Search Results

open access

Aerodynamic characteristics at subsonic and transonic speeds of a 42.7 degree sweptback wing model having an aileron with finite trailing-edge thickness

Description: Report presenting an investigation at subsonic and transonic speeds in the high-speed 7- by 10-foot tunnel to determine the aerodynamic characteristics of a 42.7 degree sweptback wing with a 20-percent-chord and 50-percent-span outboard aileron. The investigation was performed in transonic flow over a bump on the tunnel floor and in subsonic flow on one of the tunnel side walls.
Date: January 12, 1949
Creator: Turner, Thomas R.; Lockwood, Vernard E. & Vogler, Raymond D.
Partner: UNT Libraries Government Documents Department
open access

Aerodynamic Characteristics of a 1/8-Scale Powered Model of a High-Speed Bomber With a Dual Pusher Propeller Aft of the Empennage

Description: Report presenting wind-tunnel tests made to determine the aerodynamic characteristics of a scale model of a high-speed bomber with a dual pusher propeller aft of the empennage. Some of the results discussed include longitudinal, lateral, and directional stability and control, the empennage design, and ground effects on the aerodynamic characteristics. The results indicate that this particular airplane has several advantages with regard to stability and control over the conventional-type single-… more
Date: October 12, 1945
Creator: Weiberg, James A. & Schnurbusch, Alfred W.
Partner: UNT Libraries Government Documents Department
open access

Analytical and Experimental Investigation of 90 Degrees Supersonic Turning Passages Suitable for Supersonic Compressors or Turbines

Description: "Four 90 degree two-dimensional turning passages designed by the method of characteristics were tested at an inlet Mach number of 1.71. The measured losses varied from 5 to 15 percent of the inlet stagnation pressure. The smallest loss was obtained for a passage in which separation on the convex surface was minimized through the introduction of a favorable pressure gradient" (p. 1).
Date: September 12, 1949
Creator: Liccini, Luke L.
Partner: UNT Libraries Government Documents Department
open access

Analytical investigation of distribution of centrifugal stresses and their relation to limiting operating temperatures in gas-turbine blades

Description: From Introduction: "Analyses that provide a basis for comparing the centrifugal-stress distributions inherent in jet-engine turbine blades of several designs currently in use were therefore made and are presented."
Date: April 12, 1948
Creator: Kemp, Richard H. & Morgan, William C.
Partner: UNT Libraries Government Documents Department
open access

Appreciation and Prediction of Flying Qualities

Description: "The material given in this report summarizes some of the results of recent research that will aid the designers of an airplane in selecting or modifying a configuration to provide satisfactory stability and control characteristics. The requirements of the NACA for satisfactory flying qualities, which specify the important stability and control characteristics of an airplane from the pilot's standpoint, are used as the main topics of the report. A discussion is given of the reasons for the requ… more
Date: April 12, 1948
Creator: Phillips, William H.
Partner: UNT Libraries Government Documents Department
open access

Calculations of the Dynamic Stress of Several Airplane Wings in Various Gusts

Description: "A series of calculations of the dynamic response of airplane wings to gusts were made with the purpose of showing the relative response of a reference airplane, the DC-3 airplane, and of newer types of airplanes represented by the DC-4, DC-6, and L-49 airplanes. Additional calculations were made for the DC-6 airplane to show the effects of speed and altitude. On the basis of the method of calculation used and the conditions selected for analysis, it is indicated that: 1) The newer airplanes sh… more
Date: July 12, 1948
Creator: Pierce, Harold B.
Partner: UNT Libraries Government Documents Department
open access

Comparative Tests of the Rolling Effectiveness of Constant-Chord, Full-Delta, and Half-Delta Ailerons on Delta Wings at Transonic and Supersonic Speeds

Description: Report presenting comparative tests of the rolling power of plain constant-chord, full-delta, and half-delta ailerons on delta wings with varying degrees of sweepback were tested on rocket-propelled test vehicles. Results regarding the effect of leading-edge sweepback, a comparison of rolling effectiveness, and comparison with theory are provided.
Date: December 12, 1949
Creator: Sandahl, Carl A. & Strass, H. Kurt
Partner: UNT Libraries Government Documents Department
open access

A comparison of the experimental subsonic pressure distributions about several bodies of revolution with pressure distributions computed by means of the linearized theory

