National Advisory Committee for Aeronautics (NACA) - 4,115 Matching Results

Search Results

Aerodynamic and hydrodynamic tests of a family of models of flying hulls derived from a streamline body -- NACA model 84 series

Description: Report discussing a series of related forms of flying-boat hulls representing various degrees of compromise between aerodynamic and hydrodynamic requirements was tested in Langley Tank No. 1 and in the Langley 8-foot high-speed tunnel. The purpose of the investigation was to provide information regarding the penalties in water performance resulting from further aerodynamic refinement and, as a corollary, to provide information regarding the penalties in range or payload resulting from the retention of certain desirable hydrodynamic characteristics. The information should form a basis for over-all improvements in hull form.
Date: 1943?
Creator: Parkinson, John B; Olson, Roland E; Draley, Eugene C & Luoma, Arvo A
Partner: UNT Libraries Government Documents Department

Aerodynamic characteristics and flap loads of the brake-flap installation on the 0.40-scale model of the F4F-3 left wing panel

Description: From Introduction: "The data are presented in coefficient form and include lift, drag, and pitching-moment coefficients of the airfoil-flap comoinations and the normal-force, chord-force, and hinge-moment coefficients of the upper (perforated split) flap and lower (slotted) flap."
Date: October 1942
Creator: Liddell, Robert B
Partner: UNT Libraries Government Documents Department

Aerodynamic characteristics at high speeds of a two-blade NACA 10-(3)(062)-045 propeller and of a two-blade NACA 10-(3)(08)-045 propeller

Description: From Introduction: "The aerodynamic characteristics of a series of 10-foot-diameter propellers are being investigated in the Langley 16-foot high-speed tunnel in a comprehensive propeller research program. Using high-critical-speed NACA 16-series airfoil sections (reference 1), these propellers are designed to have Betz minimum induced-energy loss loading (reference 2) for a blade angle of 45^o at the 0.7 radius, when used as a four-blade propeller operating at an advance ratio of approximately 2.1 The ultimate purpose of the program is to determine the influence upon propeller design factors and of compressiblity; the propeller tests reported herein form part of the investigation of the effects of blade-section thickness ratio."
Date: October 1, 1948
Creator: Solomon, William
Partner: UNT Libraries Government Documents Department

Aerodynamic characteristics at high speeds of full-scale propellers having Clark Y blade sections

Description: From Introduction: "The single purpose of this paper is to make available the data obtained from tests of these two Clark Y section propellers as quickly as possible with no attempt being made to analyze the results or to compare them with other high-speed-propeller test results."
Date: October 26, 1948
Creator: Johnson, Peter J
Partner: UNT Libraries Government Documents Department

Aerodynamic Characteristics at High Speeds of Full-Scale Propellers having Different Shank Designs

Description: Tests of two 10-foot-diameter two-blade propellers which differed only in shank design have been made in the Langley 16-foot high-speed tunnel. The propellers are designated by their blade design numbers, NACA 10-(5)(08)-03, which had aerodynamically efficient airfoil shank sections, and NACA l0-(5)(08)-03R which had thick cylindrical shank sections typical of conventiona1 blades, The propellers mere tested on a 2000-horsepower dynamometer through a range of blade-angles from 20deg to 55deg at various rotational speeds and at airspeeds up to 496 miles per hour. The resultant tip speeds obtained simulate actual flight conditions, and the variation of air-stream Mach number with advance ratio is within the range of full-scale constant-speed propeller operation. Both propellers were very efficient, the maximum envelope efficiency being approximately 0,95 for the NACA 10-(5)(08)-03 propeller and about 5 percent less for the NACA 10-(5)(08)-03R propeller. Based on constant power and rotational speed, the efficiency of the NACA 10-(05)(08)-03 propeller was from 2.8 to 12 percent higher than that of the NACA 10-(5)(08)-03R propeller over a range of airspeeds from 225 to 450 miles per hour. The loss in maximum efficiency at the design blade angle for the NACA 10-(5)(08)-03 and 10-(5)(08)-03R propellers vas about 22 and 25 percent, respectively, for an increase in helical tip Mach number from 0.70 to 1.14.
Date: February 13, 1947
Creator: Maynard, Julian D.
Partner: UNT Libraries Government Documents Department

