Waste-to-energy has become an attractive alternative to landfills. One concern in this development is the release of pollutants in the combustion process. The binder enhanced d-RDF pellets satisfy the requirements of environmental acceptance, chemical/biological stability, and being storeable. The acid gas emissions of combusting d-RDF pellets with sulfur-rich coal were analyzed by ion chromatography and decreased when d-RDF pellets were utilized. The results imply the possibility of using d-RDF pellets to substitute for sulfur-rich coal as fuel, and also substantiate the effectiveness of a binder, calcium hydroxide, in decreasing emissions of SOx. In order to perform the analysis of the combustion sample, sampling and sample pretreatment methods prior to the IC analysis and the first derivative detection mode in IC are investigated as well. At least two trapping reagents are necessary for collecting acid gases: one for hydrogen halides, and the other for NOx and SOx. Factors affecting the absorption of acid gases are studied, and the strength of an oxidizing agent is the main factor affecting the collection of NOx and SOx. The absorption preference series of acid gases are determined and the absorption models of acid gases in trapping reagents are derived from the analytical results. To prevent the back-flushing of trapping reagents between impingers when leak-checking, a design for the sampling train is suggested, which can be adopted in sample collections. Several reducing agents are studied for pretreating the sample collected in alkali-permanganate media. Besides the recommendation of the hydrogen peroxide solution in EPA method, methanol and formic acid are worth considering as alternate reducing agents in the pretreatment of alkaline-permanganate media prior to IC analysis. The first derivative conductivity detection mode is developed and used in IC system. It is efficient for the detection and quantification of overlapping peaks as well as being applicable for non-overlapping …
Nuclear magnetic resonance (NMR) provides a convenient probe for the study of molecular reorientation in liquids because nuclear spin-lattice relaxation times are dependent upon the details of molecular motion. The combined application of Raman and Infrared (IR) lineshape analysis can furnish more complete information to characterize the anisotropic rotation of molecules. Presented here are the studies of NMR relaxation times, together with Raman/IR Mneshape analysis of the solvent and temperature dependence of rotational diffusion in 1,3,5-tribromobenzene and 1,3,5-trifluorobenzene. In these experiments, it was found that the rotational diffusion constants calculated from Perrin's stick model were two to three times smaller than the measured values of D, and D,,. Similarly, rotational diffusion constants predicted by the Hu-Zwanzig slip model were too large by a factor of 2. Application of the newer Hynes-Kapral-Weinberg model furnished rotational diffusion constants that were in reasonable agreement with the experimental results. The vibrational peak frequencies and relaxation times of the isotropic Raman spectra of the υ1 modes of CD2Br2 and CHBr3 were studied in solution. The frequency shifts in non-interactive solvents were explained well on the basis of solution variations in the dispersion energy. In Lewis bases, the displacements were in some, but not all, cases greater than predicted. On the other hand, it was found that the vibrational relaxation times of the C-H/C-D modes decreased dramatically in all Lewis base solvents. Therefore, it was concluded that relaxation times of the υ1 modes, rather than frequency shifts, furnish a more reliable measure of hydrogen bonding interactions of halomethanes in solution.
The synthesis of E- and Z-1,1,2,3-tetramethylsilacyclobutanes is described. Pyrolysis of either isomer at 398.2 °C provides the same products but in different amounts: propene, E- and Z-2-butene, allylethyldimethylsilane, dimethylpropylsilane, the respective geometric isomers, 1,1,2,3,3-pentamethyl-1,3-disilacyclobutane, 1,1, l-ethyldimethyl-2,2,2-vinyldimethyl-disilane and E- and Z-1,1,2,3,3,4-hexamethyl-1,3-disilacyclobutane. Mechanisms involving di- and trimethylsilenes are described for disilane formation and rate constants of the elementary steps for the fragmentation reactions are reported. Photochemically generated dimethylsilylene in the hydrocarbon solution inserts into the cyclic Ge-C or Si-C bonds of 1,1-dimethylgerma- or silacyclobutane to produce 1-germa-2-sila- or 1,2-disilacyclopentane. The relative reactivities of 1,1-dimethylgerma- and silacyclobutanes toward the dimethylsilylene have been determined. The carbenoid resulting from the cuprous chloride catalyzed decomposition of diazomethane at 25 °C in cyclohexane reacts with 1,1-dimethylgermacyclobutane to give, surprisingly 1,1,5,5-tetramethyl-1,5-digermacyclooctane as the major product. The reactions of the carbenoid with 1,1-dimethylsilacyclobutane are described. The kinetics of gas phase thermal decomposition of 1,1-dimethylgermacyclobutane has been studied over the temperature range, 684 - 751 K at pressures near 14 Torr. The Arrhenius parameters for the formation of ethylene are k_1 (s^-1) = 10^(14.6 ± 0.3) exp (62.7 ± 2.9 kcal mol^-1/RT) and those for the formation of propene and cyclopropane are k_2 (s^-1) = 10^(14.0 ± 0.1 ) exp (60.4 ± 2.8 kcal mol^-1/RT). Static gas phase pyrolyses of 1,1-dimethyl-lsilacyclobutene, DMSCB, in the presence of a variety of alkenes and alkynes at 260 - 365 °C have been studied. Our experimental results suggest that under these conditions the DMSCB ring opens to 1,1-dimethyl-l-silabutadiene, which either recyclizes to DMSCB or reacts with alkenes or alkynes in competing 4 + 2 and 2 + 2 cycloadditions.
This dialog allows you to filter your current search.
Each of the Months listed note their name and the number of records that will be limited down to if you choose that option.