UNT Theses and Dissertations - 5 Matching Results

Search Results

Results: 1 - 5

Application of Thermomechanical Characterization Techniques to Bismuth Telluride Based Thermoelectric Materials

Description: The thermoelectric properties of bismuth telluride based thermoelectric (TE) materials are well-characterized, but comparatively little has been published on the thermomechanical properties. In this paper, dynamic mechanical analysis (DMA) and differential scanning calorimetry data for bismuth telluride based TE materials is presented. The TE materials' tan delta values, indicative of viscoelastic energy dissipation modes, approached that of glassy or crystalline polymers, were greater than ten… more
Access: Restricted to UNT Community Members. Login required if off-campus.
Date: August 2002
Creator: White, John B.
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries
open access

Influence of design and coatings on the mechanical reliability of semiconductor wafers.

Description: We investigate some of the mechanical design factors of wafers and the effect on strength. Thin, solid, pre-stressed films are proposed as a means to improve the bulk mechanical properties of a wafer. Three-point bending was used to evaluate the laser scribe density and chemical processing effect on wafer strength. Drop and strike tests were employed to investigate the edge bevel profile effect on the mechanical properties of the wafer. To characterize the effect of thin films on stren… more
Date: August 2002
Creator: Yoder, Karl J.
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries

Mechanical Properties of Polymer Modified Mortar

Description: The mechanical properties of the polymer-modified mortar are markedly improved over conventional cement mortar. We utilized recycled ABS in powder form and a polymer latex emulsion, polymer percentage ranges from 0 to 25 percent by polymer/cement ratio were investigated. The mechanical properties investigated were compression strength and adhesion strength. Compression strength effects did not have an impact on adhesion strength. Adhesion strength was calculated with pullout testing apparatus … more
Access: Restricted to UNT Community Members. Login required if off-campus.
Date: August 2002
Creator: Palos, Artemio
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries
open access

Polyamide-imide and Montmorillonite Nanocomposites

Description: Solvent suspensions of a high performance polymer, Polyamide-imide (PAI) are widely used in magnetic wire coatings. Here we investigate the effect that the introduction of montmorillonite (MMT) has on PAI. MMT was introduced into an uncured PAI suspension; the sample was then cured by step-wise heat treatment. Polarized optical microscopy was used to choose the best suitable MMT for PAI matrix and to study the distribution of MMT in PAI matrix. Concentration dependent dispersion effect was stud… more
Date: August 2001
Creator: Ranade, Ajit
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries

Thermal, Electrical, and Structural Analysis of Graphite Foam

Description: A graphite foam was developed at Oak Ridge National Laboratory (ORNL) by Dr. James Klett and license was granted to POCO Graphite, Inc. to manufacture and market the product as PocoFoam™. Unlike many processes currently used to manufacture carbon foams, this process yields a highly graphitic structure and overcomes many limitations, such as oxidation stabilization, that are routinely encountered in the development of carbon foam materials. The structure, thermal properties, electrical resistiv… more
Access: Restricted to UNT Community Members. Login required if off-campus.
Date: August 2001
Creator: Morgan, Dwayne Russell
Item Type: Refine your search to only Thesis or Dissertation
Partner: UNT Libraries
Back to Top of Screen