National Advisory Committee for Aeronautics (NACA) - 742 Matching Results

Search Results

Results: 1 - 24 next
open access

Accuracy of Airspeed Measurements and Flight Calibration Procedures

Description: From Summary: "The sources of error that may enter into the measurement of airspeed by pitot-static methods are reviewed in detail together with methods of flight calibration of airspeed installations. Special attention is given to the problem of accurate measurements of airspeed under conditions of high speed and maneuverability required of military airplanes." (author).
Date: 1948
Creator: Huston, Wilber B.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional Abstracts Pertaining to Seaplanes

Description: "About 500 additional references pertaining to hydrodynamic design of seaplanes have been compiled, and the information is presented in the form of abstracts classified under six main headings:GENERAL INFORMATION, HYDROSTATICS, HYDRODYNAMICS, AERODYNAMICS, OPERATION, and RESEARCH. The compilation is an extension of NACA RM No. L6I13, entitled "Abstracts Pertaining to Seaplanes," by Jerold M. Bidwell and Douglas A. King. An author index and a subject index are included" (p. 1).
Date: March 9, 1948
Creator: Bidwell, Jerold M. & King, Douglas A.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional free-flight tests of the rolling effectiveness of several wing-spoiler arrangements at high subsonic, transonic, and supersonic speeds

Description: From Introduction: "The purpose of the present paper is to present results obtained recently relating to the characteristics of a full-span sharp-edge spoiler with an 0.02-chord projection above the wing surface at several chordwise positions and also to the relative effectiveness of the sharp-edge spoiler and a wedge-type spoiler located at the 80-percent-chord line."
Date: November 24, 1948
Creator: Strass, H. Kurt
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Additional Results in a Free-Flight Investigation of Control Effectiveness of Full-Span, 0.2-Chord Plain Ailerons at High Subsonic, Transonic, and Supersonic Speeds to Determine Some Effects of Wing Sweepback, Aspect Ratio, Taper, and Section Thickness Ratio

Description: Report discussing an aerodynamic control effectiveness study using free-flight, rocket-propelled test vehicles. Information about the effects of wing sweepback, aspect ratio, taper ratio, and section thickness ratio on the rolling effectiveness of full-span, sealed ailerons is provided.
Date: April 23, 1948
Creator: Sandahl, Carl A. & Strass, H. Kurt
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at high speeds of a two-blade NACA 10-(3)(062)-045 propeller and of a two-blade NACA 10-(3)(08)-045 propeller

Description: From Introduction: "The aerodynamic characteristics of a series of 10-foot-diameter propellers are being investigated in the Langley 16-foot high-speed tunnel in a comprehensive propeller research program. Using high-critical-speed NACA 16-series airfoil sections (reference 1), these propellers are designed to have Betz minimum induced-energy loss loading (reference 2) for a blade angle of 45^o at the 0.7 radius, when used as a four-blade propeller operating at an advance ratio of approximately… more
Date: October 1, 1948
Creator: Solomon, William
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at high speeds of full-scale propellers having Clark Y blade sections

Description: From Introduction: "The single purpose of this paper is to make available the data obtained from tests of these two Clark Y section propellers as quickly as possible with no attempt being made to analyze the results or to compare them with other high-speed-propeller test results."
Date: October 26, 1948
Creator: Johnson, Peter J.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at high speeds of related full-scale propellers having different blade-section cambers

Description: From Summary: "Wind-tunnel tests of a full-scale two-blade NACA 10-(10)(08)-03 (high camber) propeller have been made for a range of blade angles from 20 degrees to 55 degrees at airspeeds up to 500 miles per hour. The results of these tests have been compared with results from previous tests of the NACA 10-(3) (08)-03 (low camber) and NACA 10-(5)(08)-03 (medium camber) propellers to evaluate the effects of blade-section camber on propeller aerodynamic characteristics."
Date: May 6, 1948
Creator: Maynard, Julian D. & Salters, Leland B., Jr.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at subsonic and supersonic Mach numbers of a thin triangular wing of aspect ratio 2 1: maximum thickness at 20 percent of the chord

