Technical Report Archive & Image Library (TRAIL) - 978 Matching Results

Search Results

Results: 1 - 24 next
open access

1706 KE Water Treatment for Out-of-Reactor Test Facilities.

Description: Water treatment systems for preparing and maintaining high purity water in out-of-reactor or in-reactor test oops are becoming increasingly important. In out0of-reactor experiments the presence of ionic impurities in the water has a marked influence on film formation and corrosion rates. It is therefore , imperative that these impurities be maintained at the lower practical concentration.
Date: March 30, 1959
Creator: Demmitt, Thomas F.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Acceleration of high-pressure-ratio single-spool turbojet engine as determined from component performance characteristics 1: effect of air bleed at compressor outlet

Description: From Summary: "An analytical investigation was made to determine from component performance characteristics the effect of air bleed at the compressor outlet on the acceleration characteristics of a typical high-pressure-ratio single-spool turbojet engine. Consideration of several operating lines on the compressor performance map with two turbine-inlet temperatures showed that for a minimum acceleration time the turbine-inlet temperature should be the maximum allowable, and the operating line on… more
Date: March 10, 1953
Creator: Rebeske, John J., Jr. & Rohlik, Harold E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

An active particle diffusion theory of flame quenching for laminar flames

Description: An equation for quenching distance based on the destruction of chain carriers by the surface is derived. The equation expresses the quenching distance in terms of the diffusion coefficients and partial pressures of the chain carriers and gas phase molecules, the efficiency of the surface as a chain breaker, the total pressure of the mixture, and a constant which depends on the geometry of the quenching surface. Quenching distances measured by flashback for propane-air flames are shown to be con… more
Date: March 4, 1952
Creator: Simon, Dorothy M. & Belles, Frank E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional Fatigue Tests on Effects of Design Details in 355-T6 Sand-Cast Aluminum Alloy

Description: From Introduction: "Reported herein are results of the additional direct-stress fatigue tests on: (1) a plate-type specimen with cored centrally located hole and (2) 0.300-inch-diameter round polished specimens with various degrees of porosity."
Date: March 10, 1954
Creator: Eaton, I. D. & Youra, John A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic and inlet-flow-field characteristics at a free-stream Mach number of 3.0 for airplanes with circular fuselage cross sections and for two engine locations

Description: Report presenting an experimental investigation of several airplane configurations at Mach 3.0 in a continuous flow tunnel. The configurations had circular fuselage cross sections and a sweptback wing and either two nacelles or two side inlets.
Date: March 18, 1958
Creator: Dryer, Murray & Luidens, Roger W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at transonic and supersonic speeds of a rocket-propelled airplane configuration having a 52.5 degree delta wing and a low, swept horizontal tail

Description: Report presenting a flight investigation over a range of Mach numbers to determine the aerodynamic characteristics at low lift of a rocket model of an airplane with a 52.5 degree delta wing of aspect ratio 3.08 and NACA 65A003 airfoil sections in the streamwise direction and a low, swept horizontal tail. Results regarding the longitudinal trim, lift, drag, longitudinal static stability, damping in pitch, and directional static stability are provided.
Date: March 29, 1954
Creator: Kehlet, Alan B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics including effects of wing fixes of a 1/20-scale model of the Convair F-102 airplane at transonic speeds

Description: From Introduction: "Results from the tests in the Langley 4- by 4-foot supersonic pressure tunnel at Mach numbers of 1.61 and 2.01 are presented in reference 1. Reported herein are results obtained from the tests in the Langley 8-foot transonic tunnel of the model with no control deflections at Mach numbers 0.6 to 1.12 for angles of attack up to 34^o
Date: March 18, 1954
Creator: Osborne, Robert S. & Wornom, Dewey E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics of a canard and an outboard-tail airplane model at a Mach number of 2.01

Description: From Introduction: "In order to obtain some insight into the relative merits of canard and outboard-tail control systems at supersonic speeds, a preliminary investigation of a generalized canard and outboard-tail model has been conducted in the Langley 4- by 4-foot supersonic pressure tunnel at a Mach number of 2.01 and the results are presented herein."
Date: March 24, 1958
Creator: Spearman, M. Leroy & Robinson, Ross B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of a Circular Cylinder at Mach Number 6.86 and Angles of Attack Up to 90 Degrees

Description: "Pressure-distribution and force tests of a circular cylinder have been made in the Langley 11-inch hypersonic tunnel at a Mach number of 6.86, a Reynolds number of 129,000 based on diameter, and angles of attack up to 90 degrees. The results are compared with the hypersonic approximation of Grimminger, Williams, and Young and with a simple modification of the Newtonian flow theory. The comparison of experimental results shows that either theory gives adequate general aerodynamic characteristic… more
Date: March 11, 1954
Creator: Penland, Jim A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics of a full-span trailing-edge control on a 60 degree delta wing with and without a spoiler at Mach number 1.61

Description: Report presenting an investigation at Mach number 1.61. to determine the aerodynamic characteristics of a full-span trailing-edge control on a 60 degree delta wing with and without a partial-span spoiler mounted on the wing just ahead of the control. Pressure distribution and hinge-moment measurements were made over a range of angles of attack and control deflection. Results indicated that regions of increase pressure due to flow separation ahead of the control at the larger control deflections… more
Date: March 10, 1954
Creator: Lord, Douglas R. & Czarnecki, K. R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics of a wing with unswept quarter-chord line, aspect ratio 2, taper ratio 0.78, and NACA 65A004 airfoil section: transonic-bump method

Description: From Introduction: "This paper presents the results of an investigation of force and moment characteristics for a wing with an unswept quarter-chord line, aspect ratio 2, taper ratio 0.78, and an NACA 65A004 airfoil section parallel to the free stream."
Date: March 8, 1950
Creator: Polhamus, Edward C. & Campbell, George S.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic loadings associated with swept and unswept spoilers on a flat-plate at Mach numbers of 1.61 and 2.01

Description: Report presenting an investigation at two Mach numbers to examine the flow, force, and moment characteristics associated with spoilers mounted on a flat plate at a range of sweep angles. Pressure measurements were obtained over the plate and spoiler faces. The pressures were integrated to determine the spoiler lift, pitching-moment, drag, and hinge-moment characteristics.
Date: March 12, 1956
Creator: Lord, Douglas R. & Czarnecki, K. R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamics of slender wings and wing-body combinations having swept trailing edges

Description: From Introduction: "In the present paper, a general method is developed for solving low-aspect-ratio problems involving shed vortex sheets. Both direct and inverse problems are considered. The method is applicable for all planar problems where the velocity boundary conditions can be made homogeneous by differentiation in either the streamwise or the spanwise directions."
Date: March 1954
Creator: Mirels, Harold
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Air-flow and thrust characteristics of several cylindrical cooling-air ejectors with a primary to secondary temperature ratio of 1.0

Description: Report presenting an investigation to determine the performance of 17 cooling-air ejectors at primary-jet pressure ratios from 1 to 10, secondary pressure ratios to 4.0, and a temperature ratio of unity. Results regarding pumping characteristics, effect of spacing ratio on pumping, effect of diameter ratio on pumping, thrust characteristics, effect of spacing ratio on thrust, effect of diameter ratio on thrust, comparison of cylindrical and conical ejectors, comparison of performance with small… more
Date: March 6, 1953
Creator: Greathouse, W. K. & Hollister, D. P.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

An air-flow-direction pickup suitable for telemetering use on pilotless aircraft

Description: From Summary: Test results are presented which indicate that the pickup is aerodynamically stable and has accuracy, obtained from a bench calibration, of better than 0.3^o under conditions including acceleration up to 20g in any direction, Mach numbers from 0.5 to 2.8, and dynamic pressures up to at least 65 psi. Equations and curves which can be used to obtain flow direction at the center of gravity of a maneuvering model are presented."
Date: March 10, 1954
Creator: Ikard, Wallace L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aircraft configurations developing high lift-drag ratios at high supersonic speeds

Description: From Introduction: "Range in more or less steady level flight depends directly on aerodynamic lift-drag ratio at high supersonic speeds, just as it does at lower speeds. This result follows from the classical Breguet range equation in the case of powered flight, and it may be easily deduced from the equations of motion for unpowered or gliding flight (see refs. 1 and 2)."
Date: March 5, 1956
Creator: Eggers, A. J., Jr. & Syvertson, Clarence A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aircraft Nuclear Propulsion Project Quarterly Progress Report: Period Ending December 10, 1951

Description: This quarterly progress report details the ongoing research and experiments at the Oak Ridge National Laboratory as part of the Aircraft Nuclear Propulsion Project. The first part of this report discusses reactor theory and design. The second part of this report is not included. The third part of this report discusses materials research. The fourth part of this report includes appendixes
Date: March 6, 1952
Creator: Briant, R. C. & Cottrell, W. B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aircraft Nuclear Propulsion Project Quarterly Progress Report for Period Ending December 10, 1955

Description: This quarterly progress report of the Aircraft Nuclear Propulsion Project at ORNL records the technical progress of the research on circulating-fuel reactors and other ANP research at the Laboratory under its Contract W-7405-eng-26. The report is divided into three major parts: I. Reactor Theory, Component Development, and Construction, II. Materials Research, and III. Shielding Research. The ANP Project is comprised of about 530 technical and scientific personnel engaged in many phases of rese… more
Date: March 12, 1956
Creator: Jordan, W. H.; Cremer, S. J.; Miller, A. J. & Savelainen, A. W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Altitude Acceleration Investigation of the RA-14 Avon Turbojet Engine

Description: As a part of this investigation, the acceleration characteristics of the engine, using the standard engine fuel-control system, were obtained for conditions simulating flight at altitudes of 35,000 and 50,000 feet with a flight Mach number of 0.4. Rapid and wave-off type accelerations were made at each flight condition, and the transient performance of the engine was recorded with a multiple-channel oscillograph. The parameters are presented graphically in the form of time histories, augmented … more
Date: March 13, 1956
Creator: Russey, Robert E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen