Technical Report Archive and Image Library (TRAIL) - 11 Matching Results

Search Results

Drag and propulsive characteristics of air-cooled engine-nacelle installations for large airplane

Description: From Summary: "An investigation was conducted in the NACA full-scale wind tunnel to determine the drag and the propulsive efficiency of nacelle-propeller arrangements for a large range of nacelle sizes. In contrast with usual tests with a single nacelle, these tests were conducted with nacelle-propeller installations on a large model of a four-engine airplane. Data are presented on the first part of the investigation, covering seven nacelle arrangements with nacelle diameters from 0.53 to 1.5 times the wing thickness. These ratios are similar to those occurring on airplanes weighing from about 20 to 100 tons. The results show the drag, the propulsive efficiency, and the over-all efficiency of the various nacelle arrangements as functions of the nacelle size, the propeller position, and the airplane lift coefficient. The effect of the nacelles on the aerodynamic characteristics of the model is shown for both propeller-removed and propeller-operating conditions."
Date: 1942
Creator: Silverstein, Abe & Wilson, Herbert A., Jr.
Partner: UNT Libraries Government Documents Department

High-Speed Tests of a Model Twin-Engine Low-Wing Transport Airplane

Description: Report presents the results of force tests made of a 1/8-scale model of a twin-engine low-wing transport airplane in the NACA 8-foot high-speed tunnel to investigate compressibility and interference effects of speeds up to 450 miles per hour. In addition to tests of the standard arrangement of the model, tests were made with several modifications designed to reduce the drag and to increase the critical speed.
Date: 1942
Creator: Becker, John V. & Leonard, Lloyd H.
Partner: UNT Libraries Government Documents Department

Normal-pressure tests of rectangular plates

Description: Report presents the results of normal-pressure tests made of 56 rectangular plates with clamped edges and of 5 plates with freely supported edges. Pressure was applied and the center deflection and the permanent set at the center were measured. For some of the plates, in addition, strains and contours were measured.
Date: 1942
Creator: Ramberg, Walter; McPherson, Albert E. & Levy, Samuel
Partner: UNT Libraries Government Documents Department

Wind-tunnel investigation of an NACA 23012 airfoil with 30 percent-chord venetian-blind flaps

Description: Report presents the results of an investigation made in the NACA 7 by 10-foot wind tunnel of a NACA 23012 airfoil with 30-percent-chord venetian-blind flaps having one, two, three, and four slats of Clark y section. The three-slat arrangements was aerodynamically the best of those tested but showed practically no improvement over the comparable arrangement used in the preliminary tests published in NACA Technical Report No. 689. The multiple-slat flaps gave slightly higher lift coefficients than the one-slat (Fowler) flap but gave considerably greater pitching-moment coefficients. An analysis of test data indicates that substitution of a thicker and more cambered section for the Clark y slats should improve the aerodynamic and the structural characteristics of the venetian-blind flap.
Date: 1942
Creator: Rogallo, F. M. & Spano, Bartholomew S.
Partner: UNT Libraries Government Documents Department

Wind-tunnel tests of four- and six-blade single- and dual-rotating tractor propellers

Description: Test of 10-foot diameter, four and six blade single-rotating and dual-rotating propellers were conducted in the NACA propeller-research tunnel. The propellers were mounted at the front end of a streamline body incorporating spinners to house the hub portions. The effect of a symmetrical wing mounted in the slipstream ranged from 20 degrees to 65 degrees setting corresponds to airplane speeds greater than 500 miles per hour. The results indicate that dual-rotating propellers were from 0 to 6 percent more efficient than single-rotating ones; but, when the propellers operated in the presence of a wing, the gain was reduced by about one-half. Other advantages of dual-rotating propellers were found to include greater power absorption and greater efficiency at the low V/nD operating range of high-pitch propellers.
Date: 1942
Creator: Biermann, David & Hartman, Edwin P.
Partner: UNT Libraries Government Documents Department

The mean aerodynamic chord and the aerodynamic center of a tapered wing

Description: A preliminary study of pitching-moment data on tapered wings indicated that excellent agreement with test data was obtained by locating the quarter-chord point of the average chord on the average quarter-chord point of the semispan. The study was therefore extended to include most of the available data on tapered-wing models tested by the NACA.
Date: June 16, 1942
Creator: Diehl, Walter S.
Partner: UNT Libraries Government Documents Department

Analysis of heat and compressibility effects in internal flow systems and high-speed tests of a ram-jet system

Description: Report discussing an analysis has been made by the NACA of the effects of heat and compressibility in the flow through the internal systems of aircraft along with equations and charts are developed whereby the flow characteristics at key stations in a typical internal system may be readily obtained.
Date: July 21, 1942
Creator: Becker, John V. & Baals, Donald D.
Partner: UNT Libraries Government Documents Department

Exhaust-stack nozzle area and shape for individual cylinder exhaust-gas jet-propulsion system

Description: This report presents the results of an investigation conducted on the effect of exhaust-stack nozzle area, shape, and length on engine power, jet thrust, and gain in net thrust (engine propeller plus jet). Single-cylinder engine data were obtained using three straight stacks 25, 44, and 108 inches in length; an S-shaped stack, a 90 degree bend, a 180 degree bend, and a short straight stack having a closed branch faired into it. Each stack was fitted with nozzles varying in exit area from 0.91 square inch to the unrestricted area of the stack of 4.20 square inches. The engine was generally operated over a range of engine speeds from 1300 to 2100 r.p.m, inlet-manifold pressures from 22 to 30 inches of mercury absolute, and a fuel-air ratio of 0.08. The loss in engine power, the jet thrust, and the gain in net thrust are correlated in terms of several simple parameters. An example is given for determining the optimum nozzle area and the overall net thrust.
Date: August 11, 1942
Creator: Pinkel, Benjamin; Turner, L. Richard; Voss, Fred & Humble, Leroy V.
Partner: UNT Libraries Government Documents Department

Methods used in the NACA tank for the investigation of the longitudinal-stability characteristics of models of flying boats

Description: Report presents the results of tests of longitudinal stability characteristics of models of several flying boats conducted in the NACA Tank No. 1. These investigations were made for the purpose of (1) determining suitable methods for evaluating the stability characteristics of models of flying boats, and (2) determining the design parameters which have an important effect on the porpoising. This report is mainly concerned with the construction of suitable models, the apparatus, and methods used in the tests. The effect of changes in some design parameters is discussed.
Date: September 9, 1942
Creator: Olson, Roland E. & Land, Norman S.
Partner: UNT Libraries Government Documents Department

Identification of knock in NACA high-speed photographs of combustion in a spark-ignition engine

Description: Report presents the results of a study of combustion in a spark-ignition engine given in NACA Technical Reports 704 and 727. The present investigation was made with the NACA high-speed motion-picture camera, operating at 40,000 photographs a second, and with a cathode-ray oscillograph operating on a piezoelectric pick-up in the combustion chamber. Photographs are presented showing that the origin of knock is not necessarily in the end gas. The data obtained indicates that knock takes place only in a part of the cylinder charge which has been previously ignited either by autoignition or by the passage of the flame fronts but which has not burned to completion. Mottled regions in the high-speed Schlieren photographs are demonstrated to represent combustion regions.
Date: November 14, 1942
Creator: Miller, Cearcy D. & Olsen, H. Lowell
Partner: UNT Libraries Government Documents Department

Derivation of charts for determining the horizontal tail load variation with any elevator motion

Description: From Summary: "The equations relating the wing and tail loads are derived for a unit elevator displacement. These equations are then converted into a nondimensional form and charts are given by which the wing- and tail-load-increment variation may be determined under dynamic conditions for any type of elevator motion and for various degrees of airplane stability. In order to illustrate the use of the charts, several examples are included in which the wing and tail loads are evaluated for a number of types of elevator motion. Methods are given for determining the necessary derivatives from results of wind-tunnel tests when such tests are available."
Date: November 23, 1942
Creator: Pearson, Henry A.
Partner: UNT Libraries Government Documents Department