UNT Libraries Government Documents Department - 265,644 Matching Results

Search Results

open access

0-2 kv Flash Tube Supplies

Description: In order to perform the various experiments with a bubble chamber, a high intensity flash tube is used. This report briefly describes the power supplies designed and constructed to power these lamps.
Date: March 15, 1962
Creator: Miller, D. M.
open access

0-2 kv Flash Tube Supplies

Description: The power supplies designed and constructed to power high-intensity flash tubes are described. Three supplies, capable of charging 100 mfd to 2 kv with a repetltion rate of not less than 0.8 sec, are operated remotely from a control panel containing 3 powerstats. The power supplies are full wave center trapped rectifiers employing silicon rectifiers. (M.C.G.)
Date: March 15, 1962
Creator: Miller, D. M.
open access

0. 20-m (8-in.) Primary Burner Development Report

Description: High-Temperature Gas-Cooled Reactors (HTGRs) utilize graphite-base fuels. Fluidized-bed burners are being employed successfully in the experimental reprocessing of these fuels. The primary fluidized-bed burner is a unit operation in the reprocessing flowsheet in which the graphite moderator is removed. A detailed description of the development status of the 0.20-m (8-in.) diameter primary fluidized-bed burner as of July 1, 1977 is presented. Experimental work to date performed in 0.10; 0.20; an… more
Date: December 1977
Creator: Stula, R. T.; Young, D. T. & Rode, J. S.
open access

The 0.38 Percent Across-the-Board Cut in FY2000 Appropriations

Description: This report outlines cuts made in the federal budget for FY2000. The 0.38% cut was expected to yield savings of $2.4 billion in budget authority and $1.4 billion in outlays for the fiscal year. Departments with cuts in excess of $100 million included the Departments of Defense, Transportation, Health and Human Services, and Education.
Date: February 25, 2000
Creator: Keith, Robert
open access

0.351 micron Laser Beam propagation in High-temperature Plasmas

Description: A study of the laser-plasma interaction processes have been performed in plasmas that are created to emulate the plasma conditions in indirect drive inertial confinement fusion targets. The plasma emulator is produced in a gas-filled hohlraum; a blue 351-nm laser beam propagates along the axis of the hohlraum interacting with a high-temperature (T{sub e} = 3.5 keV), dense (n{sub e} = 5 x 10{sup 20}cm{sup -3}), long-scale length (L {approx} 2 mm) plasma. Experiments at these conditions have demo… more
Date: December 10, 2007
Creator: Froula, D.; Divol, L.; Meezan, N.; Ross, J.; Berger, R. L.; Michel, P. et al.
open access

0.52eV Quaternary InGaAsSb Thermophotovoltaic Diode Technology

Description: Thermophotovoltaic (TPV) diodes fabricated from 0.52eV lattice-matched InGaAsSb alloys are grown by Metal Organic Vapor Phase Epitaxy (MOVPE) on GaSb substrates. 4cm{sup 2} multi-chip diode modules with front-surface spectral filters were tested in a vacuum cavity and attained measured efficiency and power density of 19% and 0.58 W/cm{sup 2} respectively at operating at temperatures of T{sub radiator} = 950 C and T{sub diode} = 27 C. Device modeling and minority carrier lifetime measurements of… more
Date: June 9, 2004
Creator: Dashiell, M. W.; Beausang, J. F.; Nichols, G.; Depoy, D. M.; Danielson, L. R.; Ehsani, H. et al.
open access

0-D study of the compression of low temperature spheromaks

Description: Compression of low temperature spheromak plasmas has been studied with the aid of a O-D two-fluid computer code. It is found that in a plasma which is radiation dominated, the electron temperature can be increased by up to a factor of seven for a compression of a factor of two, provided the temperature is above some critical value (approx.25eV) and the electron density particle confinement time product n/sub e/tau/sub p/ greater than or equal to 1 x 10/sup 9/s/cm/sup 3/. If the energy balance i… more
Date: September 1, 1985
Creator: Meyerhofer, D. D.; Hulse, R. A. & Zweibel, E. G.
open access

