Technical Report Archive and Image Library (TRAIL) - 36 Matching Results

Search Results

Particle Accelerator Division Summary Report: April Through September 1960

Description: Report issued by the Argonne National Laboratory discussing a summary report of the Particle Accelerator Division. As stated in the summary, "this report outlines two methods applicable respectively to longhand and computer calculations" (p. 4). This report includes tables, illustrations, and photographs.
Date: 1960
Creator: Crewe, Albert V.; FitzPatrick, John P.; Foss, Martyn H. & Manson, David S.
Partner: UNT Libraries Government Documents Department

Irradiation of an Aluminum Alloy-Clad Ceramic Pellet-Fueled Plate

Description: From Introduction: "An experiment, designated MTR-W10, was designed to determine the effects of high burnup on the cladding and fuel of an aluminum-1% nickel alloy (M-388)-clad ceramic pellet-fuelded plate if the type manufactured at Argonne for the BORAX-IV core. Conditions of irradiation were selected to allow local boiling at the high flux end of the plate at a pressure of 600 psig."
Date: May 1960
Creator: Gavin, A. P.
Partner: UNT Libraries Government Documents Department

Cost Study of a 100-Mw(e) Direct-Cycle Boiling Water Reactor Plant

Description: Report issued by the Argonne national Laboratory discussing a technical and economic evaluation of a direct-cycle light-water boiling reactor designed for natural circulation and internal steam-water separation. The reference 100-Mw(e) reactor power plant design evolved from the study should have the best chance (compared to similar plants) of approaching the 8 to 9 mill/kwh total power-cost level. This report includes tables, and illustrations.
Date: July 1960
Creator: Bullinger, C. F. & Harrer, J. M.
Partner: UNT Libraries Government Documents Department

Irradiation of an Aluminum Alloy-Clad, Aluminum-Uranium Alloy-Fueled Plate

Description: Report issued by the Argonne National Laboratory discussing irradiation tests of an aluminum alloy-clad, aluminum-uranium alloy fuel plate. As stated in the introduction, "calculations were made to determine the lowest possible pressure which would allow the maximum possible local boiling on the plate and still assure a margin of safety against burnout" (p. 9). This report includes tables, illustrations, and photographs.
Date: July 1960
Creator: Gavin, A. P. & Crothers, C. C.
Partner: UNT Libraries Government Documents Department

Idaho Division Summary Report

Description: Report issued by the Argonne National Laboratory discussing a summary of projects conducted with the Idaho Division. Descriptions of each project are presented. This report includes tables, and illustrations.
Date: 1961
Creator: Novick, Meyer & Thalgott, F. W.
Partner: UNT Libraries Government Documents Department

A Report on Some Attempts to Cast Centrifugally Fuel Elements of Small Diameter

Description: Report issued by the Argonne national Laboratory discussing centrifugal casting of thin uranium plates. The applicability of the centrifugal casting technique to the production of multiple castings of fuel pins of small diameter and of thin fuel plates was investigated. This report includes tables, illustrations, and photographs.
Date: March 1961
Creator: Yaggee, F. L.
Partner: UNT Libraries Government Documents Department

An Ultrasonic Measurement System for The Precise Determination of the Elastic Moduli of Single Crystals

Description: From Abstract: "The equipment described in this paper is based on the technique developed by McSkimin. Figure 1 shows a block diagram of the system. The oscilloscope presentation with no specimen present appears as shown in Figure 2a. At discrete frequencies, the pattern appears as shown in Figure 2b."
Date: May 1961
Creator: Renken, C. J.
Partner: UNT Libraries Government Documents Department

Proceedings of the AMU-ANL Summer Study Program

Description: From Introduction: "In 1954, the AEC presented the "five-year plan" for power reactor development, briefly outlined in Table I-1. The program proceeded and other reactors were added as a result of the incentives indicated in the outline."
Date: November 1962
Creator: Pearson, C. V.
Partner: UNT Libraries Government Documents Department

Interim Report: Faret Experimental Program

Description: From Introduction: "The Fast Reactor Test (FARET) program is part of the United States Fast Reactor Program directed toward the demonstration of breeder reactors essential to the long-range goal of utilizing fertile fuels. (1) With-in this program is the current thinking that the early construction and operation of two or three prototype nuclear power plants of the order of 250 Mw(e) will lead eventually to the construction of practical and economic full scale breeder reactors by the early 1980's. (2)"
Date: April 1963
Creator: Smaardyk, A.; Bump, T. R.; Handwerk, J. & Handwerk, J.
Partner: UNT Libraries Government Documents Department

Reactor Development Program Progress Report: March 1963

Description: Report issued by the Argonne National Laboratory discussing progress made by the Reactor Development Program during March 1963. Reactor physics, experiments, and safety studies are presented. This report includes tables, and illustrations.
Date: April 15, 1963
Creator: Adams, R. M. & Glassner, A.
Partner: UNT Libraries Government Documents Department

Transient Behavior of a Natural-Circulation Loop Operating Near The Thermodynamic Critical Point

Description: From Introduction: "Interest in utilizing natural-circulation loops to obtain results that aid in the design of some boiler and nuclear reactor coolant systems has focused attention on the dynamic behavior of such loops. Much analytical and experimental work has been done so as to permit predictions of the transient behavior of both single-phase and two-phase neutral-circulation systems. The analytical portion of the study consisted of simulating the loop by utilizing a digital computer to predict the measured transients."
Date: May 1963
Creator: Harden, Darrel G.
Partner: UNT Libraries Government Documents Department

Reactor Development Program Progress Report: April 1963

Description: Report issued by the Argonne National Laboratory discussing progress made by the Reactor Development Program during April 1963. Reactor physics, experiments, and safety studies are presented. This report includes tables, and illustrations.
Date: May 15, 1963
Creator: Adams, R. M. & Glassner, A.
Partner: UNT Libraries Government Documents Department

Heat Transfer, Flow Instability, and Critical Heat Flux For Water in a Small Tube At 200 psia

Description: From Abstract: Report discussing "the effects of developing two-phase flow regimes in a constant-pressure drop system are shown in recorded traces from a fast-response flow transducer: the mass velocity decreases and transfer-surface superheat increases with increasing steam quality."
Date: June 1963
Creator: Weatherhead, R. J.
Partner: UNT Libraries Government Documents Department

Two-Phase Heat Transfer With Gas Injection Through A Porous Boundary Surface

Description: From Introduction: "The purpose of this study is to investigate some of the hydrodyamic aspects of two-phase heat transfer in the lower quality range. The results of this study should contribute to a better and more thorough understanding of the processes and mechanisms affecting two-phase heat transfer, and in this way help in improving its prediction."
Date: March 1964
Creator: Kudirka, A. A.
Partner: UNT Libraries Government Documents Department

Performance Characteristics of a Liquid Metal MHD Generator

Description: Report issued by the Argonne National Laboratory discussing the performance of magnetohydrodynamic generators. As stated in the abstract, "an experimental study was made of the performance characteristics of a liquid metal MHD generator utilizing single-phase sodium-potassium and two-phase sodium-potassium-nitrogen fluids. The purpose of this study was to compare the generator performance with theory for single-phase flow and to determine the effects of the introduction of the gaseous phase on the generator output and efficiency" (p. 9). This report includes tables, illustrations, and photographs.
Date: July 1964
Creator: Petrick, Michael & Lee, Kung-You
Partner: UNT Libraries Government Documents Department

Condensation of Metal Vapors: Mercury and the Kinetic Theory of Condensation

Description: Report issued by the Argonne National Laboratory discussing condensation theories of metal vapors. As stated in the introduction, "the objectives of this research then are critical analysis of condensation theories and data for metal vapors and experimental evaluation of the resistance to condensation for a representative metal such as mercury" (p. 18). This report includes tables, illustrations, and photographs.
Date: October 1964
Creator: Wilhelm, Donald J.
Partner: UNT Libraries Government Documents Department

Liquid MHD Power Cycle Studies

Description: Report issued by the Argonne National Laboratory discussing the magnetohydrodynamics (MHD) power cycle for liquid metals. The benefits, and different phases of the MHD power cycle are presented. This report includes tables, and illustrations.
Date: June 1965
Creator: Petrick, Michael & Lee, Kung-You
Partner: UNT Libraries Government Documents Department

Pictorial Studies of Molecules 1: Molecular Orbital Density Comparisons of H2, Li2, B2, C2, N2, O2, and F2

Description: From Review of Theory: " In practice, a very close approximation to the molecular orbitals can be obtained in this way. Recent calculations of this type, utilizing analysis and computer programs developed by the author, have resulted in the determination of the molecular orbitals for a large number of diatomic molecules in the form of Eq. (2). These functions, which are thought to be very close to the Hartree-Fock (i.e., the molecular orbitals demanded by theory) result, were used in the pictorial calculations presented in this report."
Date: July 1965
Creator: Wahl, Arnold C.
Partner: UNT Libraries Government Documents Department