National Advisory Committee for Aeronautics (NACA) - 6,928 Matching Results

Search Results

prev Results: 25 - 48 next
open access

Adaptation of a Cascade Impactor to Flight Measurement of Droplet Size in Clouds

Description: "A cascade impactor, an instrument for obtaining the size distribution of droplets borne in a low-velocity air stream, was adapted for flight cloud droplet-size studies. The air containing the droplets was slowed down from flight speed by a diffuser to the inlet-air velocity of the impactor" (p. 1).
Date: September 18, 1951
Creator: Levine, Joseph & Kleinknecht, Kenneth S.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Adaptation of Combustion Principles to Aircraft Propulsion, Volume 1, Basic Considerations in the Combustion of Hydrocarbon Fuels with Air

Description: The report summarizes source material on combustion for flight-propulsion engineers. First, several chapters review fundamental processes such as fuel-air mixture preparation, gas flow and mixing, flammability and ignition, flame propagation in both homogenous and heterogenous media, flame stabilization, combustion oscillations, and smoke and carbon formation. The practical significance and the relation of these processes to theory are presented. A second series of chapters describes the observ… more
Date: April 1, 1955
Creator: Barnett, Henry C. & Hibbard, Robert R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Adaptation of Combustion Principles to Aircraft Propulsion Volume 2: Combustion in Air-Breathing Jet Engines

Description: This volume continues the NACA study of combustion principles for aircraft propulsion. The various aspects of combustion pertinent to jet engines are organized and interpreted with quite extensive information, particularly for basic or fundamental. subject matter. The report concerns only air-breathing engines and hydrocarbon fuels, and not rocket engines and high-energy fuels.
Date: May 2, 1956
Creator: Fuels and Combustion Research Division
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional comparisons between computed and measured transonic drag-rise coefficients at zero lift for wing-body-tail configurations

Description: From Introduction: "This report makes further comparisons of the theoretical computing method with available experimental results, showing effects of wing plan-form changes, and the effect of an airfoil-section change on a wing of given plan form."
Date: August 15, 1955
Creator: Holdaway, George H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional experimental heat-transfer and durability data on several forced-convection, air-cooled, strut-supported turbine blades of improved design

Description: Report presenting an investigation at the Lewis laboratory to develop air-cooled, strut-supported turbine blades. Six blades were investigated in a full-scale turbojet engine to obtain data on blade durability and blade-cooling effectiveness and strut temperature. Results regarding the heat-transfer investigation and blade-durability investigation are provided.
Date: January 19, 1955
Creator: Schum, Eugene F.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional Experiments With Flat-Top Wing- Body Combinations at High Supersonic Speeds

Description: Memorandum presenting an experimental study of the effects of several variations in configuration geometry on the aerodynamic characteristics of flat-top wing-body combinations. Generally, the configurations consist of one half of a body of revolution mounted beneath a wing of essentially arrow plan form. Results regarding the effect of trailing-edge sweep, effect of the addition of auxiliary bodies, effect of tip-flap deflection, effect of dihedral, effect of leading-edge sweep, effect of fuse… more
Date: February 19, 1957
Creator: Syvertson, Clarence A.; Wong, Thomas J. & Gloria, Hermilo R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional Fatigue Tests on Effects of Design Details in 355-T6 Sand-Cast Aluminum Alloy

Description: From Introduction: "Reported herein are results of the additional direct-stress fatigue tests on: (1) a plate-type specimen with cored centrally located hole and (2) 0.300-inch-diameter round polished specimens with various degrees of porosity."
Date: March 10, 1954
Creator: Eaton, I. D. & Youra, John A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional measurements of the low-speed static stability of a configuration employing three triangular wing panels and a body of equal length

