UNT Libraries Government Documents Department - 5,164 Matching Results

Search Results

Aerodynamic and hydrodynamic characteristics of a deck-inlet multijet water-based-aircraft configuration designed for supersonic flight

Description: From Introduction: "In the present investigation, lift, drag, and pitching moment were determined over a Mach number range 0.6 to 1.42. Smooth-water takeoff and landing stability and resistance were investigated. A brief check of the rough-water spray and behavior was also made."
Date: December 5, 1956
Creator: Bielat, Ralph P; Coffee, Claude W , Jr & Petynia, William W

Aerodynamic and hydrodynamic characteristics of a proposed supersonic multijet water-based hydro-ski aircraft with a variable-incidence wing

Description: From Introduction: "The configuration described in this paper represents one approach to such an airplane and the results of the wind-tunnel and tank evaluations are presented. In the present investigation, the aerodynamic longitudinal characteristics over a Mach number range from 0.6 to 1.97 were obtained."
Date: October 23, 1957
Creator: Petynia, William W.; Hasson, Dennis F. & Spooner, Stanley H.

Aerodynamic and hydrodynamic characteristics of models of some aircraft-towed mine-sweeping devices : TED No. NACA AR 8201

Description: From Introduction: "A study is being conducted by the U.S. Naval Air Development Center to determine the feasibility of several airborne magnetic mine-sweeping methods. The advantages of a satisfactory airborne method are greater safety and speed than are possible with existing surface methods. The three configurations investigated are described in some detail in reference 1 where they are designated as the double Q-sweep, the modified double-catenary sweep and the M-sweep."
Date: December 1, 1955
Creator: Shanks, Robert E

Aerodynamic characteristics and pressure distributions of a 6-percent-thick 49 degree sweptback wing with blowing over half-span and full-span flaps

Description: From Introduction: "The investigation reported herein was initiated to define further the effects on the aerodynamic characteristics and load distribution of a thin, sweptback wing of a low-pressure blowing system and also to provide information on which to base a more thorough study of a complete airplane configuration."
Date: September 20, 1955
Creator: Whittle, Edward F , Jr & Mclemore, H Clyde

Aerodynamic characteristics at high and low subsonic Mach numbers of four NACA 6-series airfoil sections at angles of attack from -2 to 31 degrees

Description: From Introduction: "The airfoil sections tested, which differ only in thickness ratio, were the NACA 64-006, 64-008, 64-010, and 641-012. Lift, drag, and pitching-moment data were obtained for Mach numbers of 0.3 to that for tunnel choke at angles of attack of -2^o to 31^o. The results of this investigation are reported herein."
Date: June 5, 1953
Creator: Wilson, Homer B., Jr. & Horton, Elmer A.

Aerodynamic Characteristics at High and Low Subsonic Mach Numbers of the NACA 0012, 64(sub 2)-015, and 64(sub 3)-018 Airfoil Sections at Angles of Attack from -2 Degrees to 30 Degrees

Description: An investigation has been made in the Langley low-turbulence pressure tunnel of the aerodynamic characteristics of the NACA 0012, 64(sub 2)-015, and 64(sub 3)-018 airfoil sections. Data were obtained at Mach numbers from 0.3 to that for tunnel choke, at angles of attack from -2deg to 30deg, and with the surface. of each airfoil smooth-and with roughness applied at the leading edge.The Reynolds numbers of the tests ranged from 0.8 x 10(exp 6) to 4.4 x 10(exp 6). The results are presented as variations of lift, drag, and quarter-chord pitching-moment coefficients with Mach number.
Date: 1954?
Creator: Critzos, Chris C.

Aerodynamic characteristics at high speeds of a two-blade NACA 10-(3)(062)-045 propeller and of a two-blade NACA 10-(3)(08)-045 propeller

Description: From Introduction: "The aerodynamic characteristics of a series of 10-foot-diameter propellers are being investigated in the Langley 16-foot high-speed tunnel in a comprehensive propeller research program. Using high-critical-speed NACA 16-series airfoil sections (reference 1), these propellers are designed to have Betz minimum induced-energy loss loading (reference 2) for a blade angle of 45^o at the 0.7 radius, when used as a four-blade propeller operating at an advance ratio of approximately 2.1 The ultimate purpose of the program is to determine the influence upon propeller design factors and of compressiblity; the propeller tests reported herein form part of the investigation of the effects of blade-section thickness ratio."
Date: October 1, 1948
Creator: Solomon, William

Aerodynamic Characteristics at High Speeds of Full-Scale Propellers having Different Shank Designs

Description: Tests of two 10-foot-diameter two-blade propellers which differed only in shank design have been made in the Langley 16-foot high-speed tunnel. The propellers are designated by their blade design numbers, NACA 10-(5)(08)-03, which had aerodynamically efficient airfoil shank sections, and NACA l0-(5)(08)-03R which had thick cylindrical shank sections typical of conventiona1 blades, The propellers mere tested on a 2000-horsepower dynamometer through a range of blade-angles from 20deg to 55deg at various rotational speeds and at airspeeds up to 496 miles per hour. The resultant tip speeds obtained simulate actual flight conditions, and the variation of air-stream Mach number with advance ratio is within the range of full-scale constant-speed propeller operation. Both propellers were very efficient, the maximum envelope efficiency being approximately 0,95 for the NACA 10-(5)(08)-03 propeller and about 5 percent less for the NACA 10-(5)(08)-03R propeller. Based on constant power and rotational speed, the efficiency of the NACA 10-(05)(08)-03 propeller was from 2.8 to 12 percent higher than that of the NACA 10-(5)(08)-03R propeller over a range of airspeeds from 225 to 450 miles per hour. The loss in maximum efficiency at the design blade angle for the NACA 10-(5)(08)-03 and 10-(5)(08)-03R propellers vas about 22 and 25 percent, respectively, for an increase in helical tip Mach number from 0.70 to 1.14.
Date: February 13, 1947
Creator: Maynard, Julian D.

Aerodynamic characteristics at Mach number of 2.01 of two cruciform missile configurations having 70 degree delta wings with length-diameter ratios of 14.8 and 17.7 with several canard controls

Description: From Introduction: "The present paper contains the results of the investigation of the aerodynamic characteristics at Mach number of 2.01 of the two cruciform wing missiles equipped with larger canard controls and compares the result with that obtained previously with a smaller control."
Date: August 30, 1954
Creator: Spearman, M. Leroy & Robinson, Ross B.

Aerodynamic characteristics at subcritical and supercritical Mach numbers of two airfoil sections having sharp leading edges and extreme rearward positions of maximum thickness

Description: From Introduction: "A 12-percent-chord-thick wedge section and a reversed NACA 0012 section were chosen for these tests as they are representative of sections having no boat tailing and appreciable boat tailing (i.e., blunt and rounded trailing edges, respectively), and the results of this investigation are compared with those obtained from a previous investigation of the NACA 0012 section. Conclusions are drawn regarding the relative merits of the two unconventional sections and the conventional section in transonic speed range."
Date: November 6, 1947
Creator: Eggers, A J , Jr