Aerodynamic characteristics at subcritical and supercritical Mach numbers of two airfoil sections having sharp leading edges and extreme rearward positions of maximum thickness

Description: From Introduction: "A 12-percent-chord-thick wedge section and a reversed NACA 0012 section were chosen for these tests as they are representative of sections having no boat tailing and appreciable boat tailing (i.e., blunt and rounded trailing edges, respectively), and the results of this investigation are compared with those obtained from a previous investigation of the NACA 0012 section. Conclusions are drawn regarding the relative merits of the two unconventional sections and the conventional section in transonic speed range."
Date: November 6, 1947
Creator: Eggers, A J , Jr
Partner: UNT Libraries Government Documents Department

Aerodynamic characteristics at subsonic and supersonic Mach numbers of a thin triangular wing of aspect ratio 2 I : maximum thickness at 20 percent of the chord

Description: From Summary: "This report presents the results of a wind-tunnel investigation conducted to determine the effects of Mach number on the aerodynamic characteristics of a wing of triangular plan form."
Date: November 19, 1948
Creator: Berggren, Robert E & Summers, James L
Partner: UNT Libraries Government Documents Department

Aerodynamic characteristics at subsonic and supersonic Mach numbers of a thin triangular wing of aspect ratio 2 II : maximum thickness at midchord

Description: The lift, drag, and pitching-moment characteristics of a triangular wing, having an aspect ratio of 2 and a symmetrical double-wedge profile of 5-percent-chord maximum thickness at midchord, have been evaluated from wind-tunnel tests at Mach numbers from 0.50 to 0.975 and from 1.09 to 1.49 and at Reynolds numbers ranging from 0.67 to 0.85 million. The lift, drag, and pitching-moment coefficients of the triangular wing with a leading-edge sweepback of approximately 63 degrees did not exhibit the irregular variations with Mach number at high subsonic and low supersonic Mach numbers that are characteristic of unswept wings. The lift-curve slope increased steadily with Mach number below unity and declined slowly beyond the Mach number of 1.13. A substantial rise in the minimum drag coefficient occurred between Mach numbers of 0.95 and 1.20 with an associated reduction in the maximum lift-drag ratio. The aerodynamic center shifted rearward toward the centroid of area of the wing with increasing Mach number below 0.975; whereas above 1.09 it coincided with the centroid.
Date: December 3, 1948
Creator: Walker, Harold J & Berggren, Robert E
Partner: UNT Libraries Government Documents Department

Aerodynamic Characteristics of a 0.5-Scale Model of the Fairchild XSAM-N-2 Lark Missile at High Subsonic Speeds

Description: An investigation was conducted to determine the longitudinal- and lateral-stability characteristics of a 0.5-scale moue1 of the Fairchild Lark missile, The model was tested with 0 deg and with 22.5 deg of roll. Three horizontal wings having NACA 16-009, 16-209, and 64A-209 sections were tested. Pressures were measured on both pointed and blunt noses. The wind-tunnel-test data indicate that rolling the missile 22.5 deg. had no serious effect on the static longitudinal stability. The desired maneuvering acceleration could not be attained with any of the horizontal wings tested, even with the horizontal wing flaps deflected 50 deg. The flaps on the 64A-209 wing (with small trailing-edge angles and flat sides) were effective at all flap deflections, while the flaps on the 16-series wings (with large trailing-edge angles) lost effectiveness at small flap deflections. The data showed that rolling moment existed when the vertical wing flaps were deflected with the model at other than zero angle of attack. A similar rolling moment probably would be found . with the horizontal wing flaps deflected and the model yawed.
Date: September 28, 1949
Creator: Martin, Andrew & Hunter, Harlo A.
Partner: UNT Libraries Government Documents Department

Aerodynamic characteristics of a 6-percent-thick symmetrical double-wedge airfoil at transonic speeds from tests by the NACA wing-flow method

Description: From Introduction: "The investigation covered a range of Mach numbers from 0.66 to 1.12 and included measurements of angle of attack, pitching moment, normal force, and chord force. The drag at zero lift obtained in this investigation was reported in reference 1, but without the correction for tare of the end plate."
Date: March 4, 1949
Creator: Lina, Lindsay J
Partner: UNT Libraries Government Documents Department

Aerodynamic characteristics of a 42 degree swept-back wing with aspect ratio 4 and NACA 64(sub 1)-112 airfoil sections at Reynolds numbers from 1,700,000 to 9,500,000

Description: Report discussing testing on a 42 degree swept-back wing to determine its low-speed aerodynamic characteristics in pitch and yaw at high Reynolds numbers. The main effect of increasing the Reynolds number was delayed wing stalling to higher angles of attack. Roughness on the wing leading edge also had a large adverse effect on lift, drag, and pitching-moment characteristics at higher Reynolds numbers.
Date: May 23, 1947
Creator: Neely, Robert H. & Conner, D. William
Partner: UNT Libraries Government Documents Department

Aerodynamic characteristics of a 45 degree swept-back wing with aspect ratio of 3.5 and NACA 2S-50(05)-50(05) airfoil sections

Description: From Introduction: "The present paper presents the scale effect on the longitudinal aerodynamic characteristics, the aerodynamic characteristics in yaw, and the tuft studies for 0^o and 3.7^o yaw. The results of the effect of leading-edge and trailing-edge flaps on the aerodynamic characteristics of the wing will be presented in later reports."
Date: August 4, 1947
Creator: Proterra, Anthony J
Partner: UNT Libraries Government Documents Department

Aerodynamic characteristics of a flying-boat hull having a length-beam ratio of 15 and a warped forebody

Description: From Introduction: "The results of two phases of this investigation, presented in references 1 and 2, have indicated possible ways of reducing hull drag without causing large changes in aerodynamic stability and hydrodynamic performance."
Date: February 11, 1949
Creator: Macleod, Richard G
Partner: UNT Libraries Government Documents Department

Aerodynamic Characteristics of a Number of Modified NACA Four-Digit-Series Airfoil Sections

Description: Theoretical pressure distributions and measured lift, drag, and pitching moment characteristics at three values of Reynolds number are presented for a group of NACA four-digit-series airfoil sections modified for high-speed applications. The effectiveness of flaps applied to these airfoils and the effect of standard leading-edge roughness were also investigated at one value of Reynolds number. Results are also presented of tests of three conventional NACA four-digit-series airfoil sections.
Date: November 14, 1947
Creator: Loftin, Laurence K., Jr. & Cohen, Kenneth G.
Partner: UNT Libraries Government Documents Department

Aerodynamic Characteristics of a Portion of the Horizontal Tail from a Douglas C-74 Airplane with Fabric-Covered Elevators

Description: A Douglas C-74 airplane, during a test dive at about 0.525 Mach number, experienced uncontrollable longitudinal oscillations sufficient to cause shedding of the outer wing panels and the subsequent crash of the airplane. Tests of a section of the horizontal tail plane from a C-74 airplane were conducted in the Ames 16-foot high-speed wind tunnel to investigate the possibility of the tail as a contributing factor to the accident. The results of the investigations of fabric-covered elevators in various conditions of surface deformation are presented in this report.
Date: May 6, 1947
Creator: Perone, Angelo & Berthold, Cecil L.
Partner: UNT Libraries Government Documents Department

Aerodynamic characteristics of a slot-lip aileron and slotted flap for dive brakes

Description: From Introduction: "As a part of this investigation, a study is being made of test results obtained during the development of devices designed primarily for other purposes, such as high lift or lateral control, but which may also be used for dive control. These results have been reanalyzed and are herein presented in a form that should make them convenient for design purposes."
Date: April 1941
Creator: Rogallo, F M
Partner: UNT Libraries Government Documents Department