Search Results

open access

The Denis-Gruson Six-Component Wind-Tunnel Balance

Description: The 6.C.1 balance is the first fully automatic balance assuring a continuous and simultaneous record of the aerodynamic characteristics of an airfoil in a wind tunnel. Because of the rapidity of the measurements a complete polar (six components) requires only about three minutes of wind, that is to say, of motive power, which is of interest for wind tunnels with high efficiency factors and may lead to the economical design of large size wind tunnels.
Date: July 1935
Partner: UNT Libraries Government Documents Department
open access

The Effect of Depth of Step on the Water Performance of a Flying-Boat Hull Model N.A.C.A. Model 11-C

Description: "NACA model 11-C was tested with four different depths of step to obtain information as to the effect of the depth of step on the water performance. The depths of step were selected to cover the practicable range of depths and in each case the included angle between the forebody and afterbody keels was kept the same 6-1/2 degrees. Small depths of step were found to give lower resistance at speeds below and at the hump speed of the model and greater depths of step lower resistance at high speeds… more
Date: July 1935
Creator: Bell, Joe W.
Partner: UNT Libraries Government Documents Department
open access

Principal Effects of Axial Load on Moment-Distribution Analysis of Rigid Structures

Description: "This thesis presents the method of moment distribution modified to include the effect of axial load upon the bending moments. This modification makes it possible to analyze accurately complex structures, such as rigid fuselage trusses, that heretofore had to be analyzed by approximate formulas and empirical rules. The method is simple enough to be practicable even for complex structures, and it gives a means of analysis for continuous beams that is simpler than the extended three-moment equati… more
Date: July 1935
Creator: James, Benjamin Wylie
Partner: UNT Libraries Government Documents Department
open access

The Relative Hydrodynamic Resistance of Various Types of Rivet Heads from Tests of Planning Surfaces, Special Report

Description: The Committee was requested to investigate the effect of various types of rivet heads on hydrodynamic resistance. The proposal was made to obtain the resistance of the various types of rivets by tests of planing surfaces on which the full size rivets would be arranged. The testing methods, results and conclusions are given.
Date: July 1935
Creator: Truscott, Starr & Parkinson, John B.
Partner: UNT Libraries Government Documents Department
Back to Top of Screen