UNT Libraries Government Documents Department - 108 Matching Results

This system will be undergoing maintenance April 18th between 9:00AM and 12:00PM CDT.

Search Results

Results: 1 - 24 next
open access

Additional design charts relating to the stalling of tapered wings

Description: From Introduction: "The present report, therefore, may be considered a supplement to reference 1. The combined scope of the stall charts of reference 1, designated A, and of the present work, designated B, is summarized in the following table: For the wing with root thickness ratio to 18 was also investigated.
Date: January 1943
Creator: Harmon, Sidney M.
open access

Aerodynamic Data for a Wing Section of the Republic XF-12 Airplane Equipped With a Double Slotted Flap

Description: Report presenting an investigation in the two-dimensional low-turbulence tunnels for the purpose of developing an optimum flap configuration for maximum lift on an airfoil section for the Republic XF-12 airplane equipped with a double slotted flap. Lift and flap loads were obtained at several flap deflections for two flap paths. Results regarding lift, drag, and flap loads are provided.
Date: January 1946
Creator: Cahill, Jones F.
open access

Altitude Rating of Electrical Apparatus

Description: "This paper studies the effect of altitude on the ratings of rotating electric machines and after determining the fundamental principles involved, discusses these in relation to the application of such machines in modern aircraft" (p. 1).
Date: January 1943
Creator: Lebenbaum, Paul, Jr.
open access

Analysis of a thermal ice-prevention system for wing leading-edge landing-light installations

Description: From Introduction: "A typical ice formation on a wing leading-edge-type light installation is shown in figure 1. Although the primary purpose of this analytic investigation was to determine the practicability of providing a landing-light thermal ice-prevention system which could be incorporated with the wing leading-edge thermal ice-prevention system of the B-17 F airplane, the analysis has been developed in a general form for future application to similar deigns. "
Date: January 1944
Creator: Hillendahl, Wesley H.
open access

An analysis of the skipping characteristics of some full-size flying boats

Description: From Introduction: "The purpose of this report is to gather together in one place information on the skipping characteristics of number of flying boats. A graph showing the influence of the hull form on the skipping characteristics is given which should be useful in laying out the proportions of the hull in preliminary design to insure good landing behavior."
Date: January 1946
Creator: Locke, F. W. S., Jr.
open access

Boundary-Layer Transition on the N.A.C.A. 0012 and 23012 Airfoils in the 8-Foot High-Speed Wind Tunnel

Description: Report presenting determinations of boundary-layer transition on the NACA 0012 and 23012 airfoils in the high-speed wind tunnel over a range of Reynolds numbers. For all of the lift coefficients that testing occurred at, transition occurred in the region of estimated laminar separation at low Reynolds numbers and approached the point of minimum static pressure as a forward limit at high Reynolds numbers.
Date: January 1940
Creator: Becker, John V.
open access

Characteristics of Naca 4400R Series Rectangular and Tapered Airfoils, Including the Effect of Split Flaps

Description: "At the request of the Bureau of Aeronautics, Navy Department, tests were made in the variable-density wind tunnel of a tapered wing of 3-10-18 plan form and based on the NACA 4400R series sections. The wing was also tested with 0.2 chord split flaps, deflected 60 degrees, in the center of the wing and having flat span to wing span ratios of 0.3, 0.5, 0.7, and 1.0, respectively" (p. 1).
Date: January 1941
Creator: Greenberg, Harry
open access

Charts of Pressure, Density, and Temperature Changes at an Abrupt Increase in Cross-Sectional Area of Flow of Compressible Air

Description: "Equations have been derived for the change in the quantities that define the thermodynamic state of air - pressure, density, and temperature - at an abrupt increase in cross-sectional area of flow of compressible air. Results calculated from these equations are given in a table and are plotted as curves showing the variation of the calculated qualities with the area expansion ratio in terms of the initial Mach number as parameter. Only the subsonic region of flow is considered" (p. 1).
Date: January 1945
Creator: Joyner, Upshur T.
open access

Collection of Balanced-Aileron Test Data

Description: "Test data of balanced ailerons have been collected from NACA and British sources. These data, which are presented in the form of charts, are grouped as A - ailerons with Frise balances, B - ailerons with blunt-nose balances, C - ailerons with internal balances, D - ailerons with contour modifications, and E - ailerons with tabs. Results of flight tests and of wind-tunnel tests in both two- and three-dimensional flow are presented but no correlation nor resume of the data has been included" (p.… more
Date: January 1944
Creator: Rogallo, F. M.
open access

Comparison of an approximate and an exact method of shear-lag analysis

Description: Report presenting comparisons between the approximate substitute single-stringer method of shear-lag analysis and the exact solutions, which indicate that for beams of practical proportions the approximate method yields a value for the maximum root stress that exceeds the value obtained by use of the exact solution by less than 10 percent.
Date: January 1944
Creator: Duberg, John E.
open access

Comparison of various methods for computing drag from wake surveys

Description: "The various equations for computing profile drag by the momentum method are examined, and the errors arising from complete or partial neglect of compressibility effects in the Jones equation and the Bicknell equation are evaluated. The integrating method of Silverstein and Katzoff is shown to be accurate over a wide range of Mach number and wake shapes" (p. 1).
Date: January 1943
Creator: Davis, Wallace F.
open access