Description: From Introduction: "The results of an investigation of the low-speed static stability of a simplified model of such an arrangement having one of the airfoils placed vertically on top of the body and the other two as wing panels having negative dihedral are presented in reference 1. In order to provide information for predicting the effects of changes in the basic configuration on the low-speed stability characteristics presented in reference 1, additional measurements have been made."
Date: July 25, 1955
Creator: Delany, Noel K.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional results of an investigation at transonic speeds to determine the effects of a heated propulsive jet on the drag characteristics of a series of related afterbodies

Description: From Introduction: "Presented in this report are the basic data obtained from investigation. The data are presented with limited analysis in order to expedite their availability to those concerned with jet-exit-afterbody design."
Date: September 24, 1956
Creator: Henry, Beverly Z., Jr. & Cahn, Maurice S.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional Results on the Static Longitudinal and Lateral Stability Characteristics of a 0.05-Scale Model of the Convair F2Y-1 Airplane at High Subsonic Speeds

Description: "Additional results on the static longitudinal and lateral stability characteristics of a 0.05-scale model of the Convair F2Y-1 water-based fighter airplane were obtained in the Langley high-speed 7- by 10-foot tunnel over a Mach number range of 0.50 to 0.92. The maximum angle-of-attack range (obtained at the lower Mach numbers) was from -2 degrees to 25 degrees. The sideslip-angle range investigated was from -4 degrees to 12 degrees" (p. 1).
Date: August 10, 1954
Creator: Spreeman, Kenneth P. & Few, Albert G., Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional Static and Fatigue Tests of High-Strength Aluminum-Alloy Bolted Joints

Description: From Introduction: "Early in 1951 the National Advisory Committee for Aeronautics published, as Technical Note 2276 (ref. 1), a report by the Aluminum Research Laboratories of the Aluminum Company of America on the results of static and fatigue tests of high-strength aluminum alloy monobloc specimens and bolted joints. In view of special interest shown by several aircraft companies, certain expansions of the test program were undertaken by the Aluminum Research Laboratories and are reported her… more
Date: July 1954
Creator: Hartmann, E. C.; Holt, Marshall & Eaton, I. D.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional Studies of the Stability and Controllability of an Unswept-Wing Vertically Rising Airplane Model in Hovering Flight Including Studies of Various Tethered Landing Techniques

Description: Report discussing the results of an investigation to determine the stability and control characteristics of a flying model of an unswept-wing vertically rising airplane. Information about stabilization, maneuverability, rolling motions, and landings is provided.
Date: November 6, 1951
Creator: Bates, William R.; Lovell, Powell M., Jr. & Smith, Charles C., Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Adhesive and protective characteristics of ceramic coating A-417 and its effect on engine life of forged Refractaloy-26 (AMS 5760) and cast stellite 21 (AMS 5385) turbine blades

Description: The adhesive and protective characteristics of National Bureau of Standards Coating A-417 were investigated, as well as the effect of the coating on the life of forged Refractaloy 26 and cast Stellite 21 turbine blades. Coated and uncoated blades were run in a full-scale J33-9 engine and were subjected to simulated service operations consisting of consecutive 20-minute cycles (15 min at rated speed and approximately 5 min at idle). The ceramic coating adhered well to Refractaloy 26 and Stellite… more
Date: February 12, 1953
Creator: Garrett, Floyd B. & Gyorgak, Charles A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic and hydrodynamic characteristics of a deck-inlet multijet water-based-aircraft configuration designed for supersonic flight

Description: From Introduction: "In the present investigation, lift, drag, and pitching moment were determined over a Mach number range 0.6 to 1.42. Smooth-water takeoff and landing stability and resistance were investigated. A brief check of the rough-water spray and behavior was also made."
Date: December 5, 1956
Creator: Bielat, Ralph P.; Coffee, Claude W., Jr. & Petynia, William W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic and hydrodynamic characteristics of a proposed supersonic multijet water-based hydro-ski aircraft with a variable-incidence wing