Description: From Summary: "This report presents the results of a wind-tunnel investigation conducted to determine the effects of Mach number on the aerodynamic characteristics of a wing of triangular plan form."
Date: November 19, 1948
Creator: Berggren, Robert E. & Summers, James L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic characteristics at subsonic and supersonic Mach numbers of a thin triangular wing of aspect ratio 2 2: maximum thickness at midchord

Description: "The lift, drag, and pitching-moment characteristics of a triangular wing, having an aspect ratio of 2 and a symmetrical double-wedge profile of 5-percent-chord maximum thickness at midchord, have been evaluated from wind-tunnel tests at Mach numbers from 0.50 to 0.975 and from 1.09 to 1.49 and at Reynolds numbers ranging from 0.67 to 0.85 million. The lift, drag, and pitching-moment coefficients of the triangular wing with a leading-edge sweepback of approximately 63 degrees did not exhibit th… more
Date: December 3, 1948
Creator: Walker, Harold J. & Berggren, Robert E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of a Number of Modified NACA Four-Digit-Series Airfoil Sections

Description: Report presenting theoretical pressure distributions and experimental aerodynamic characteristics at low speeds for a group of NACA four-digit series airfoil sections. Results regarding lift, drag, and pitching moment are provided.
Date: June 1948
Creator: Loftin, Laurence K., Jr. & Cohen, Kenneth S.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Flying-Boat Hulls Having Length-Beam Ratios of 20 and 30

Description: Report discussing the aerodynamic effects of length-beam ratios 20 and 30 as compared to length-beam ratios from 6 to 15. There was slightly more longitudinal stability and slightly less directional stability than in the lower ratios and not much change in the minimum drag coefficient.
Date: November 10, 1948
Creator: Riebe, John M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Several NACA Airfoil Sections at Seven Reynolds Numbers From 0.7 X 10(Exp 6) to 9.0 X 10(Exp 6)

Description: Report presenting an investigation of the two-dimensional aerodynamic characteristics of several NACA airfoil sections at four Reynolds numbers. Results regarding the minimum drag, maximum lift, lift-curve slope, and angle of zero lift and pitching moment are provided.
Date: May 27, 1948
Creator: Loftin, Laurence K., Jr. & Poteat, M. Irene
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of Two All-Movable Wings Tested in the Presence of a Fuselage at a Mach Number of 1.9

Description: Report presenting testing of half-span models of two wings of different plan form as both all-movable and fixed surfaces in the presence of a half fuselage. All-movable surfaces are being considered for supersonic aircraft as possible angle-of-attack indicators, control surfaces, and all-movable wings. Results regarding the lift characteristics, center of pressure, and drag of the wings are provided.
Date: October 28, 1948
Creator: Conner, D. William
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Properties of Slender Wing-Body Combinations at Subsonic, Transonic, and Supersonic Speeds

Description: From Introduction: "In an incomprehensible medium, the mutual interference of a fuselage and wing of high-aspect ratio (to which lifting-line theory is applicable) has been treated by Lennertz, Wiselsberger, Pepper, and Multhopp in reference 1, 2, 3, and 4. It is the purpose of this note to treat the effect of on the aerodynamic loading of the mutual interference between a low-aspect-ratio pointed wing and a fuselage consisting of a slender body of revolution."
Date: July 1948
Creator: Spreiter, John R.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic study of a wing-fuselage combination employing a wing swept back 63 degrees: Subsonic Mach and Reynolds number effects on the characteristics of the wing and on the effectiveness of an elevon

Description: Report presenting a wind-tunnel investigation of a semispan model of a wing swept back 63 degrees with an aspect ratio of 3.5 and a taper ratio of 0.25. The tests were conducted to evaluate the effects of Reynolds and Mach number on the aerodynamic characteristics of the wing. Results regarding the characteristics of the wing with the elevon undeflected, effectiveness of the elevon, effects of roughness strips, and effect of model deflection under varying loads are provided.
Date: October 11, 1948
Creator: Reynolds, Robert M. & Smith, Donald W.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aerodynamics characteristics of 24 NACA 16-series airfoils at Mach numbers between 0.3 and 0.8

Description: Report presenting an investigation to determine the aerodynamic characteristics of a group of NACA 16-series airfoils related in camber and thickness over a range of Mach numbers. All of the currently available force-test data for NACA 16-series airfoils obtained under the same test conditions in the 24-inch high-speed tunnel are presented.
Date: September 1948
Creator: Lindsey, W. F.; Stevenson, D. B. & Daley, Bernard N.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Aeronautical Characteristics of a Three-Blade Propeller Having NACA 10-(3)(08)-03 Blades

Description: "Data obtained in tests of a 10-foot diameter, three-blade propeller, having NACA 10-(3)(08)-03 blades, conducted in the Langley 16-foot high-speed tunnel are presented. The propeller performance quantities related by the tests are thrust, torque, efficiency, and advance ratio for various rotational speeds or stream Mach numbers with blade angle as a parameter. Advance Mach numbers varied from 0.12 to 0.64" (p. 1).
Date: October 29, 1948
Creator: Davidson, Robert E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Altitude-Test-Chamber Investigation of a Solar Afterburner on the 24C Engine 1 - Operational Characteristics and Altitude Limits

Description: "An altitude-test-chamber investigation was conducted to determine the operational characteristics and altitude blow-out limits of a Solar afterburner in a 24C engine. At rated engine speed and maximum permissible turbine-discharge temperature, the altitude limit as determined by combustion blow-out occurred as a band of unstable operation of about 8000 feet altitude in width with maximum altitude limits from 32,000 feet at a Mach number of 0.3 to about 42,000 feet at a Mach number of 1.0. The … more
Date: July 6, 1948
Creator: Dowman, Harry W. & Reller, John O.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Altitude-Wind-Tunnel Investigation of a 3000-Pound-Thrust Axial-Flow Turbojet Engine 1 - Analysis of Turbine Performance

Description: A wind tunnel investigation was conducted to determine the performance of a turbine operating as an integral part of a turbojet engine. Data was obtained while the engine was running over full operable range of speeds at various altitudes and flight mach numbers, and with four nozzles of different outlet areas.A maximum turbine efficiency of 0.875 was obtained at altitude of 15 thousand feet, Mach number 0.53, and corrected turbine speed of 5900 rpm.
Date: August 23, 1948
Creator: Conrad, Earl W.; Dietz, Robert O., Jr. & Golladay, Richard L.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Altitude-Wind-Tunnel Investigation of a 3000-Pound-Thrust Axial-Flow Turbojet Engine 2 - Analysis of Compressor Performance

Description: Compressor performance properties for two 11-stage compressors of 3000-pound-thrust axial-flow turbojet engines were determined. Data are presented for a range of simulated altitudes and a range of Mach numbers for various modifications of the engine.
Date: August 23, 1948
Creator: Dietz, Robert O., Jr.; Berdysz, Joseph J. & Howard, Ephraim M.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
open access

Altitude-Wind-Tunnel Investigation of a 3000-Pound-Thrust Axial-Flow Turbojet Engine 3 - Analysis of Combustion-Chamber Performance

Description: Combustion chamber performance properties of a 3000-pound-thrust axial-flow turbojet engine were determined. Data are presented for a range of simulated altitudes from 15,000 to 45,0000 feet and a range of Mach numbers from 0.23 to 1.05 for various modifications of the engine.
Date: August 23, 1948
Creator: Campbell, Carl E.
Item Type: Refine your search to only Report
Partner: UNT Libraries Government Documents Department
Back to Top of Screen