flap for dive brakes

Description: From Introduction: "As a part of this investigation, a study is being made of test results obtained during the development of devices designed primarily for other purposes, such as high lift or lateral control, but which may also be used for dive control. These results have been reanalyzed and are herein presented in a form that should make them convenient for design purposes."
Date: April 1941
Creator: Rogallo, F M

Aerodynamic characteristics of four NACA airfoil sections designed for helicopter rotor blades

Description: From Introduction: "The purpose of the present work is to extend the previous investigation and to derive additional airfoil sections designed to minimize the undesirable characteristics of the previously tested airfoils. The tests of these additional airfoils were made in the Langley two-dimensional low-turbulence tunnel (LTT)."
Date: February 1946
Creator: Rice, Fred J , Jr

Aerodynamic characteristics of several modifications of a 0.45-scale model of the vertical tail of the Curtiss XP-62 airplane

Description: From Introduction: "In the course of an investigation to find a satisfactory vertical tail for the XP-62 airplane, a 0.45-scale vertical tail model on a stub fuselage was tested in the Langley 7- by 10-foot tunnel. This model was fitted with a flat plate to represent the horizontal tail surface. The data are presented herein for their general interest value rather than their application to this particular airplane."
Date: July 1946
Creator: Liddell, Robert B.

Aerodynamic problems in the design of efficient propellers

Description: From General Analysis: "The purpose of part I of this paper is to show how the loading that gives the minimum induced energy loss can be obtained from rather elementary considerations and to present design charts from which such a plan form can be quickly obtained for any set of design conditions."
Date: August 1942
Creator: Feldman, Lewis