Technical Report Archive & Image Library (TRAIL) - 3 Matching Results

Search Results

Results: 1 - 3
open access

Cloud-droplet ingestion in engine inlets with inlet velocity ratios of 1.0 and 0.7

Description: From Summary: "The paths of cloud droplets into two engine inlets have been calculated for a wide range of meteorological and flight conditions. The amount of water in droplet form ingested by the inlets and the amount and distribution of water impinging on the inlet walls are obtained from these droplet-trajectory calculations. In both types of inlet, a prolate ellipsoid of revolution represents either part or all of the forebody at the center of an annular inlet to an engine. The configuratio… more
Date: November 2, 1955
Creator: Brun, Rinaldo J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Some Effects of Bluntness on Boundary-Layer Transition and Heat Transfer at Supersonic Speeds

Description: "Large downstream movements of transition observed when the leading edge of a hollow cylinder or a flat plate is slightly blunted are explained in terms of the reduction in Reynolds number at the outer edge of the boundary layer due to the detached shock wave. The magnitude of this reduction is computed for cones and wedges for Mach numbers to 20. Concurrent changes in outer-edge Mach number and temperature occur in the direction that would increase the stability of the laminar boundary layer. … more
Date: November 21, 1955
Creator: Moeckel, W. E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Charts for Estimating Performance of High-Performance Helicopters

Description: "Theoretically derived charts showing the profile-drag-thrust ratio are presented for helicopter rotors operating in forward flight and having hinged rectangular blades with a linear twist of 0 degree, 8 degrees, and 16 degrees. The charts, showing the profile-drag characteristics of the rotor for various combinations of pitch angle, ratio of thrust coefficient to solidity, and a parameter representing shaft power input, are presented for tip-speed ratios ranging from 0.05 to 0.50. Also present… more
Date: November 23, 1955
Creator: Gessow, Alfred & Tapscott, Robert J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen