National Advisory Committee for Aeronautics (NACA) - 13,806 Matching Results

Search Results

Primary view of Activation of hydrocarbons and the octane number
Peschard, Marcel
October 1939
Primary view of An active particle diffusion theory of flame quenching for laminar flames / Dorothy M. Simon and Frank E. Belles
Simon, Dorothy M & Belles, Frank E
March 4, 1952
Primary view of Adaptation of a Cascade Impactor to Flight Measurement of Droplet Size in Clouds
Levine, Joseph & Kleinknecht, Kenneth S.
September 18, 1951
Primary view of Adaptation of aeronautical engines to high altitude flying
Kutzbach, K
May 1923
Primary view of Adaptation of Combustion Principles to Aircraft Propulsion, Volume 2, Combustion in Air-Breathing Jet Engines
unknown creator
May 2, 1956
Primary view of Adaptation of Combustion Principles to Aircraft Propulsion, Volume I, Basic Considerations in the Combustion of Hydrocarbon Fuels with Air
Barnett, Henry C. & Hibbard, Robert R.
April 1, 1955
Primary view of Adaptor for measuring principal strains with Tuckerman strain gage
Mcpherson, A E
June 1943
Primary view of Addition of heat to a compressible fluid in motion
Hicks, Bruce L
February 1945
Primary view of Additional abstracts pertaining to seaplanes
Bidwell, J. M. & King, D. A.
March 9, 1948
Primary view of Additional comparisons between computed and measured transonic drag-rise coefficients at zero lift for wing-body-tail configurations
Holdaway, George H
August 15, 1955
Primary view of Additional design charts relating to the stalling of tapered wings
Harmon, Sidney M
January 1943
Primary view of Additional experimental heat-transfer and durability data on several forced-convection, air-cooled, strut-supported turbine blades of improved design
Schum, Eugene F
January 19, 1955
Primary view of Additional experiments with flat-top wing- body combinations at high supersonic speeds
Gloria, H. R.; Syvertson, C. A. & Wong, T. J.
February 19, 1957
Primary view of Additional fatigue tests on effects of design details in 355-T6 sand-cast aluminum alloy
Eaton, I D & Youra, John A
March 10, 1954
Primary view of Additional free-flight tests of the rolling effectiveness of several wing-spoiler arrangements at high subsonic, transonic, and supersonic speeds
Strass, H Kurt
November 24, 1948
Primary view of An additional investigation of the high-speed lateral-control characteristics of spoilers
Summers, James
June 1945
Primary view of The additional-mass effect of plates as determined by experiments
Gracey, William
1941
Primary view of Additional measurements of the low-speed static stability of a configuration employing three triangular wing panels and a body of equal length
Delany, Noel K
July 25, 1955
Primary view of Additional power-on wind-tunnel tests of the 1/8-scale model of the Brewster F2A airplane with full-span slotted flaps
Lowry, John G
October 1941
Primary view of Additional results in a free-flight investigation of control effectiveness of full-span, 0.2-chord plain ailerons at high subsonic, transonic, and supersonic speeds to determine some effects of wing sweepback, aspect ratio, taper, and section thickne
Sandahl, Carl A & Strass, H Kurt
April 23, 1948
Primary view of Additional results of an investigation at transonic speeds to determine the effects of a heated propulsive jet on the drag characteristics of a series of related afterbodies
Henry, Beverly Z JR & Cahn, Maurice S
September 24, 1956
Primary view of Additional Results on the Static Longitudinal and Lateral Stability Characteristics of a 0.05-Scale Model of the Convair F2Y-1 Airplane at High Subsonic Speeds
Spreeman, Kenneth P. & Few, Albert G.
August 10, 1954
Primary view of Additional static and fatigue tests of high-strength aluminum-alloy bolted joints
Hartmann, E C; Holt, Marshall & Eaton, I D
July 1954
Primary view of Additional Studies of the Stability and Controllability of an Unswept-Wing Vertically Rising Airplane Model in Hovering Flight Including Studies of Various Tethered Landing Techniques
Bates, William R.; Lovell, Powell M., Jr. & Smith, Charles C., Jr.
November 6, 1951