Compressible potential flow with circulation about a circular cylinder

Description: Report presenting the potential function for flow, with circulation, of a compressible fluid about a circular cylinder, which is obtained in series form including terms of the order of M(exp 4) where M is the Mach number of the free stream. The equations are used to obtain pressure coefficient as a function of Mach number at a point on the surface of the cylinder for different values of circulation.
Date: January 1944
Creator: Heaslet, Max A.
open access

Compressive Strength of Corrugated-Sheet-Stiffened Panels for Consolidated XB-36 Airplane

Description: "Compression tests were made of 63 panels stiffened with corrugated sheet. The specimens were constructed from artificially aged alclad 24S-T aluminum alloy with minimum guaranteed yield strengths of 57 and 48 kips per square inch for the flat- and corrugated-sheet materials, respectively. Results of the tests are presented in charts which show the average stresses at the maximum load and at buckling of the sheet" (p. 1).
Date: January 1944
Creator: Weinberger, Robert A.; Sperry, William C. & Dobrowski, Charles V.
open access

Correlation of Engine-Cooling Data

Description: Report discusses a method of correlating engine-cooling data and its application to a representative engine-cooling test. Considerations for the correlation method are given, but the application to specific engine-cooling problems should be simple and direct. Information about experimental procedure and an example with specific values are included.
Date: January 1945
Creator: Brimley, D. E. & Brevoort, Maurice J.
open access

Correlation of Mixture Temperature Data Obtained From Bare Intake-Manifold Thermocouples

Description: "A relatively simple equation has been found to express with fair accuracy, variation in manifold-charge temperature with charge in engine operating conditions. This equation and associated curves have been checked by multi cylinder-engine data, both test stand and flight, over a wide range of operating conditions. Average mixture temperatures, predicted by the equations of this report, agree reasonably well with results within the same range of carburetor-air temperatures from laboratories and… more
Date: January 1946
Creator: White, H. Jack & Gammon, Goldie L.
open access

Correlation of Wright Aeronautical Corporation Cooling Data on the R-3350-14 Intermediate Engine and Comparison With Data From the Langley 16-Foot High-Speed Tunnel

Description: Report presenting a comparison of the cooling-test data obtained on the identical Wright R-3350-14 engine equipped with the same cooling pressure-tube installation. The comparison reveals the large difference in cooling pressure drop that may be obtained in different test installations with the identical engine and pressure-tube installation because of an injudicious choice of pressure-tube locations.
Date: January 1945
Creator: Pinkel, Benjamin & Rubert, Kennedy F.
open access

Correlation Tests of the Ditching Behavior of an Army B-24D Airplane and a 1/16-Size Model

Description: Behaviors of both model and full-scale airplanes were ascertained by making visual observations, by recording time histories of decelerations, and by taking motion picture records of ditchings. Results are presented in form of sequence photographs and time-history curves for attitudes, vertical and horizontal displacements, and longitudinal decelerations. Time-history curves for attitudes and horizontal and vertical displacements for model and full-scale tests were in agreement; maximum longitu… more
Date: January 1946
Creator: Jarvis, George A. & Fisher, Lloyd J.
open access

Critical combinations of shear and transverse direct stress for an infinitely long flat plate with edges elastically restrained against rotation

Description: Report presenting an exact solution and a closely concurring approximate energy solution for the buckling of an infinitely long flat plate under combined shear and transverse direct stress with edges elastically restrained against rotation. An appreciable fraction of the critical stress in pure shear may be applied to the plate without any reduction in the transverse compressive stress necessary to produce buckling.
Date: January 1945
Creator: Batdorf, S. B. & Houbolt, John C.
open access

Design charts for cross-flow tubular intercoolers charge-across-tube type

Description: Report presenting equations relating the various dimensions, air mass flow, and performance of a cross-flow tubular intercooler in which the charge flows across and the cooling air through the tubes. Design charts are presented from which the intercooler design characteristics and performance can be quickly determined.
Date: January 1941
Creator: Reuter, J. George & Valerino, Michael F.
open access

Determination of Gas Temperatures from the Frequency of Knock-Induced Gas Vibrations in an Internal-Combustion Engine

Description: Report of a study to develop a method of obtaining gas temperatures from the frequency of knock-induced gas vibrations in an internal-combustion engine cylinder. Temperatures calculated from frequency data were in agreement with temperatures measured by the spectral line-reversal method in previous investigations and were about 700 degrees Fahrenheit lower than temperatures obtained from thermodynamic charts.
Date: January 1946
Creator: Moeckel, W. E. & Evvard, J. C.
open access

Determination of the Effect of Wing Flexibility on Lateral Maneuverability and a Comparison of Calculated Rolling Effectiveness With Flight Results

Description: Report presenting an analysis which shows that, when account is taken of sideslip and wing flexibility, the calculated rolling maneuverability of an airplane is in good agreement with the results obtained from flight tests. The method used avoids the complications of successive approximations but is nevertheless believed to be more nearly accurate than other methods based on semirigid-wing assumptions. The method is applied to a wing of tubular shell construction and the procedure is illustrate… more
Date: January 1944
Creator: Harmon, Sidney M.
Back to Top of Screen