Technical Report Archive and Image Library (TRAIL) - Browse

ABOUT BROWSE FEED

Bibliographies of Industrial Interest : Thermodynamic Measurements on the Systems CO₂-H₂O, CuCl₂-H₂0,H₂SO₄-H₂O, NH₃-H₂O, H₂S-H₂O, ZnCl₂-H₂Oand H₃PO₄-H₂O

Description: Abstract: Contained herein are bibliographies of Sources of experimental and correlated thermodynamic data for seven binary aqueous mixtures of industrial importance, namely mixtures of CO2, H2S, NH3, H2S0, H3P4, CuCl2 and ZnCl2 with water. The categories of equilibrium data included in the bibliographies are activity and osmotic coefficients, equilibria in solution, enthalpies and heat capacity data, vapor-liquid equilibria, and phase equilibrium data.
Date: September 1986
Creator: Staples, B. R.
Partner: UNT Libraries Government Documents Department

Bibliography and Index on Vacuum and Low Pressure Measurement

Description: From Introduction: "This paper consists essentially of a) a bibliography, b) an author index, and c) an index of the subject matter of the bibliography. While the primary objective is to focus on vacuum measurement, it was believed essential to include in the bibliography articles on vacuum technology in some measure accessory or essential to vacuum measurement. For maximum usefulness, an index of the subject matter of the references has been prepared. The abstract publications listed in the previous paragraph have been freely drawn upon in preparing the bibliography."
Date: November 10, 1961
Creator: Brombacher, W. G.
Partner: UNT Libraries Government Documents Department

Bibliography and Index on Vacuum and Low Pressure Measurement, January 1960 to December 1965

Description: From Abstract: "The bibliography, a supplement to NBS Monograph 35, of the same title, covers the years 1960 to 1965, inclusive, and include 109 references for prior years not listed in Monograph 35. It contains 1787 references, 38 of which are to books. The references, besides those directly concerned with pressure measurement, include those on vacuum technology which may bear on the technique of vacuum measurement, such as on adsorption and desorption, diffusion of gases into solids, gas conductance and hardware such as pumps, seals and traps."
Date: May 31, 1967
Creator: Brombacher, W. G.
Partner: UNT Libraries Government Documents Department

A Bibliography of Sources of Thermodynamic Data for the Systems: CO₂+NH₃+H₂O, CO₂+H₂S+H₂O, H₂S+NH₃+H₂O, and CO₂+NH₃+H₂S+H₂O

Description: Abstract: Contained herein is a bibliography of sources of experimental and correlated thermodynamic data for the systems: CO₂ + NH₃ + H₂O, CO₂ + H₂S + H₂O, H₂S + NH₃ + H₂O, and CO₂ + NH₃ + H₂S + H₂O. The types of data in this bibliography include all types of equilibrium data, including both eqilibria [sic] in solution and vapor-liquid equilibrium data, enthalpies, heat capacities, and densities. There are 215 references cited. Bibliographic Data Sheet.
Date: May 1985
Creator: Goldberg, Robert N. & Steckler, D. K.
Partner: UNT Libraries Government Documents Department

Bibliography of Temperature Measurement: January 1953 to June 1960

Description: Report presenting more than 500 references to the field of temperature measurement. These references were collected from two general sources: Scientific and technical literature and government reports. The period covered is from 1953 to June 1960, with some from earlier dates. References are divided into a number of categories based on the type of instrument used. Some references to calibration of instruments and to scientific theories upon which temperature measurement is based are also presented.
Date: April 6, 1961
Creator: Halpern, Carl & Moffat, Robert J.
Partner: UNT Libraries Government Documents Department

Bibliography of Temperature Measurement: July 1960 to December 1962

Description: Report presenting 700 additional references to the field of temperature measurement as a supplement to NBS Monograph 27, "Bibliography of Temperature Measurement, January 1953 to June 1960" issued April 6, 1961. These references were collected from two general sources: Scientific and technical literature and government reports. The period covered is from July 1960 to December 1962 with some earlier references which were found later. The arrangement of material is the same as in Monograph 27.
Date: September 13, 1936
Creator: Halpern, Carl
Partner: UNT Libraries Government Documents Department

Bibliography of Temperature Measurement: July 1960 to December 1965

Description: Report combining National Bureau of Standards Monograph 27 with the references given in Supplement 1 (May 13, 1963) and issued as a single publication to assist users of this material. References concern the field of temperature measurement. These references were collected from two general sources: Scientific and technical literature and government reports. References are divided into a number of categories based on the type of instrument used. Some references to calibration of instruments and to scientific theories upon which temperature measurement is based are also presented.
Date: April 28, 1967
Creator: Olsen, Lief O. & Halpern, Carl
Partner: UNT Libraries Government Documents Department

Bibliography on Atomic Transition Probabilities

Description: Report presenting a bibliography on atomic transition probabilities. The papers are arranged according to elements and stages of ionization, and the method employed and class of transitions are indicated behind each reference. Only articles on discrete transitions, both permitted and forbidden, are listed. Also included is a supplementary list of papers dealing with transition probabilities from a general point of view, a table showing the availability of numerical material on the individual atoms and ions, and a table of conversion factors.
Date: August 1, 1962
Creator: Glennon, B. M. & Wiese, W. L.
Partner: UNT Libraries Government Documents Department

Bibliography on Molecular and Crystal Structure Models

Description: Report that briefly describes many of the models of crystal and molecular structures which have appeared in the literature, and presents a bibliography of the publications, grouped according to model types, which describe the models in more detail.
Date: May 20, 1960
Creator: Smith, Deane K.
Partner: UNT Libraries Government Documents Department

BOLOVAC Systems for Measuring Electrical Quantities From 0.5 MHz Through Microwaves

Description: From Introduction: "This paper describes in some detail how Bolovac works, when its structural components are, what are the methods and steps of the procedure in its various major applications, and reasons for its advantages. The emphasis is on applications. Present status at the National Bureau of Standards relating to fabricating the most important component of the Bolovac-the bolometric disk-is briefly pointed out."
Date: January 1972
Creator: Selby, Myron C.
Partner: UNT Libraries Government Documents Department

Brief History of Measurement Systems: with a Chart of the Modernized Metric System

Description: Pamphlet issued by the United States National Bureau of Standards providing an overview of the English system of measurement used in the United States and of the metric system. The internal pages of the pamphlet contain a chart labeled "The Modernized Metric System" which includes tables of common conversions and a chart of the seven base units: meter/length, kilogram/mass, second/time, ampere/electric current, kelvin/temperature, mole/amount of substance, and candela/luminous intensity, as well as two supplementary units: radian/plane angle and steradian/solid angle. There is also a graphic representation of yards versus meters in ruler form at the bottom.
Date: August 1976
Creator: United States. National Bureau of Standards.
Partner: UNT Libraries Government Documents Department

The Calculation of Rotational Energy Levels and Rotational Line Intensities in Diatomic Molecules

Description: Report describing procedures for making quantum mechanical calculations of rotational energy levels and rotational line intensities in diatomic molecules. The procedures are illustrated by sample calculations. A familiarity with the material of this report should enable a practicing electronic spectroscropist to carry out, though in a rather mechanical way, his own theoretical calculations for molecules under experimental investigation.
Date: June 1970
Creator: Hougen, Jon T.
Partner: UNT Libraries Government Documents Department

Calibration of Line Standards of Length and Measuring Tapes at the National Bureau of Standards

Description: From Abstract: "The methods used at the National Bureau of Standards in calibrating line standards of length and measuring tapes submitted for standardization are outlined. The equipment used is described briefly. There is a discussion of some considerations that should be given as to whether or not a standard should be submitted to the Bureau."
Date: May 20, 1960
Creator: Judson, Lewis V.
Partner: UNT Libraries Government Documents Department

Calibration of Liquid-in-Glass Thermometers

Description: Report discussing important elements of thermometer design. Factors affecting the use of common types of liquid-in-glass thermometers are included together with tables of tolerances and reasonably attainable accuracies. The calculation of corrections for the temperature of the emergent stem is given in detail for various types of thermometers and conditions of use.
Date: February 12, 1965
Creator: Swindells, James F.
Partner: UNT Libraries Government Documents Department

Calibration Procedures for Direct-Current Resistance Apparatus

Description: From Object and Scope of This Paper: "This paper describes the apparatus and procedures used at the National Bureau of Standards for the measurement of d-c resistance when an accuracy of a few parts in a million is required. The object will be to explain procedures in detail and as simply as possible, with a minimum reference to theory."
Date: March 1, 1962
Creator: Brooks, Paul P. B.
Partner: UNT Libraries Government Documents Department

Catenary Chart 3

Description: Chart of catenary curve ordinates: "The curve gives approximate values of sag at all points on the catenary curve expressed in per cent of the center sag. The error is negligible for all spans in which the center sag is less than 10% of the span length." It is enlarged from figures in NBS discussion of national electrical safety code (handbook H39).
Date: August 7, 1944
Creator: United States. National Bureau of Standards.
Partner: UNT Libraries Government Documents Department

Causes of Variation in Chemical Analyses and Physical Tests of Portland Cement

Description: Report discussing variations in comparative tests of portland cements that could lead to the rejection of a material fully conforming to specification requirements, or the acceptance of a material with undesirable chemical or physical properties. Many of the causes for variation in chemical analyses and physical test results are listed in this discussion, and remedies for some of the more frequently encountered deficiencies in apparatus and methods are suggested.
Date: April 27, 1961
Creator: Bean, B. Leonard & Dise, John R.
Partner: UNT Libraries Government Documents Department