Description: From Introduction: "The configuration described in this paper represents one approach to such an airplane and the results of the wind-tunnel and tank evaluations are presented. In the present investigation, the aerodynamic longitudinal characteristics over a Mach number range from 0.6 to 1.97 were obtained."
Date: October 23, 1957
Creator: Petynia, William W.; Hasson, Dennis F. & Spooner, Stanley H.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic and hydrodynamic characteristics of models of some aircraft-towed mine-sweeping devices : TED No. NACA AR 8201

Description: This report details a study that was conducted by the U.S. Naval Air Development Center to "determine the feasibility of several airborne magnetic mine-sweeping methods. The advantages of a satisfactory airborne method are greater safety and speed than are possible with existing surface methods." The configurations and results of the double Q-sweep, the modified double-catenary sweep, and the M-sweep are examined.
Date: December 1, 1955
Creator: Shanks, Robert E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic and inlet-flow-field characteristics at a free-stream Mach number of 3.0 for airplanes with circular fuselage cross sections and for two engine locations

Description: Report presenting an experimental investigation of several airplane configurations at Mach 3.0 in a continuous flow tunnel. The configurations had circular fuselage cross sections and a sweptback wing and either two nacelles or two side inlets.
Date: March 18, 1958
Creator: Dryer, Murray & Luidens, Roger W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic and Lateral-Control Characteristics of a 1/28-Scale Model of the Bell X-1 Airplane Wing-Fuselage Combination: Transonic-Bump Method

Description: Report discussing an investigation into the lateral-control characteristics and the pitching-moment characteristics of a scale model of the X-1 wing-fuselage configuration. Information about the estimated variation of rolling effectiveness and wing-fuselage pitching-moment coefficient is described in detail.
Date: May 5, 1950
Creator: Lockwood, Vernard E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics and flying qualities of a tailless triangular-wing airplane configuration as obtained from flights of rocket-propelled models at transonic and supersonic speeds

Description: Report discussing a flight investigation of rocket-powered models of a tailless triangular-wing airplane configuration was made through the transonic and low supersonic speed range at the Langley Pilotless Aircraft Research Station at Wallops Island, Va. An analysis of the aerodynamic coefficients, stability derivatives, and flying qualities based on the results obtained from the successful flight tests of three models is presented.
Date: November 1956
Creator: Mitcham, Grady L.; Stevens, Joseph E. & Norris, Harry P.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics and pressure distributions of a 6-percent-thick 49 degree sweptback wing with blowing over half-span and full-span flaps

Description: From Introduction: "The investigation reported herein was initiated to define further the effects on the aerodynamic characteristics and load distribution of a thin, sweptback wing of a low-pressure blowing system and also to provide information on which to base a more thorough study of a complete airplane configuration."
Date: September 20, 1955
Creator: Whittle, Edward F., Jr. & McLemore, H. Clyde
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics at a Mach Number of 1.25 of a 6-Percent-Thick Triangular Wing and 6- and 9-Percent-Thick Triangular Wings in Combination With a Fuselage: Wing Aspect Ratio 2.31, Biconvex Airfoil Sections

Description: Report discussing testing to determine the aerodynamic characteristics of two semispan delta-wing configurations. Information about the lift characteristics, drag characteristics, pitching-moment characteristics, and comparison with other results is provided.
Date: May 5, 1950
Creator: Hall, Albert W. & Morris, Garland J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics at a Mach Number of 1.38 of Four Wings of Aspect Ratio 4 Having Quarter-Chord Sweep Angles of 0 Degrees, 35 Degrees, 45 Degrees, and 60 Degrees

Description: Report discussing testing to determine the supersonic aerodynamic characteristics of four sweptback wings and wing-body configurations at several angles. Information about basic wing data, modifications to the 60 degree wing, the effects of sweep, and effects of fuselage are included.
Date: October 10, 1950
Creator: Kemp, William B., Jr.; Goodson, Kenneth W. & Booth, Robert A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen