Technical Report Archive and Image Library (TRAIL) - 5 Matching Results

Search Results

Particle Accelerator Division Summary Report: April Through September 1960

Description: Report issued by the Argonne National Laboratory discussing a summary report of the Particle Accelerator Division. As stated in the summary, "this report outlines two methods applicable respectively to longhand and computer calculations" (p. 4). This report includes tables, illustrations, and photographs.
Date: 1960
Creator: Crewe, Albert V.; FitzPatrick, John P.; Foss, Martyn H. & Manson, David S.
Partner: UNT Libraries Government Documents Department

Irradiation of an Aluminum Alloy-Clad Ceramic Pellet-Fueled Plate

Description: From Introduction: "An experiment, designated MTR-W10, was designed to determine the effects of high burnup on the cladding and fuel of an aluminum-1% nickel alloy (M-388)-clad ceramic pellet-fuelded plate if the type manufactured at Argonne for the BORAX-IV core. Conditions of irradiation were selected to allow local boiling at the high flux end of the plate at a pressure of 600 psig."
Date: May 1960
Creator: Gavin, A. P.
Partner: UNT Libraries Government Documents Department

Cost Study of a 100-Mw(e) Direct-Cycle Boiling Water Reactor Plant

Description: Report issued by the Argonne national Laboratory discussing a technical and economic evaluation of a direct-cycle light-water boiling reactor designed for natural circulation and internal steam-water separation. The reference 100-Mw(e) reactor power plant design evolved from the study should have the best chance (compared to similar plants) of approaching the 8 to 9 mill/kwh total power-cost level. This report includes tables, and illustrations.
Date: July 1960
Creator: Bullinger, C. F. & Harrer, J. M.
Partner: UNT Libraries Government Documents Department

Irradiation of an Aluminum Alloy-Clad, Aluminum-Uranium Alloy-Fueled Plate

Description: Report issued by the Argonne National Laboratory discussing irradiation tests of an aluminum alloy-clad, aluminum-uranium alloy fuel plate. As stated in the introduction, "calculations were made to determine the lowest possible pressure which would allow the maximum possible local boiling on the plate and still assure a margin of safety against burnout" (p. 9). This report includes tables, illustrations, and photographs.
Date: July 1960
Creator: Gavin, A. P. & Crothers, C. C.
Partner: UNT Libraries Government Documents Department