UNT Libraries Government Documents Department - 34 Matching Results

Search Results

Results: 1 - 24 next
open access

Land Reclamation Program, Annual Report: July 1975-July 1976

Description: Annual report of the Argonne National Laboratory Land Reclamation Program outlining the activities and research conducted during the year, various assessments and discussion, and related documentation.
Date: December 1976
Creator: Argonne National Laboratory. Land Reclamation Program.
open access

Metallurgy Division Quarterly Report [for] October, November, and December 1955

Description: A total of nine clad plates, containing uranium -5 w/o zirconium 1.5 w/o niobium alloy cores and clad with Zircaloy-II, were rolled in plain carbon steel jackets, heat treated, physically evaluated, and corrosion tested. All these plates were found to be within predetermined dimensional tolerance in width, thickness, length, cladding thickness, and core distribution. Improved control of wielding variables and of the length of the seal pin projecting above the end plugs resulted in the eliminati… more
Date: June 1965
Creator: Foote, Frank G.; Schumar, James F. & Chiswik, Haim H.
open access

Chemical Engineering Division Summary Report

Description: Measurement of radioactive carry-over was made on borax III operating at 300 psig and at power levels ranging from 4 to 14 mv. Decontamination factors of from 1.5 x 104 (at 14 mv) were obtained. These data are in essential agreement with those predicted by previous laboratory experimental work.
Date: May 2, 1956
Creator: Lawroski, Stephen; Rodger, W. A.; Vogel, R. C. & Munnecke, V. H.
open access

Quarterly Report January, February and March, 1956

Description: The EBWR loading requires a total of 888 plates. It is anticipated that approximately 1000 plates will have to be produced to obtain the number of acceptable plates required for the loading. To the end of this quarter, 568 cladding billet cores acceptable with respect to chemical composition and physical soundness had been cast; this number represents 78% of the total number of cores cast. Approximately 75% of the Zircaloy-II stock required has been rolled, and about 55% of the cladding compone… more
Date: June 1956
Creator: Foote, Frank G.; Schumar, James F. & Chiswik, Haim H.
open access

The Fabrication of Prototype Fuel Elements for the Experimental Boiling Water Reactor and the Experimental Breeder Reactor

Description: The purpose of this program was to develop techniques and methods for producing fuel elements for the Experimental Boiling Water and Experimental Breeder Reactors. Methods for fabricating large tubes, flat plates, and small pins were investigated. The tube and plates contained U-5 w/o Zr-1.5 w/o Nb alloy and were designed for the EBWR. The pins contained U-2 w/o Zr alloy and were designed for the EBR. Cladding and end seal material of Zircaloy-2 was required for the water-cooled EBWR elements. … more
Date: May 1956
Creator: Sawyer, H. F.; Paynton, W. C.; Loewenstein, P. & Corzine, P.
open access

Quarterly Progress Report on Reactor Development 400 Program

Description: Physics calculations have been made for various combinations of the four types of fuel assemblies to be used in the EBWR core. Two thicknesses of plates, 0.205 in. and 0.274 in., including the two 0.020-in. cladding layers, are to be made of both natural U and U containing 1.44% U235. A total of 148 assemblies, 74 natural and 74 enriched, are to be fabricated with six identical plates each. Various configurations of these fuel assemblies will be used to (1) change the critical size of the core,… more
Date: April 30, 1956
Creator: Stuart McLain & Members of the Laboratory Staff
open access

Chemical Engineering Division Summary Report July, August, and September, 1956

Description: Additional runs have been made in the six-inch, continuous-flow mixing chamber to study the rate of mass transfer between isobutanol and water. These runs were inconclusive because the effluents were mutually saturated. A new four-inch cell has been designed and is being fabricated; this will permit a reduction in the time available for mass transfer. Consideration has been given to other liquid pairs which may transfer more slowly than isobutanol-water. The system nitrobenzene-ethylene glycol … more
Date: December 1956
Creator: Rodger, W. A.; Vogel, R. C. & Munnecke, V. H.
open access

Chemical Engineering Division Summary Report October, November, and December, 1956

Description: A final series of runs was made in a four-inch continuous-flow mixing chamber to study the transfer of isobutanol into water and nitrobenzene into ethylene glycol. Satisfactory techniques were developed to provide for the rapid analysis of these systems. In addition, a light-scattering correlation was prepared to provide a measure of the interfacial area of the yellow-colored nitrobenzene-ethylene glycol mixtures.
Date: March 1957
Creator: Lawroski, Stephen; Rodger, W. A.; Vogel, R. C. & Munnecke, V. H.
open access

Quarterly Report October, November and December, 1956

Description: Methods of producing extremely clean surfaces on rolled Zircaloy-2 strip have been investigated. It has been found that the finer abrasives, 400 mesh or finer, are more effective than coarse types because of their ability to penetrate pits and crevices more readily. Two such cleanings, with an intermediate 35 v/o HNO3-5 v/o HF pickle, resulted in a microscopically clean surface. Ultrasonic inspection of the EBWR fuel plates has been completed during this quarter. Approximately 95% of the plates… more
Date: December 31, 1956
Creator: Foote, Frank G.; Schumar, James F. & Chiswik, Haim H.
open access

Chemical Engineering Division Summary Report July, August, and September, 1957

Description: Development work continued on a fused salt process for the recovery of uranium from zirconium-matrix fuel alloys. The fuel is dissolved in a sodium fluoride-zirconium fluoride melt at 600°C by hydrogen fluoride sparging. The melt is then sparged with fluorine gas which volatilizes the dissolved uranium as the hexafluoride. The final decontamination and purification of the uranium hexafluoride are accomplished by fractional distillation. The testing of graphite as a container material for the hy… more
Date: December 1957
Creator: Lawroski, Stephen; Rodger, W. A.; Vogel, R. C. & Munnecke, V. H.
open access

The Fabrication of a Plutonium Helix for a Doppler Experiment

Description: A helix constructed of plutonium was made to test the Doppler temperature effect in ZPR-III. The helix, 1 inch in diameter and 6-1/4 inches long, contained 240 grams of delta-phase plutonium alloy encapsulated in titanium tubing. Four plutonium rods were extruded, joined together, and pushed into a titanium tube. This tube was swaged tightly over the plutonium rod, and the assembly was wound into a coil. Electrical leads to the coil were made by swaging copper tubing over the ends of the coil. … more
Date: December 1958
Creator: Dunworth, R. J.; Rhude, H. V. & Kelman, L. R.
open access

Operating Manual for the Argonaut Reactor

Description: The design of the Argonaut (Argonne Nuclear Assembly for University Training) was initiated by the Reactor Engineering Division of Argonne National Laboratory to satisfy needs for a low-power reactor facility within the Laboratory, and for training uses within the international School of Nuclear Science and Engineering (ISNSE). It was intended primarily for instruction and research in reactor physics. It was also considered as a possibility that it would fulfill the requirements of universities… more
Date: August 1959
Creator: Argonne National Laboratory
open access

Interim Report: Faret Experimental Program

Description: From Introduction: "The Fast Reactor Test (FARET) program is part of the United States Fast Reactor Program directed toward the demonstration of breeder reactors essential to the long-range goal of utilizing fertile fuels. (1) With-in this program is the current thinking that the early construction and operation of two or three prototype nuclear power plants of the order of 250 Mw(e) will lead eventually to the construction of practical and economic full scale breeder reactors by the early 1980… more
Date: April 1963
Creator: Smaardyk, A.; Bump, T. R.; Handwerk, J. & Handwerk, J.
open access

A Multiple-Source Urban Atmospheric Dispersion Model

Description: Report documenting the development phase of a multiple-source, urban atmospheric dispersion model that describes environmental transients.
Date: May 1970
Creator: Roberts, John J.; Croke, E. J.; Kennedy, A. S.; Norco, J. E. & Conley, L. A.
open access

Summary of Conference on the Toxicity of Carbon 14 Held at Argonne National Laboratory, January 15-16, 1952

Description: Report issued by the Argonne National Laboratory discussing the Conference on the Toxicity of Carbon 14. At the outset of the meeting it was emphasized that the group was brought together to discuss work which had a bearing on the toxicity of C14 compounds used either clinically or industrially, and the hope was expressed that the group might be able to reach some conclusions on these matters. This report includes tables.
Date: March 1952
Creator: Brues, A. M. & Buchanan, D. L.
open access

Stirling-Engine Thermodynamic Analysis: A Users Guide To SEAM1

Description: From Abstract: This report provides background and procedural information for the use of a general-purpose Stirling-engine analysis code developed at Argonne National Laboratory and available through the National Energy Software Center. Different engine configurations are easily specified, or the user may make use of provided data for existing engines, both kinematic and free piston. The code models heat transfer and fluid mechanics throughout the engine and accounts for system energy flows and… more
Date: September 1982
Creator: Heames, T. J.; Uherka, D. J.; Zabel, J. C & Daley, J. C.
open access

Reactor Engineering Division Quarterly Report Section I January, February, March. 1956

Description: Physical calculations have been performed for various combinations of the four types of fuel assemblies to be used in the EBWR core. Two thicknesses of plates (0.205 in. and 0.274 in., including two 0.020-in. cladding layers) are to be made of both natural uranium and uranium containing 1.44% U235. Any given fuel assembly contains six identical plates. A total of 148 assemblies, 74 natural and 74 enriched, are to be fabricated. Various configurations of these fuel assemblies can be used to (1) … more
Date: July 1956
Creator: Members of the Reactor Engineering Division
open access

The Manufacture of Enriched ZPR-III Fuel Plates

Description: This report is essentially a procedural account of the fabrication of certain enriched ZPR-III fuel plates for use in the ANL fast critical experiments at Arco, Idaho. A total of 208.92 kilograms of fully enrich, unalloyed uranium was processed. Of this amount 202.74 kilograms was received in the form of Oak Ridge type reduction buttons and 6.18 kilograms as pressed-powder plates. The completed fabrication consisted of 720 rectangular fuel plates having the nominal dimensions 3in. x 2in. x 1/8i… more
Date: October 1956
Creator: Yaggee, Frank L.
open access

Table of Sin θ and Sin2 θ for Values of θ from 2° to 87°

Description: The table of sin θ and sin2 θ, to five decimal places for every hundreth of a degree from 2°-87°, has been prepared for the use of Professor W. H. Zachariasen in his X-ray diffraction studies. [Tables not transcribed]
Date: March 1956
Creator: Plettinger, H. Anne
open access

A Coated Cast Iron Crucible for use with Eutectic Al-Si Alloy in the Temperature Range 595°-650°C

Description: The feasibility of the coated metal crucible as a container for eutectic Al-Si alloy has been proven by test. Small, enamel-coated cast iron pots has been proven by test. Small, enamel-coated cast iron pots have successfully withstood the chemically aggressive Al-Si alloy and the adverse influence of an oxidizing atmosphere for a period of 3 months at 725°C. A similarly coated castiron crucible containing 450 pounds of eutectic Al-Si alloy was successfully tested for 144 days in a jacketing ope… more
Date: November 1957
Creator: Yaggee, F. L.
Back to Top of Screen