D-0 End Calorimeter Warm Tube/TeV Dry Air Purge

Description: This Engineering Note studies the design of the Dry Air Purge that is going to flow through the Warm Tube of the End Calorimeter of the D-O Calorimeter. The Tev tubes through the E.C. can be thought of as a cluster of concentric tubes: The Tev tube, the warm (vacuum vessel) tube, 15 layers of superinsulation, the cold (argon vessel) tube, and the Inner Hadronic center support tube. The Dry Air Purge will involve flowing Dry Air through the annular region between the Warm Tube and the Tev Beam P… more
Date: August 14, 1991
Creator: Leibfritz, J. R.
open access

D-0 North End Cap Calorimeter Cold Test Results

Description: The North endcap calorimeter vessel was recieved on July 1, 1990. A cooldown of the pressure vessel with liquid nitrogen was performed on July 10-11 to check the vessel's integrity. With the pressure vessel cold, the insulating vacuum was monitored for leaks. Through out the testing, the insulating vacuum remained good and the vessel passed the test. The cold test was carried out per the procedures of D-Zero engineering note 3740.220-EN-250. The test was very similar to the cold test performed … more
Date: August 2, 1990
Creator: Michael, J.
open access

D-0 South End Cap Calorimeter Cold Test Results

Description: The South endcap calorimeter vessel was moved into Lab A on Sept. 18, 1990. A cooldown of the pressure vessel with liquid nitrogen was performed on Sept. 26 to check the vessel's integrity. With the pressure vessel cold, the insulating vacuum was monitored for leaks. Through out the testing, the insulating vacuum remained good and the vessel passed the test. The cold test was carried out per the procedures of D-Zero engineering note 3740.220-EN-250. The test was very similar to the cold test pe… more
Date: November 26, 1990
Creator: Rucinski, R.
open access

1-1/2-Loop Semiscale Isothermal Test Program: Program and System Description in Support of Experiment Data Reports.

Description: The isothermal test series is part of the Semiscale Blowdown and Emergency Core Cooling (ECC) Project conducted by Aerojet Nuclear Company for the U. S. Atomic Energy Commission. The test series consisted of ten blowdown tests and five hot-wall tests with emphasis on emergency core coolant delivery. The blowdown tests were conducted to investigate the effects of lower plenum geometry, heat transfer configuration, ECC injection location, downcomer gap size, and break size.
Date: February 1, 1974
Creator: Aerojet Nuclear Company
open access

1/2/Sup +/. -->. 1/2/Sup -/ Beta Decay of /Sup 19/Ne and the Parity Nonconserving Nn Force

Description: A branching ratio of (1.20 +- 0.20) x 10/sup -4/ is obtained for the ..beta../sup +/ decay of /sup 19/Ne to the 110 keV 1/2/sup -/ level of /sup 19/F. This transition (presumably dominated by the ..delta..J/sup ..pi../ = 0/sup -/ axial charge operator) provides a crucial test of wavefunctions used in interpreting the parity mixing of the ground and 110 keV levels of /sup 19/F. These wavefunctions, which yield a parity mixing larger than that observed experimentally, also predict too large a ..b… more
Date: 1978~
Creator: Adelberger, E. G.; Hindi, M. M.; Hoyle, C. D.; Swanson, H. E. & Von Lintig, R. D.
open access

1,3,5-trichlorobenzene progress report, July--September 1976

Description: Research progress is reported on the following topics: (1) conversion of 2, 4, 6-trichloroaniline to 2, 4, 6-trichloronitrobenzene; (2) nitration of 1, 2, 4-trichlorobenzene; (3) exploration of the route to 1, 3, 5-trichlorobenzene via aniline; and (4) direct nitration of trichloroaniline. (TFD)
Date: September 1, 1976
Creator: Estes, Z. L.
open access