Description: Report presenting an analysis of the effects of compressibility on the pressure coefficients of several bodies of revolution by comparing experimentally determined pressure coefficients with corresponding pressure coefficients calculated by the use of linearized equations of compressible flow. The results indicated that the theoretical methods predict the subsonic pressure-coefficient changes over the central portion of the body but do not predict the pressure-coefficient changes near the nose.
Date: September 12, 1949
Creator: Matthews, Clarence W.
Partner: UNT Libraries Government Documents Department
open access

Correlation of the Characteristics of Single-Cylinder and Flight Engines in Tests of High-Performance Fuels in an Air-Cooled Engine 2 - Knock-Limited Charge-Air Flow and Cylinder Temperatures

Description: An investigation was conducted to correlate the knock limited performance of flight and single-cylinder engines under a variety of operating conditions.
Date: October 12, 1945
Creator: Brown, Kenneth D.; Richard, Paul H. & Wilson, Robert W.
Partner: UNT Libraries Government Documents Department
open access

Cyclic Engine Test of Cast Vitallium Turbine Buckets 2

Description: Memorandum presenting an investigation conducted to provide data that may be used to correlate the engine service performance of cast Vitallium turbine buckets with metallurgical properties. Data were obtained from four turbine wheels of Timken alloy with cast Vitallium buckets. Examination of 12 broken buckets indicated that 8 of the failures were probably caused by fatigue and 4 by impact with pieces of other broken buckets.
Date: January 12, 1948
Creator: Farmer, J. Elmo; Deutsch, George C. & Sikora, Paul F.
Partner: UNT Libraries Government Documents Department
open access

Damping in pitch and roll of triangular wings at supersonic speeds

Description: A method is derived for calculating the damping coefficients in pitch and roll for a series of triangular wings and a restricted series of sweptback wings at supersonic speeds. The elementary "supersonic source" solution of the linearized equation of motion is used to find the potential function of a line of doublets, and the flows are obtained by surface distributions of these doublet lines. The damping derivatives for triangular wings are found to be a function of the ratio of the tangent of … more
Date: December 12, 1947
Creator: Brown, Clinton E. & Adams, Mac C.
Partner: UNT Libraries Government Documents Department
open access

Design and Performance of Experimental Axial-Discharge Mixed-Flow Compressor 1: Impeller Design Theory

Description: Memorandum presenting a description of an axial-discharge mixed-flow compressor, which is especially adapted for jet engines because of the large mass flow per unit frontal area. The best impeller was selected on the basis of the maximum air-flow capacity, which was 19.6 pounds per second for a 14-inch-diameter impeller with a tip speed of 1480 feet per second and a pressure ratio of 3.5.
Date: August 12, 1948
Creator: Goldstein, Arthur W.
Partner: UNT Libraries Government Documents Department
open access

Design and performance of experimental axial-discharge mixed-flow compressor 2: performance of impeller

Description: Report presenting an analysis of an axial-discharge mixed-flow compressor designed to combine the compactness, reliability, and wide operating range of a mixed-flow compressor with the high flow capacity per unit of frontal area that characterizes the axial-flow compressor. The primary objective of this design was to maximize the flow capacity for a predetermined pressure ratio. Results regarding the flow distribution at the impeller inlet, flow distribution at the impeller outlet, and impeller… more
Date: August 12, 1948
Creator: Wilcox, Ward W.
Partner: UNT Libraries Government Documents Department
open access

Dislocation Theory of the Fatigue of Metals

Description: "A dislocation theory of fatigue failure for annealed solid solutions is presented. On the basis of this theory, an equation giving the dependence of the number of cycles for failure on the stress, the temperature, the material parameters, and the frequency is derived for uniformly stressed specimens. The equation is in quantitative agreement with the data" (p. 183).
Date: September 12, 1947
Creator: Machlin, E. S.
Partner: UNT Libraries Government Documents Department
open access

Effect of hinge-moment parameters on elevator stick forces in rapid maneuvers

Description: "The importance of the stick force per unit normal acceleration as a criterion of longitudinal stability and the critical dependence of this gradient on elevator hinge-moment parameters have been shown in previous reports. The present report continues the investigation with special reference to transient effects for maneuvers of short duration" (p. 449).
Date: October 12, 1944
Creator: Jones, Robert T. & Greenberg, Harry
Partner: UNT Libraries Government Documents Department
open access

The Effect of Six Aromatic Amines on the Preignition-Limited Performance of 28-R Aviation Fuel in a CFR Engine

Description: Report discussing the results of testing on the suitability of six aromatic amines as fuel additives. Antiknock effectiveness, availability, physical properties, and chemical properties for knock tests were explored. The six aromatic amines were xylidines, cumidines, N-methylxylidines, N-methylcumidines, N-methylaniline, and N-methyltoluidine in 28-R aviation fuel.
Date: May 12, 1945
Creator: Male, Donald W.
Partner: UNT Libraries Government Documents Department
open access

Effect of Water-Alcohol Injection and Maximum Economy Spark Advance on Knock-Limited Performance and Fuel Economy of a Large Air-Cooled Cylinder

Description: An investigation was conducted to determine the effect of a coolant solution of 25 percent ethyl alcohol, 25 percent methyl alcohol, and 50 percent water by volume and maximum-economy spark advance on knock-limited performance and fuel economy of a large air-cooled cylinder. The knock-limited performance of the cylinder at engine speeds of 2100 and 2500 rpm was determined for coolant-fuel ratios of 0.0, 0.2, and 0.4. The effect of water-alcohol injection on fuel economy was determined in consta… more
Date: August 12, 1945
Creator: Heinicke, Orville H. & Vandeman, Jack E.
Partner: UNT Libraries Government Documents Department
open access

Evaluation of Gust and Draft Velocities from Flights of P-61C Airplanes within Thunderstorms September 11, 1946 to September 16, 1946 at Orlando, Florida

Description: "The results obtained from measurements of gust velocities, draft velocities, and ambient-air temperature within thunderstorms for the period from September 11, 1946 to September 16, 1946 at Orlando, Florida are presented herein. These data are summarized in.and presented" (p. 1).
Date: March 12, 1947
Creator: Tolefson, H. B.
Partner: UNT Libraries Government Documents Department
open access

Experimental determination of the lateral stability of a glider towed by a single towline and correlation with an approximate theory

Description: Report presenting an investigation to determine the effects of various design parameters on the lateral-stability characteristics of a glider towed by a single towline. The investigation showed that it is possible to obtain inherent lateral stability with a single towline system.
Date: November 12, 1948
Creator: Maggin, Bernard & Shanks, Robert E.
Partner: UNT Libraries Government Documents Department
open access

Experimental investigation at supersonic speeds of side scoops employing boundary-layer suction

Description: Report presenting the pressure-recovery characteristics of a model with two scoops situated on the aft position of a long forebody and connected through diffusors to a common settling chamber at a range of Mach numbers. The effects of interaction between the flow in the two air-induction systems and of varying the mass flow through the boundary-layer scoops were studied. Results at several different angles of attack are provided.
Date: December 12, 1949
Creator: Edwards, Sherman S.
Partner: UNT Libraries Government Documents Department
open access

Flight Investigation to Determine the Hinge Moments of a Beveled-Edge Aileron on a 45 Degree Sweptback Wing at Transonic and Low Supersonic Speeds

Description: Report discussing testing of a model of the pilotless aircraft RM-1 to measure aileron hinge moments in flight in order to determine the reason for loss of roll stabilization at supercritical speeds in flight. The aileron was found to become quickly underbalanced over the full deflection range at supercritical speeds. Information about the general flight behavior, aileron hinge moments, and roll stabilization of the model is provided.
Date: November 12, 1947
Creator: Gardner, William N. & Curfman, Howard J., Jr.
Partner: UNT Libraries Government Documents Department
open access

Full-Scale Investigation of the Maximum Lift and Flow Characteristics of an Airplane Having Approximately Triangular Plan Form

Description: Report discussing an investigation of the DM-1 glider, which has an approximately triangular plan form, with auxiliary studies of a model of triangular wings. The pitching-moment coefficient, drag coefficient, and angle of attack with the lift coefficient are provided. Results indicated that the angles of descent without power are likely to be prohibitive and airplanes with the tested type of wings will not be able to land safely without power.
Date: February 12, 1947
Creator: Wilson, Herbert A., Jr. & Lovell, J. Calvin
Partner: UNT Libraries Government Documents Department
Back to Top of Screen