A 1. 5--4 Kelvin detachable cold-sample transfer system: Application to inertially confined fusion with spin-polarized hydrogens fuels

Description: A compact cold-transfer apparatus for engaging and retrieving samples at liquid helium temperatures (1.5--4K), maintaining the samples at such temperatures for periods of hours, and subsequently inserting them in diverse apparatuses followed by disengagement, is described. The properties of several thermal radiation-insulating shrouds, necessary for very low sample temperatures, are presented. The immediate intended application is transportable target-shells containing highly spin-polarized deu… more
Date: January 1, 1990
Creator: Alexander, N.; Barden, J.; Fan, Q. & Honig, A.
open access

1.5% boron, stainless steel

Description: A test report on the brittleness of borated steel to be used in the KIWI B-5 shield capsules.
Date: September 19, 1962
Creator: Schreiber, J.J.
open access

1.8.2.1.2 Site system engineering implementation Fiscal Year 1998 multi-year work plan

Description: Manage the Site Systems Engineering process to provide a traceable, integrated, requirements-driven, and technically defensible baseline., Through the Site Integration Group, Systems Engineering ensures integration of technical activities across all site projects. Systems Engineering`s primary interfaces are with the Project Direction Office and with the projects, as well as with the Planning organization.
Date: October 3, 1997
Creator: Ferguson, J. E.
open access

1.8.3 Site system engineering FY 1997 program plan

Description: The FY 1997 Multi-Year Work Plan (MYWP) technical baseline describes the functions to be accomplished and the technical standards that govern the work. The following information is provided in this FY 1997 MYWP: technical baseline, work breakdown structure, schedule baseline, cost baseline, and execution year.
Date: September 13, 1996
Creator: Grygiel, M. L.
open access

1/12-Scale mixing interface visualization and buoyant particle release tests in support of Tank 241-SY-101 hydrogen mitigation

Description: In support of tank waste safety programs, visualization tests were performed in the 1/12-scale tank facility, using a low-viscosity simulant. The primary objective of the tests was to obtain video records of the transient jet-sludge interaction. The intent is that these videos will provide useful qualitative data for comparison with model predictions. Two tests were initially planned: mixing interface visualization (MIV) and buoyant particle release (BPR). Completion of the buoyant particle rel… more
Date: October 1, 1993
Creator: Eschbach, E. J. & Enderlin, C. W.
open access

1/12-scale physical modeling experiments in support of tank 241-SY- 101 hydrogen mitigation

Description: Hanford tank 241-SY-101 is a 75-ft-dia double-shell tank that contains approximately 1.1 M gal of radioactive fuel reprocessing waste. Core samples have shown that the tank contents are separated into two main layers, a article laden supernatant liquid at the top of the tank and a more dense slurry on the bottom. Two additional layers may be present, one being a potentially thick sludge lying beneath the slurry at the bottom of the tank and the other being the crust that has formed on the surfa… more
Date: January 1, 1993
Creator: Fort, J. A.; Bamberger, J. A.; Bates, J. M.; Enderlin, C. W. & Elmore, M. R.
open access

1/12-scale physical modeling experiments in support of tank 241-SY- 101 hydrogen mitigation. Final report

Description: Hanford tank 241-SY-101 is a 75-ft-dia double-shell tank that contains approximately 1.1 M gal of radioactive fuel reprocessing waste. Core samples have shown that the tank contents are separated into two main layers, a article laden supernatant liquid at the top of the tank and a more dense slurry on the bottom. Two additional layers may be present, one being a potentially thick sludge lying beneath the slurry at the bottom of the tank and the other being the crust that has formed on the surfa… more
Date: January 1993
Creator: Fort, J. A.; Bamberger, J. A.; Bates, J. M.; Enderlin, C. W. & Elmore, M. R.
Back to Top of Screen